查询词典 solid-colored

Chock In a chock support, the canopy is a solid piece and the base may be either a solid piece or two separate parts connected by steel bars at the rear and/or the front ends.

钢梁 在钢梁支持下，天篷是一个坚实的作品和基地既可以是坚实的一件或两部分连接钢筋，在后方和/或前端。

Bumble Bee Solid Milk Chocolate Gift Box - Solid milk chocolate bumble bee designed foil wrapped chocolate.

大黄蜂固体牛奶巧克力礼盒-固体牛奶巧克力大黄蜂设计铝箔包裹巧克力。

An optimum multiple strain and processing test condition for producing micro-ecological, multiple enzyme feedstuff from beer grain with solid state fermentation was selected by using analytic hierarchy process. Meanwhile, data dispose and weight analyses to the relevant relations of all factores effecting the selection of the scheme were done after setting up a matrix. Multiple weight value of scheme X in target were X1=0.26, X2=0.41,X3=0.33 respectively, so that the optimizing multiple strains and relevant processing conditions of beer grains solid state fermentation were obtained.

利用层次分析方法对固态发酵啤酒糟生产微生态多酶复合饲料的工艺试验方案进行选择，通过分析影响方案选择的各因素之间的关系建立成对矩阵，并进行数据处理及权重分析，得到方案X在目标层中的组合权重值分别为：X1=0.26，X2=0.41，X3=0.33，由此得出啤酒糟固态发酵的最佳方案为X2。

In this dissertation, first, based on theory of cutting tooth about the gleason spiral bevel gear, the equation of meshing in the process of cutting tooth, the surface equation of generating gear as well as the general tooth surface equation of the double circular arc spiral bevel gear, using GB12759-1991 type of double circular arc gear as a basic gear profile, a three-dimension solid model of double circular arc spiral bevel gear which has the good adaptability was carried out by used of Unigraphics software;Second, by researching of the algorithm about contact and collision as well as various contact types based upon Contacting Finite Element Method, a foundation was laid for selecting the contact type in analyzing contact stress of double circular arc spiral bevel gearing;Finally, through the connection port of PARASOLID between UG software and ANSYS/LS-DYNA software, the three-dimension solid model of double circular arc spiral bevel gearing obtained above in UG was imported into ANSYS/LS-DYNA, a finite element analyzing about contact stress of double circular arc spiral bevel gearing was carried out by applying new loading method.

本文首先基于格利森弧齿锥齿轮加工原理及切齿啮合过程中的啮合方程、产形轮齿面方程以及双圆弧弧齿锥齿轮的齿面方程，选用GB12759-1991型双圆弧齿轮基本齿廓为基准齿形，利用Unigraphics软件的建模功能，绘制了有较好适应性的双圆弧弧齿锥齿轮传动三维实体模型。其次，描述了应用有限单元法进行实体接触与碰撞问题算法的公式，研究了有限元分析中的各种接触类型以及双圆弧弧齿锥齿轮接触应力分析中所选择接触类型的依据。最后，通过UG软件和ANSYS/LS-DYNA之间的PARASOLID接口工具包，将UG软件中得到的啮合齿轮模型导入ANSYS/LS-DYNA有限元分析软件，给出一种新的加载方法，进行了双圆弧弧齿锥齿轮传动的接触应力的有限元分析。

This paper discussed the determination method of solid decompound enthalpy with oxygen bomb calorimeter. After the solid sample and standard substance were accurately quantified and uniform mixed, and the pressed piece was put into the oxygen bomb and combustion.

