查询词典 solids

Pretreatment for the RBC package plant is required to remove large, dense solids which might otherwise settle out in the RBC tankage or become lodged in the media.

要求RBC打包工厂的预处理可以去除厚大的固体，否则这些固体会沉降在RBC池底部或积聚在盘片中。

The results show that increasing the solids loading of slurry up to 45% allows minimizing deformation of green sheets during drying and sintering process effectively. When the content of monomers in shurry is 2%-4%, and the content of plasticizer in shurry is 3%-6%, green sheets with good strength and flexibility are obtained. The microstructures and the electric characteristics of PTCR chip thermistors were investigated. A five-layer chip PTCR thermistor with room resistance of 0.8Ω, temperature coefficient of resistance of 13.40%/℃, and ratio of maximum to minimum of resistance larger than 10^5 is successfully fabricated.

研究表明：浆料固相体积分数对坯体的乾燥及烧结行为有较大影响，当浆料固相体积分数在45%以上时，可有效避免制品乾燥和烧结过程中收缩过大而产生的变形开裂缺陷；当有机单体的质量分数为2%~4%，丙三醇的体积分数为3%~6%时，可获得有一定强度和柔韧性的生坯；研究了注凝成型PTCR陶瓷的微观结构及陶瓷元件的PTCR性能，成功地制备了层数为5、室温电阻为0.8Ω、电阻温度系数为13.40%/℃、升阻比大於10^5的多层片式PTCR元件。

The results show that increasing the solids loading of slurry up to 45% allows minimizing deformation of green sheets during drying and sintering process effectively. When the content of monomers in shurry is 2%-4%, and the content of plasticizer in shurry is 3%-6%, green sheets with good strength and flexibility are obtained. The microstructures and the electric characteristics of PTCR chip thermistors were investigated. A five-layer chip PTCR thermistor with room resistance of 0.8 Ω, temperature coefficient of resistance of 13.40%/℃, and ratio of maximum to minimum of resistance larger than 105 is successfully fabricated.

研究表明：浆料固相体积分数对坯体的干燥及烧结行为有较大影响，当浆料固相体积分数在45%以上时，可有效避免制品干燥和烧结过程中收缩过大而产生的变形开裂缺陷；当有机单体的质量分数为2％~4%，丙三醇的体积分数为3％~6%时，可获得有一定强度和柔韧性的生坯；研究了注凝成型PTCR陶瓷的微观结构及陶瓷元件的PTCR性能，成功地制备了层数为5、室温电阻为0.8 Ω、电阻温度系数为13.40%/℃、升阻比大于105的多层片式PTCR元件。

The projects are supported by National Nature Science Foundation of China. In the thesis, we take the heat transfer analysis of 3D interfacial layer of two contact solids as a cut-in point and investigates the visualization simulation of 3D ITR in the condition of vacuum and micro therm.

本文结合国家自然科学基金项目，以两接触物体的三维界面层为研究的切入点，研究真空低温环境下三维界面层热阻的可视化仿真问题。

It was noticed that pressure is also effective on influencing the thermally induced crystallization process of amorphous solids.

人们早已注意到外界压力对非晶材料的受热晶化过程有显著的作用。

Total hardness and total solids appear positive correlation with nitrate, but no correlation with ammonium.

总硬度和总固体与硝酸盐氮呈显著正相关，与氨氮未表现出相关关系。

There are two kinds of elastic waves in solids a compressional wave and a transverse wave.

在固体中有两类弹性波，一类是压缩波，另一类是横波。

Triboelectric charging canhappen between any materials such as solids, liquids and airparticles.

摩擦电控诉能在任何的材料，像是固体，液体和空气粒子之间发生。

Triboluminescence is the emission of light produced during mechanical on solids.

摩擦发光是指晶体受到机械力作用后，晶体变形或断裂时的发光。

Turbit water has small particles of solids suspended in it, so it will be cloudy or muddy to look at.

混浊的水中有悬浮的固体颗粒，因而看上去不清澈或污浊。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。