查询词典 sol-faing

Result: The nm-HAP-sol present the dispersed and uniformity needle. A431cells inhibition ratio was maximizing at the 5 day in the 400mg/L nm-HAP-sol group, the 200mg/L nm-HAP-sol group and the 100mg/L nm-HAP-sol group, inhibition ratio of the 400mg/L nm-HAP-sol group, the positive control group and the 50mg/L nm-HAP-sol group was respectively (77.89±6.29)%,(77.46±8.26)% and (1.23±0.15)%. It was detected that the number of A431 cells were persistently increasing in the 50mg/L nm-HAP-sol groups while decreasing in the 400mg/L nm-HAP-sol group, the positive control group and abidingly increasing for 4 and 3 days then decreasing in the 100mg/L and 200mg/L nm-HAP-sol group by inverted microscope.

结果：超声乳化法配制的HAP纳米溶胶呈均匀分散的针状；400mg/L、200mg/L和100mg/L溶胶组对A431细胞抑制率在第5天达到各组最大值，此时400mg/L溶胶组与阳性对照组的抑制率分别为（77.89±6.29）%和（77.46±8.26）%， 50mg/L溶胶组抑制率为（1.23±0.15）%；倒置显微镜下见50mg/L溶胶组细胞数目持续增加，聚集成簇，细胞呈现多角形或梭形，胞浆透亮，而100mg/L 和200mg/L溶胶组的细胞数目分别增加至第4天和第3天开始下降，400mg/L溶胶组和阳性对照组细胞数目持续减少，细胞体积缩小，漂浮细胞增多。

The polarization curves show that the corrosion current density of sol sealed film is about 2 orders of magnitude lower than that of the film sealed by sodium bichromate, the reason is that sol particles can not only seal pores of anodized film, but also form sol-gel coating on anodized film.

极化曲线显示溶胶封闭膜的腐蚀电流密度比重铬酸盐封闭膜的降低2个数量级，其原因是溶胶不仅封闭了氧化膜的孔隙，而且在氧化膜的表面形成溶胶凝胶涂层。

This invention discloses a new technology for preparing rear earth ionic doped fiber prefabricated rods with DC-RTA technology in a sol-gel method including preparing sol containing necessary doped ions, coating said sol uniformly on the inner wall of the quartz glass tube and burning it under high temperature to coagulate and vitrify them to a doped layer and repeating the above process to form a fiber prefabricated rod by oxygen and hydrogen flame after the doped layer reaches to a designed thickness and the fiber prefabricated rod can be made to various rare earth ionic doped fibers by an ordinary drawbench technology.

本发明属于光纤制造和光纤激光技术领域，具体公开了一种利用溶胶凝胶方法中的DC-RTA技术制备稀土离子掺杂光纤预制棒的新工艺。该工艺步骤包括预先配制好含有所需掺杂离子的溶胶，将该溶胶均匀涂覆在石英玻璃管的内壁后高温灼烧，使之凝结并玻璃化为一层掺杂层。反复上述涂覆灼烧过程，在掺杂层达到设计厚度后由氢氧焰高温收棒形成光纤预制棒。该方法所得到的光纤预制棒可以通过普通拉丝工艺拉制成各类稀土离子掺杂光纤。

In the aspects of research method, we took the method of preparing sol at first and then impregnating the wood to obtain ceramic-wood composite; this method made the wood use efficiently and increased the wood's weight gain percent. The ceramic-wood composite with performances of well decay resistance, dimensional stability, effloresce resistance and high strength was obtained by importing the cymene to the net of gel as the result of co-hydroxylation between MTES and TEOS. Making use of XPS ,we found that the apex of Si2p、O1s、C1s had evident chemical shift , which validated the existence of Si-O-C bonding.Key Words: Sol-gel, Ceramic-wood composite, Modified sol, Ecomaterials

在工艺方法上，采用先制备溶胶，然后浸注木材的工艺方法具有原料利用率高、提高增重率的优点；采用甲基三乙氧基硅烷和正硅酸乙酯共水解的方法，将甲基引入陶瓷化复合木材的凝胶内部，所制备的材料具有尺寸稳定性好、具有耐风化和耐腐朽性，强度高的特点；首次利用X射线光电子能谱，发现了Si2p、O1s和C1s谱峰发生了明显的化学位移，证实了Si－O－C键合作用的存在。

It was shown that the photocatalytic activity of TiO_2 catalysts that were prepared by sol-hydrothermal method was better than that prepared by sol-gel method from the comparison investigations of sol-hydrothermal and sol-gel methods, which result in the better dispersiveness of the former.

通过对溶胶-水热法和溶胶-凝胶法的比较研究，发现溶胶-水热法的制备样品的活性要高于溶胶-凝胶法，分析认为主要与前者的分散性较好有关。

The A13 sol and Al(0H)3—Zr4 sol is prepared by peptization method with A1(NO3)3 , ZrOCl2 and NH3H2O as starting materials, using A1(NO3)3 solution and Zr4 sol as peptizing agents, and the preparation process, preparation conditions and colloid structure are analyzed.

本文以Al(NO_3)_3，ZrOCl_2和氨水为原料，分别以Al(NO_3)_3溶液和Zr_4溶胶作为胶溶剂，通过胶溶法制备Al_3溶胶和Al_3—Zr_4溶胶，并对两种溶胶的制备过程，制备条件和胶团结构进行了分析。

Aluminum Ispropoxide was hydrolyzed to prepare Al〓O〓 sol. The hydrolyzed 〓CHOH affected the sol peptization. The colloidal particle was the smallest when the peptization time was 12 hours.γ-Al〓O〓 membrane without cracks, thickness about 2μm, was prepared from 1M sol with a suitable amount of PVA solution. The mean pore size of the membrane was about 3nm. And, the H〓/N〓 separation factor was 3. 53, exhibiting good separation performance.

异丙醇铝为前驱体，水解制备Al〓O〓溶胶，水解产生的异丙醇影响溶胶的胶溶效果，并且胶溶12小时得到的胶粒最小。1M溶胶加PVA制备厚度2μm左右，无开裂γ-Al〓O〓膜，经600℃煅烧，平均孔径为3nm，H〓/N〓分离系数可达到3.53，表现了很好的分离性能。

In comparison with the conventional method of coating on the tool surface, carbide powders were coated with boehmite sol when dispersed in the mixture of boehmite sol and ethanol. The coated powders were then dried, separated, and hot-pressed. The sol preparation techniques were optimized in experiments and the property of the sol was studied at the same time.

本文从提高硬质合金刀具的耐磨性、探索新型刀具涂层方法入手，突破了在刀具表面进行涂层的传统方法，提出了用溶胶－凝胶法在硬质合金碳化物粉末表面涂覆一薄层氧化铝陶瓷制成复合粉末，然后热压制备刀具材料的新方法，开发成功一类新型的陶瓷涂层硬质合金复合刀具材料。

I have an old notebook in which it says dev sol magic photos move.

我有一本旧笔记本，那上面写到了dev sol魔法照片是会动的。

The Sol-Gel chemical modified iodide electrode showed Nernst response to I- with a slope of 58.321mV/pI-,and a linear range of 10~(-1)～10~(-7)mol/L.

首先在Sol-Gel化学修饰碘电极测试中研究了加入CMC量表面活性剂的增敏作用。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失