查询词典 solid angle

The preparative technique of solid lubricant is cold-press sintering method.The micro-structure , friction surface, lubricant transfer film surface of base material was characterized by SEM; XRD was used to do phase analysis. The degrees of crystallinity of pure PTFE under the different conditions of water cooling, air cooling and furnace-varying cooling were made comparison by XRD. The thermal stability of pure PTFE and solid lubricant was analyzed by DSC-TG; The composition and valence state of elements in the surface of carbon fiber ,solid lubricant before and after friction test and lubricant transfer film were characterized by XPS; The frictional property of solid lubricant was tested by pin and disk test rig .

用SEM表征原料微观结构、摩擦表面及润滑转移膜表面形貌：用XRD进行原料物相分析，及比较水冷却、空气冷却、随炉冷却三种工艺条件下的纯聚四氟乙烯树脂的结晶度；用DSC-TG分析纯聚四氟乙烯树脂及固体润滑剂的热稳定性；用XPS表征碳纤维表面、固体润滑剂摩擦前后表面、润滑转移膜表面的元素组成、价态变化；用销盘式摩擦磨损试验机对固体润滑剂进行摩擦性能测试；采用专用的台架模拟试验机对固体润滑剂镶嵌轴承套与钢轴摩擦副间的摩擦磨损性能进行测定；用莱次偏光显微镜测试固体润滑剂的硬度；用材料试验机测试固体润滑剂的抗压强度等。

With the fluid-solid coupling of train oil tank clue to train speed increase, the fluid-solid coupling modal analysis of G70B oil tank is calculated by NSYS. The finite element model of fluid-solid coupling system is set up. The fluid-solid coupling modal analysis of G70B oil tank is done for light oil tank train under different kinds of loads and its natural frequency and modal shapes are obtained.

针对列车油罐因列车提速导致液固耦合作用突出的问题，运用ANSYS软件对轻型油罐车G70B型罐体的液固辐合模态响应进行实例分析和计算；建立车载油罐的液固辐合系统有限元模型；对轻型油罐车G70B型罐体进行在不同贮液比时的液固福合模态分析，得出固有频率和模态振型图。

Points of knowledge: To know the definition, performance, category and preparation of solid catalyst; characteristic of solid catalyst, basic course of gas-solid catalytic reaction, physical construction of catalyst; to understand the derivation of intrinsic kinetics of gas-solid catalytic reaction by using the Langmuir 's adsorption isothermal line.

知识要点：了解并掌握固体催化剂的定义、性能要求、种类和催化剂的制法；固体催化剂的特性，气-固相催化反应进行的基本过程，催化剂的物理结构；掌握朗哥缪尔吸附等温线推导气固相催化反应本征动力学的方法。

Hence, based on acoustic potential function and boundary condition on solid interface, we get reflection coefficient and refraction coefficient of longitudinal wave and transverse wave on solid-solid interface, and provide approximate formula of the reflection coefficient and the refraction coefficient about the first critical angle of incidence. We analyze relation between the refraction coefficient and acoustic impedance.

为此，基于固体介质的声势函数和界面的边界条件，推导了固-固界面纵横波的反射系数和透射系数，以及第一临界角入射情况下反射系数和透射系数的近似公式，并且分析了透射系数与声阻抗之间的关系。

Optimal screw path length: The distance from the optimal entrancepoint to the optimal vent point Screw tail distance: The distance between left and right optimalentrance point Transverse section angle: Half of the included angle between left andright optimal screw Sagital section angle: The average of angle between both side optimalscrew with the upper terminal plate 1.2.2 Modify the threshold of CT value to distinguish the rear partof the lumbar, Observate the the optimal entrance point and the adjustable range.

1.2.2三维重建观察螺钉最佳进钉点的位置和各方向螺钉进钉点关系，调整CT值下限阈值使椎弓后部结构尽量显示清晰，以利观察。 1.3统计方法本实验采用SPSS13.0统计软件。对同一椎体左右两侧椎弓根螺钉相对数据行计量资料配对样本t检验，对男女组间相关数据行计量资料独立样本t检验，对男女组内不同腰椎节段间相关数据行单向方差分析及不同腰椎节段间LSD法多重比较。

Based on varying process of generator terminal parameters after excitation fault, shortages of excitation protective principle of static stability boundary and asynchronous impedance boundary are analyzed. It proposed that excitation fault research relates to large-disturbance stability. Because dynamic power-angle character of generator after excitation fault is non-sinusoidal, there are differences between dynamic power-angle character and static state power-angle character. So it isn't ideal to protective operation result based on small-disturbance stability and static stability boundary criterion. At the same time, it proposed that asynchronous boundary impedance criterion is a constant reactive power circle moving adown j Xd′. It can ensure complete loss-of-excitation generator measuring impedance enter into the circle, but can't ensure the other condition measuring impedance including impossible losing synchronism enter. So loss-of-excitation protection would be maloperation when system voltage drops short and recovers or generator rejects load.③Based on stability principle, it puts forward setting conditions and calculation method of generator loss-of-excitation protection by direct measuring power-angle.

