英语人>网络例句>solution formula 相关的网络例句
solution formula相关的网络例句

查询词典 solution formula

与 solution formula 相关的网络例句 [注:此内容来源于网络,仅供参考]

Using the formula supplied with the standard absorption curve, determine the amount of sulphur dioxide in the test solution from the absorbance measured.

用标准消光曲线提供的公式,从测量的吸收率来测定测试溶液中二氧化硫的量。

On the basis of the simplified differential equations, analytical solution of the radiation damping coefficient for a thin layer is derived, and then a simplified formula taking into account of a number of important influence factors is obtained.

求解了薄层辐射阻尼的解析解,并拟合了包含足够信息同时又便于使用的近似公式。

Using the Hamilton-Jacobi formula, an approximate solution of field equation that is beyond the slow-roll condition is obtained.

利用场方程的Hamilton-Jacobi形式,得到了场方程的一个近似解,这个解突破了通常的慢滚近似。

It is an improvement of previous approximate solution, and the formula in this article can be used in numerical calculation and simulation of atmospheric electric parameters in the future.

该文的工作是对以前相关工作仅能得到近似解的一种改进,同时本文所得公式可用于今后对大气电参量进行相关的数值计算及模拟之中。

And solutions given by the"exact"infinite series solution are compared with solutions calculated by the approximate formula.

比较了"精确的"无穷级数解法和高频近似解。

And the time needed for calculation using approximate formula is only 2/5 the time for"exact"intinite series solution.

且用高频近似式计算时所用机时仅为用"精确的"无穷级数解法计算时的五分之二。

This particular formula involves a special function,which is the uniformly bounded solution to a scalar Riemann-Hilbert problem,and which is asymptotically equal to the constant "1" except at the origin.

这个特殊的公式包含了一个特殊函数,这个特殊函数实际上是一个一维Riemann-Hilbert问题的一致有界的解,并且除了在原点,它的取值都渐近地等于常数"1"。

The results indicated that formula of low concentration nutrient solution (EC=1.376×10^3μs/cm) was adapt to soil culture and high concentration nutrient solution (EC=2.168×10^3s/cm) was adapt to modes of hydroponic culture and ceramicite culture for ornamental tomato.

结果表明:采用土培方式栽培观赏番茄宜选用低浓度的营养液配方(EC=1.376×10^3μs/cm),采用水培、陶粒培方式栽培宜选用高浓度的营养液配方(EC=2.168×10^3μs/cm);家居栽培观赏番茄宜选用陶粒培方式,并选用高浓度的营养液配方EC=2.168×10^3μs/cm)。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80~100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100~300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能,且合金内的V元素会向表面富集,因此,钛合金真空热处理和表面涂层的烧结温度不能过高,即应低于其相转变点;通过对生物活性梯度涂层的组成和结构的设计,分析和计算了梯度涂层内的应力大小和分布,结果表明:对于本研究,当成分分布系数n=1.5时,可以获得较合理的涂层力学性能,即在沉积开始时,采用富含BG颗粒的悬浮液,以便在钛合金侧获得同底层BG有良好过渡的富BG涂层;梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定,改变成分分布系数,只能改变涂层内应力变化的趋势;涂层的厚薄不影响涂层内的应力分布规律,但涂层越薄,涂层内的应力变化越快,但这并不意味着涂层越厚越好,因为涂层越厚,涂层允许的变形越小,对于应用于弯曲受力部位的涂层而言,涂层应薄一点为好(50μm);而对于仅纯受剪切应力的部位,如牙根种植体,涂层可适当加厚(80~100μm);通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现,它们在水溶液体系中很难发生电沉积;在无水乙醇溶液中,HA颗粒带正电,可在阴极钛合金片上发生均匀的电泳沉积,而BG颗粒则带负电荷;利用复分解反应法,可以制得100~300nm的HA,通过诱导HA在BG颗粒表面结晶,可对BG颗粒进行表面包覆,获得了被HA包覆的BG颗粒,改变了BG颗粒表面的带电特性,使BG和HA颗粒在无水乙醇中均带上正电荷,从而实现了HA和BG颗粒在阴极上的共沉积。

The results showed that stripping rates were strongly dependent on the concentration of H2O2 in alkaline solution and also affected by the crystal structure of TiN film. The aim of this study was to provide a formula solution for removing TiN film without damaging the substrate surface.

实验结果显示,碱性过氧化氢水溶液为蚀刻主要因子,并由此研究提供最佳之溶液组成配方,以达到去除氮化钛薄膜之应用,且在不损伤基材表面下完成。

第5/12页 首页 < 1 2 3 4 5 6 7 8 9 ... > 尾页
推荐网络例句

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸,那乌黑、忧郁的眼睛,她便会相信,他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失

But because of its youthful corporate culture—most people are hustled out of the door in their mid-40s—it had no one to send.

但是因为该公司年轻的企业文化——大多数员工在40来岁的时候都被请出公司——一时间没有好的人选。