查询词典 speak volume for

In this research, large volume stainless pots, high－quality pottery pots and enamel pots, instead of traditional small volume pottery pots, were used in storing several kinds of fresh liquor like "Shuanggou Liquor" etc.and the analysis of stored liquor by gas chromatography and atomic absorption spectrum indicated that the application of large volume stainless containers, instead of the traditional pottery pots, could not only advance liquor aging , produce flavour and remove precipitate, develop soft liquor style, stabilize and improve liquor quality,harmonize the balance of components , decrease liquor loss and liquor storage space,but also promote oxidation , reduction, esterification and molecular hydrogen bond association in the process of liquor storage.

对&双沟酒&等各香型酒，利用大容器的不锈钢罐、优质陶缸和搪瓷罐代替传统小容积陶坛或陶缸贮存新酒作了试验研究。采用气相色谱和原子吸收光谱对贮酒分析，得出采用不锈钢等大容器代替传统小陶罐贮存酒，不但可使酒在贮存过程中进行氧化、还原、酯化和分子氢键缔合作用，促进酒体老熟去杂增香，使酒体柔和老熟、成分平衡协调，稳定和提高酒质；而且还可以降低酒的损耗和减少贮酒库占地面积。孙悟

Engine cylinder liner of the general process of measurement are: cylinder liner according to the nominal size measuring selection, that is, sub-thousand-foot-cylinder form and quantity (including the volume of cylinder rod inserted table); installation and adjustment of measuring, that is first to adjust micrometer cylinder liner the nominal size, and then loaded card good indicator of the volume of cylinder form measuring bar and the bar card inserted in the anvil micrometer measuring bar between the seat and adjust the volume of cylinder form of extended length of rod inserted, when the dial indicator of the 1.5-2.0 cells have small hands around the amount of pre-press under lock-lock female plug, and a large dial indicator to zero adjust

发动机气缸套测量的一般过程是：根据气缸套的公称尺寸选择量具，即千分尺和量缸表；安装和调整量具，即先将千分尺调整到气缸套的公称尺寸，再将卡装好百分表的量缸表的测杆和插杆卡在千分尺的砧座和测杆之间，调整量缸表插杆的伸出长度，当百分表的小表针有1.5-2.0格左右的预压量时锁紧插杆锁母，并将百分表的大表盘调整到零

The first direct measurement with micrometer piston skirt and the outside diameter Do micrometer stop screw to the locking plate position, and then dial indicator card installed and well well inserted under the initial installation of the amount of cards, directly into the cylinder corresponding cylinder kit, adjust the volume of the cylinder rod out in table inserted length, so that small hands dial indicator cell has about 1 volume of pre-press and lock locking rod inserted mother, at the same time, large dial indicator dial to adjust zero, the last cylinder to adjust the volume of good form under test card inserted rods and do at Anvil micrometer and measured the rod between the big hands dial indicator at this time than the "zero" high value is the piston and cylinder liner with the space.

3先直接用千分尺测量活塞裙部的外径并将干分尺止动螺钉扳转到锁紧位置，再将卡装好百分表和初步安装好插杆的量缸表直接卡入对应气缸套内，调整量缸表插杆的伸出长度，使百分表的小表针有1格左右的预压量并锁紧插杆锁母，同时将百分表的大表盘调整到零，最后将调整好的量缸表的测杆和插杆卡在干分尺的砧座和测杆之间，此时百分表大表针比&零&高的数值即为活塞和气缸套的配合间隙。

The first direct measurement with micrometer diameter piston skirt, and then dial indicator card installed and the initial installation of the amount of good cylinder rod inserted card table micrometer mounted on the anvil between the seat and the measuring bar, adjust the volume of cylinder table Interpolation of the extended length of rod, when the dial indicator has small hands around 1.5-2 cell volume preloading lock locking rod inserted mother, and a large dial indicator to zero adjust the final stretch to the volume of cylinder table into the Cylinder Sleeve, large dial indicator hands than "zero" low value (considering the small hands reading) is the piston and cylinder liner with the space.

