查询词典 solution pressure

Moreover, the hot compressive deformation behavior of the RS/PM AZ91 magnesium alloy and AZ91 alloy matrix composite were also investigated, the conclusions are drawn as follows:1. The processing parameters of the atomization-twin rolls quenching technology were optimized as follows: the diameter of the nozzle 1mm, the wheel velocity 25m/s, the pressure of atomization gas 0.3MPa and Ar gas for melt injection 0.1MPa. The RS AZ91 alloy flakes exhibited fine and uniform microstructures. When the flakes were extruded at 673K, extruded velocity of 0.1mm/min and extrusion ratio of 25:1,the magnesium alloy rods with clean surface, uniform dimension and excellent mechanical properties were obtained.2. The RS AZ91 magnesium alloy powders prepared by atomization-twin rolls quenched technology exhibited fine equiaxed grains with the grain size of 1-3μm, the phase constituent included supersaturate solid solution phaseα-Mg and miner fineβ-Mg_(17)Al_(12) phase. The as-extruded materials also exhibited equiaxed grains with the size of 5-7μm and a large number of fineβ-Al_(12)Mg_(17) and fewer AlMg_2Zn phases were detected in the alloy.

本文还研究了快速凝固/粉末冶金AZ91镁合金热压缩变形流变应力行为，快速凝固/粉末冶金法原位生成Mg_2Si增强AZ91镁基复合材料，经过系统的研究，获得如下结论：1、雾化-双辊急冷法在下列工艺参数组合下：双辊线速度25m/s；喷嘴直径1mm；熔体压射压力0.1MPa；雾化气体压力0.3MPa。，可获得宏观尺寸细小、微观组织均匀细小、综合性能优良的的快速凝固AZ91镁合金细碎箔带，快速凝固箔带在挤压温度为673K、挤压速度为0.1mm/min，挤压比为25：1时，可获得的外表光洁、尺寸均匀、组织性能优异的镁合金棒材。2、雾化-双辊急冷法制备的AZ91镁合金粉末态为细小等轴晶组织，晶粒尺寸1-3μm，组织为α-Mg过饱和固溶体和微量的细小β-Mg_(17)Al_(12)相组成；粉末挤压棒材为等轴晶组织，晶粒尺寸5-7μm，组织中含有大量细小的β-Al_(12)Mg_(17)以及AlMg_2Zn析出相，室温力学性能，抗拉强度383MPa，屈服强度275MPa，断后伸长率7.5%。

Nested-girding method improves the solution of pressure function, which could upraise the speed more than 8 times.(4) Based on the qualitative analysis results of geology and employing greyclustering analysis method, the quantitatively discriminating pattern of the size of remaining oil potential is founded.

嵌套网格划分法改进了压力方程的求解过程，进一步缩短了运算时间，节约了设备运行成本；(4)以地质综合分析的定性分析结论为基础，采用灰色系统理论中的灰聚类方法建立的剩余油定性描述量化模型，实现了剩余油潜力大小的定量化评价。

The solution is to first plate on a layer of absorption of paper air pressure once again that the background color of the ink layer waxiness, non-drying oil quality adsorption off and short-run operation.

解决办法是先在印版上粘上一层吸收性强的纸空压一遍，将底色墨层上的蜡质、不干性油质吸附掉后，再进行烫印操作。

Some authors favor expanding the contracted capsule by means of high-pressure and high-volume saline solution injections or hydraulic-distension arthrography.

一些作者倾向扩展被收缩的囊通过高压力和高容量盐解决射入或水力扩张关节造影术。

Meanwhile, the coated surface was hydrophobic with a contact angle of 107.2°since the introduction of methyl groups and methylene groups. Static immersing corrosion test, potentiodynamically polarization curve and electrochemical impedance spectroscopy were conducted to evaluate the film corrosion performances. The results of potentiodynamically polarization curve and EIS in 55wt% LiBr solutions at room temperature in atmospherical pressure indicated that the corrosion current density of BMBSE film coated surface was 4 orders of magnitude smaller than that of bare SUS304 steel, and the impedance was increased by a factor of 10000. Static immersing corrosion test presented that the BMBSE film can significantly increase the corrosion resistance in 55wt%LiBr solution at 180°C compared with stainless steels.

