查询词典 spacing

The effects of idler spacing selection on belt conveyor power consumption were discussed.

讨论了带式输送机托辊间距的选择对功率消耗的影响。

An analytical model was built up on the jet deflection in the crossflow by applying the theorem of momentum, which takes full account of mixing between the upstream fluid and burner jet, and of the total pressure difference between the two sides of the jets. Through analysis of this model, experimental study and numerical simulation, effects of the nozzle spacing ratio, width of the furnace corner, width of the nozzle and imaginary circle diameter on the aerodynamic field in the furnace were obtained.

本文综合考虑了炉内旋转气流与燃烧器射流的混合和燃烧器射流向火侧与背火侧的全压差等因素，应用动量定理建立了横向气流中射流偏转的分析模型，并结合冷态模化试验和数值模拟计算，得到了燃烧器间隙率、炉膛切角、喷口宽度和假想切圆直径等因素对炉内空气动力场影响的规律。

Pitch: The horizontal spacing of typewriter or impact printer characters.

字阔度：打字机或撞压式印字机的字符阔度。

And the results indicate: the ratio of fin spacing to fin height exerts influence on total resistance of heat sinks in significant measure, there are figures at the end of this paper, that plot heat transfer coefficients and resistances when fin dimensions amount to different values.

计算结果表明：肋片间距与高度的比值对散热器热阻的影响较大，在图中绘制出了不同肋片尺寸对应的散热器对流换热系数和热阻。

Then set the Indent, which is the spacing between the bullet or number and the text.

然后设置缩进，这是项目符号或编号和文字的间距。

Current drilling is focused on infilling these areas to reserve spacing in support of feasibility studies.

目前的钻探着重点是在这些地区加密钻探，已达到储量钻距的要求为可行性报告提供充分的数据。

Basing on this, we have summarized the injection adjusting techniques of different stages and responding characteristics of different well spacing after infilling. We also have carried out comprehensive evaluation and economic benefit of the development result after infilling.

在此基础上，总结了加密后不同阶段注水调整技术及不同井距受效特点，对井网加密后的开发效果及取得的经济效益进行了综合评价。

The glass insulator spacing is a very important parameter.

玻璃绝缘子产品的结构高度尺寸，是一个非常重要的参数。

After annealing at 150℃,the moleculesorientate to ordered columnar structure with a intercolumnar spacing of 17.4〓The ringplane of TNPPcZn is orientated nearly perpendicular to the substrate.

采用红外掠射光谱、X射线衍射等方法研究了沉积在基片上的TNPPcZn旋涂膜的结构特征，首次发现原本呈无序排列的酞菁分子，于150℃退火后，分子发生了共面聚集并以接近垂直的角度直立在基片表面上，X射线衍射实验进一步证实了薄膜结构的有序性，并测定出了17.4〓的晶面间距。

The 90 and 180 phase shift bits are of reflection type, using Lange coupler to realize the separation between the incident and reflection signals. According to process rules of the GaAs MMIC product line, we properly designed the circuit layout. In order to reduce the overall chip size, the transmission lines are folded with sufficient spacing to avoid interline coupling.

结合实际MMIC工艺线，合理设计移相器电路版图，折叠微带线并留出足够大的线间距，以避免线间寄生耦合的发生，并折叠兰格耦合器使90°和180°移相位的尺寸与其它相位的芯片尺寸保持一致。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。