2先直接用千分尺测量活塞裙部的外径，然后将卡装好百分表和初步安装好插杆的量缸表卡装在千分尺的砧座和测杆之间，调整量缸表插杆的伸出长度，当百分表的小表针有1.5-2格左右的预压量时锁紧插杆锁母，并将百分表的大表盘调整到零，最后将量缸表伸入气缸套内，百分表大表针比&零&低的数值即为活塞和气缸套的配合间隙。

Path analysis of nine traits, which were highly correlated with tree volume, showed that the direct contribution of DBH and height on the variations of tree volume took up about 63% of the total variations. On the other hand, those traits, such as tree crown and wall/lumina, affected the volume strongly by indirect way of the genetic correlation with DBH and height.

通过对与材积性状紧密相关的胸径等9个性状的通径分析发现，胸径和树高两个性状对单木材积的直接作用占材积总变异的63％，其余性状的直接控制作用很小；冠幅、壁腔比等性状通过胸径对单木材积具有很大的间接遗传控制作用，这种控制是通过与胸径、树高的遗传相关实现的。

Weigh's addition minishes the loss of net's volume in pure current, but makes no differnce in the pure wave condition. After installed of sinking ring or lower ring, the loss of net's volume is decreased. The loss of net volume is more in the current combined with wave condition than in the pure current condition.

在纯流条件下，增大配重均有利于减小网箱的体积损失；而在纯波条件下，配重的增加对于改善网衣的变形没有实质性的意义；设置了底圈或沉降圈后，均能在一定程度上减小网衣的体积损失；波流组合条件下网衣的体积损失要明显大于纯流条件下的体积损失。

The different points of views, transverse section, plane and volume changes are considered. The results show that the evolution of the Xinqiao Channel has experienced three stages: in 1861~1926 ,the Xinqiao Channel area had been eroded at first and then silted; the Xinqiao Channel is formed during 1926~1958 with the channel experiencing persistence erosion; from 1958 to 2002, the total volume of the Xinqiao Channel keeps stable with the volume of 5.02×108m^3. The pattern of 10m contour has shaped to a certainty in 1926 and 5m contour of the upper and lower parts of Biandansha has been joined. The change of sections of the Xinqiao Channel reflects its thalweg movement to the North Bank 1.1~2.8 km, its shape changes from "U" shape to "V" shape and its depth has been deepened.

计算结果显示在所研究的区域内自1861年以来新桥水道冲淤过程明显被分为三个阶段：1861~1926年的66a间新桥水道区域经过一段时间的冲刷后又重新产生淤积，总容积变化不大；1926~1958年的33a间新桥水道在不断的冲刷中总容积由2.603亿立方公尺增长到5.076亿立方公尺；1958年至今的45a时间里水道容积基本保持在平均5.02亿立方公尺。1926年新桥水道10m等深线已经形成一定的格局，1947年5m等深线向上延伸，扁担沙已经不再与崇明岛相连；1958年上下扁担沙的5m等深线基本连成一体，可以认为此时新桥水道已经形成。

Bellows Gate Valves However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。

However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。因此热力膨胀阀在变工况下供液量的调节方面需进一步改进。

Summary: Regard guava as raw materials, adopt the organic solvent to extract the law, pass the single factor experiment and orthogonal experiment, to influence many phenol draw abstraction pharmaceutical kind of quantity, draw pharmaceutical volume mark, draw time, draw temperature factor go on the discussion compared with material liquid,etc., the ones that confirm much phenol of guava draw the craft parameter bestly: Volume mark 70% ethanol according to material 1:10 volume ratio of liquid, 70 ℃lay reflux draw 40min in temperature, many abstraction amount of phenol can reach 62.35mg/g be thing.

问题补充：不好意思，我修改了一下摘要，正文应该是：以番石榴为原料，采用有机溶剂萃取法，通过单因素实验和正交实验，对影响多酚提取量的提取剂种类、提取剂体积分数、提取时间、提取温度和料液比等因素进行探讨，确定番石榴多酚的最佳提取工艺参数为：体积分数为70%的乙醇按1∶10的料液比，在温度70℃下回流提取40min，多酚的提取量可达到62.35mg/g干物。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"