同时由于有机组分甲基和亚甲基的引入，结构均匀致密，并具有一定的疏水性；电化学测试结果表明BMBSE膜的极化阻抗比不锈钢大4个数量级，自腐蚀电流密度也下降低了4个数量级左右，具有良好的耐腐蚀性能；成膜的影响因素优化结果表明BMBSE、EtOH、D.I.water摩尔比为1∶4∶3，热处理温度为200℃时，更有利于制备结构均匀、致密、耐腐蚀性能好的薄膜；静态浸泡腐蚀实验结果说明，在180℃、55%的高温溴化锂溶液中BMBSE膜能起到良好的腐蚀防护作用。

The invention discloses a dielectric hole-microhole composite material and synthesizing method in the inorganic porous material, adsorbing material and catalytic material technical domain, which comprises the following steps: adopting zeolite molecular sieve as raw material; reacting with sodium bisilicate solution under 30-60 deg.c for 10-300 min; disintegrating particle part of zeolite molecular sieve into piece with microhole structure; adding cetyl trimethyl ammonium bromide as molder; adjusting pH value of mother liquid to 10-12; aging 1-8h; adding in the high-pressure autoclave to do water heat synthesizing reaction at 80-130 deg.c for 24-72h; separating solid; washing; drying; sintering under 500-600 deg.c for 5-10h; obtaining the Si-Al porous material with dielectric hole and microhole composite structure.

本发明属于无机多孔材料、吸附材料和催化材料技术领域，涉及具有介孔-微孔复合材料及其合成方法。其特征是以沸石分子筛为原料，用偏硅酸钠的水溶液在30～60℃反应10～300分钟，使沸石分子筛的颗粒部分解离形成具有微孔结构的碎片，加入模板剂十六烷基三甲基溴化铵，然后调节母液pH值为10～12，老化1～8小时，然后加入高压釜于80～130℃进行水热合成反应。反应24～72小时后，分离出固体，水洗、干燥，然后于500～600℃焙烧5～10小时，得到具有介孔和微孔复合结构的硅铝多孔材料。本发明的效果和益处是所发明的合成方法可用于合成多种沸石结构和介孔结构的复合材料，所合成的材料经过质子交换可以具有较强的酸性，在吸附和催化领域具有广泛应用前景。

The surface pressure-area per molecule isotherm of 0.001molL^(-1) arachidic acid chloroformic solution at the air/liquid interface of pure water has been measured, and dynamic domains morphology of AA monolayer has been investigated via Brewster angle microscopy.

测定了花生酸的氯仿溶液在二次蒸馏水气／夜界面的单分子膜的表面张力与单分子面积的等温线，用布儒斯特角显微镜原位监测了花生酸分子成膜过程中单分子膜区域形貌的动态变化。

And the lower pressure is the reason of solution colligative property.

溶液的渗透现象、蒸气压降、冰点下降正是由于溶液中溶剂的压力比外界压力低而造成的。

The colloidal solution formed under lower concentration conditions has zero free water and is with large volume fraction, the advantage of which is good deformational ability at low pressure gradient.

在较低的浓度条件下形成的胶体溶液无游离水，颗粒体积分数大，具有形变压差小、形变能力强的优点。

In this paper,the electrochemical reduction of CO2 by various metal electrodes in aqueous solution,organic solvent and molten salt media is reviewed,which includes reaction activity and mechanism of every kind of metal electrodes. The effect of electrode,temperature,pressure,electrode potential and electrolyte on the selective and Faradaic e...

综述了金属电极在水溶液、有机溶剂以及熔融体中电还原CO2的研究现况，包括各类金属在电还原CO2过程中所表现出的反应活性以及生成相应产物的反应机理；介绍了电极、温度、压力、电极电位和电解质等因素对金属电极电还原选择性及法拉第电流效率的影响；展望了CO2电还原的未来研究方向及应用前景。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。