以励磁故障后发电机端的相关参数的变化为基础，通过对以静稳定边界和异步阻抗边界作判据的两类三种现行励磁保护在原理上存在的缺陷分析，发现：励磁故障是一个大干扰稳定性问题，励磁故障后的发电机的动态功角特性与静态功角特性有很大的差异，已远非正弦曲线，因此基于小干扰稳定性原理、以静稳定边界作判据的保护必然动作不理想；异步边界阻抗判据是一个下移j Xd′的等无功阻抗圆，它可以保证完全失磁后的发电机测量阻抗能进入该阻抗圆，但不能保证完全失磁之外的其它状态不会进入该阻抗圆，因此在系统电压短时下降或发电机突然甩负荷等情况下可能启动该保护使之误动。

In this paper, a spark advance angle adjusting system is presented. In the system, spark advance angle of engine with carburetor on which spark controlled ECU is installed can be matched, the spark advance angle was real time adjusted according to engine different speed and load to find the ideal spark advance angle.

提出了一种具有调节点火提前角功能的控制系统，该系统能够在对化油器发动机进行简单改造加装点火控制ECU后对其点火提前角进行标定，对发动机在不同转速和工况下的点火提前角进行实时的调节，寻找到发动机在该转速和工况下的理想点火提前角。

Results There were obvious mandible changes such as the increase of SNB angle and decrease of ANB angle and overjet after treatment with Twinblock, suggestive of mandible growth, increase of facial angle, reduction of mandible process angle, mild adduction of upper incisors, and mild anteversion of lower incisors.

结果 矫治前后下颌骨的变化具有统计学意义，表现在SNB角的增大和ANB角、OJ的减小，提示下颌骨的生长、面角增加和颌突角减小，上前牙轻度内收和下前牙少量前倾。

［Objective］To identify the standard of radiographic diagnosis and analyse the measurement between tailor's bunion and normal feet.［Methods］The fourth-fifth intermetatarsal angle (IM4～5),modified fourth-fifth intermetatarsal angle (MIM4～5),metatarsophalangeal-fifth angle,lateral deviation of the fifth metatarsal angle,width of fifth metatarsal head,distance of prominence of the fifth metatarsal head were measured by X-ray for 131 feet of normal persons and 117 feet of tailor's bunion. The measured results and other clinical presentations were compared.

［目的］通过对小趾囊炎足与正常足X线的测量及对比分析研究，明确小趾囊炎足X线诊断标准［方法］对131例正常足与117例小趾囊炎足的第4～5跖骨间角(IM4～5)，改良4～5跖骨间角(MIM4～5)，小趾内翻角，第5跖骨外翻角，第5跖骨头宽度及突出距离进行X线测量，结合临床对测量结果进行对比分析研究。

Methods］The fourth-fifth intermetatarsal angle (IM4～5),modified fourth-fifth intermetatarsal angle (MIM4～5),metatarsophalangeal-fifth angle,lateral deviation of the fifth metatarsal angle,width of fifth metatarsal head,distance of prominence of the fifth metatarsal head were measured by X-ray for 131 feet of normal persons and 117 feet of tailor's bunion.

方法］对131例正常足与117例小趾囊炎足的第4～5跖骨间角(IM4～5)，改良4～5跖骨间角(MIM4～5)，小趾内翻角，第5跖骨外翻角，第5跖骨头宽度及突出距离进行X线测量，结合临床对测量结果进行对比分析研究。

Putt your way through 36 fun-filled holes of minigolf on 3D designed courses with elevated greens, bunkers, bridges and water hazards, among other crazy obstacles.

您的推杆方式，通过36个有趣的填孔迷你的三维设计的课程，以提升绿党，掩体，桥梁和水的危害，除其他疯狂的障碍。

Some participles can be used either as attributes or as predicatives.

有些分词既可当定语用，也可当表语用。