探讨了利用氧弹量热计测定固体物质分解焓的方法，准确称取一定量的固体样品和基准物质，均匀混合后压片，放入氧弹量热计燃烧，记录燃烧前后时间和氧弹量热计温度变化数据。

Key introduces the CT-121 bubble type spraying tower haze desulphurization craftCT-121 uses the limestone - gypsum (it is in the present world is maturest, most economical, applies broadest desulphurization craft) the aqueous method desulphurization craftIt the sulphur dioxide absorption, the oxidation, neutral, technological processes and so on crystallization as well as dust removal merges to an independent gas - fluid - solid phase reactor in carries onIt the sulphur dioxide absorption, the oxidation, neutral, technological processes and so on crystallization as well as dust removal merges to an independent gas - fluid - solid phase reactor in carries on

与传统的石灰石-石膏湿法烟气脱硫工艺相比，CT-121最大的特点在于鼓泡式吸收塔。它将二氧化硫的吸收、氧化、中和、结晶以及除尘等工艺过程合并到一个单独的气-液-固相反应器中进行。气体进入喷射管，喷射成无数小气泡，形成鼓泡区，从而大大增加了传质面积，提高了脱硫效率。CT-121脱硫工艺能够达到95%以上稳定连续的脱硫率，最低10 以下的粉尘排放率以及优异的可靠性和实用性。问题补充：谁再帮忙给篇，石灰石-石膏湿法烟气脱硫方面的论文文献，谢谢了中英文版的，谢谢了555

The glucose-type calf milk replacer is fed to a newborn calf that has been fed with colostrum milk until the calf is fed on solid feed instead of liquid feed. The starch-type calf milk replacer is fed to calf of 30 days old until the calf is fed on solid feed instead of liquid feed.

葡萄糖型犊牛代乳品可以在初生犊牛饲喂初乳后使用，直到犊牛由液体饲料转为固体饲料；淀粉型犊牛代乳品可以从犊牛30日龄开始使用，直到犊牛由液体饲料转为固体饲料。

Methods After the solid dispersion of cinnamon oil was prepared by melting method, the effects of the process variables and formulation variables on solid dispersion and dissolution were investigated.

应用熔融法制备固体分散体后，以溶出度的测定为主要评价指标，采用正交设计对工艺及处方优化，并用红外光谱法考察药物与载体是否具有相互作用。

The method adopts powders (10.0 parts of mass) of crop straws and phenols or polyalcohol compound (10 to 100 parts of mass) which is firstly pre-heated by 10 to 30 minutes under a temperature of 30 to 200 DEG C with the effect of acid catalyst (0.5 to 10 parts of mass) for a reaction of 30 to 240 minutes; after the reaction, the compound is washed, neutralized, filtered and dried to obtain a solid appearing as a color from citron yellow, yellow, bight brown to seal brown; wherein, the solid includes 64.0 to 70,0 percent of fibrin and 4.1 to 7.6 percent of lignin.

秸秆&液化&预处理制备生产燃料乙醇原料的方法，是用农作物秸秆的粉末(10.0质量份)和酚类或多元醇类化合物(10～100质量份)，在酸性催化剂(0.5～10质量份)存在下，在30～200℃温度下预热10～30min后，反应30～240min，反应完毕进行洗涤、中和、过滤和干燥而得呈淡黄色-黄色-浅褐色至深褐色固体，其中，纤维素含量64.0～70.0％，木质素含量4.1～7.6％。

The gas solid interaction was studied, the solid concentration and particle size distribution contours downstream of the nozzle were obtained. The particle roping mechanism in a coal conveying pipe with large diameter was also studied with the fiber probe. The on-line coal concentration measuring facility is needed for NO〓 reduction. In this work, a set of on-line coal concentration measuring facility was developed and installed in the coal conveying pipes of a 660MW capacity utility boiler, which can give on-line accurate coal concentration information for the operator.

论文首次采用基于光学波动法的激光光纤探针，对高浓度的低NO〓燃烧器出口的气固两相流动的详细结构进行了试验，研究了配300 MW煤粉燃烧锅炉的燃烧器出口高浓度气固相射流中颗粒浓度、粒度随射流发展的演变规律，分析了利用水平浓淡燃烧器和齿形燃烧器实现对低NO〓燃烧有利的气固结构，并验证了基于DES方法的气固两相数值模拟的计算结果。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。