查询词典 sodium chloride

Water, Dextrose, Less than 2% of: Potassium Citrate, Sodium Chloride, Sodium Citrate, Citric Acid.

水，葡萄糖，不到2 ％的：柠檬酸钾，氯化钠，柠檬酸钠，柠檬酸。

ADPODS posses stable Surface chemical properties when dissolved in 10% sulfuric acid, 10% sodium hydroxide or 10% sodium chloride aqueous solutions. ADPODS s emulsifiability and detergency at 650mg/L water hardness are very good.4 The micellar aggregation number of C16-MADS was determined by molecule fluorescence probe method.

采用分子荧光探针法测定了C_(12)-MADS与C_(16)-MADS的胶团聚集数，在一定的表面活性剂溶液浓度1.25×10~(-2～1.10×10~(-1)mol·L~(-1)范围内，N_m随浓度的增大而线性增大；体系温度和NaCl浓度对N_m的影响极小；胶团内核的微极性明显大于传统阴离子表面活性剂。

SODIUM GLYCOLATE— Transfer about 500 mg of it, accurately weighed, into a 100-mL beaker, moisten thoroughly with 5 mL of glacial acetic acid, followed by 5 mL of water, and stir with a glass rod to ensure proper hydration (usually about 15 minutes). Slowly add 50 mL of acetone while stirring, then add 1 g of sodium chloride, and stir for several minutes to ensure complete precipitation of the carboxymethylcellulose.

乙醇酸钠—取本品500mg，精密称定，置于100mL烧杯中，用5mL冰乙酸完全润湿，接着加5mL水，并用玻棒搅拌使水合作用完全（搅拌时间一般为15分钟），边振摇边缓缓加入50mL丙酮，再加入1g氯化钠，振摇几分钟以确保羧甲基纤维素沉淀完全。

This paper mainly studies effect and influence factor that typical corrosive medium (muriatic acid, vitriol, nitric acid, sodium hydroxide, sodium chloride etc.), consistence and condition temperature acts on the material coated on castiron centrifugal interface (PFEP, PPS, CPE, remodeled epoxy). It is studied that powder electrostatic spray, suspend fluid spray, suspend fluid electrophoresis underside coat etc. technics influences on coat quality coated with above four anticorrosive material. The property analysis is done that above four anticorrosive material and three coat technics adapt to centrifugal pump frame and running dynamic condition. In addition, the effect is introduced that castiron centrifugal coated anticorrosive material is used in coal water with alum.

本文侧重研究了典型腐蚀工作介质盐酸、硫酸、硝酸、氢氧化钠碱、氯化钠盐等品种、浓度、环境温度，对铸铁离心泵过流面的聚全氟乙丙烯、改性聚苯硫醚、改性氯化聚醚、改性环氧四种防腐涂层材料的试验使用效果和影响因素分析；研究了四种涂层材料粉末静电喷涂、悬浮液喷涂、悬浮液电泳底涂等涂装方法工艺对涂层质量的影响；四种涂层材料和三种涂装方法对离心泵结构和运行动态环境的适应性分析；介绍了铸铁离心泵防腐涂层在煤矿矾水中的应用效果。

Solvent dosage is 10mL/ gram epichlorohydrin. The yield of 5-chloromethyl-2-oxazolidinone was more than 65.2%. 5-Chloromethyl-2-oxazolidinone and sodium phenolate were condensated to give 5-phenoxymethyl-2-oxazolidinone after taking off the sodium chloride in yield of 63.0%~78.0%. Dimethylsulfoxide was used as the solvent, and orthogonal experiment to the reaction condition had been carried out.

用5-氯甲基-2-噁唑烷酮和酚钠缩合，脱去氯化钠后生成5-芳氧甲基-2-噁唑烷酮类化合物，选用二甲亚砜为溶剂，对反应条件进行了正交实验，最佳条件为：反应温度120℃、反应时间20h、物料配比1：1，产率为63.0%～78.0%。

Thermal decomposition reaction kinetics of potash feldspar -calcium sulphate-calcium carbonate system added to sodium sulphate and sodium chloride was studied.

研究了钾长石-硫酸钙-碳酸钙体系加入硫酸钠、氯化钠的热分解反应动力学，结果表明硫酸钠可以有效促进钾长石的热分解。

Aim To study the preparative process of sodium ferulate and sodium chloride injection.

目的研究阿魏酸钠氯化钠注射液的制备工艺。

There is a large difference to form the third phase when adding sodium chloride or sodium bromide.

在温度为20℃时，无法形成第三液相，而温度在2030℃间可明显看出温度对形成第三相的效应。

The process is based on the electrolytic deposition at the cathode of LME Grade A purity copper from a purified sodium chloride-sodium bromide electrolyte.

我翻成：处理的过程基于LME评定的A级纯铜阴极的电解沉积——它从氯化钠，氯化溴的电解质中提纯而来。

This paper makes study on effects of several factors such as leaching time,solid liquid ratio,concentration of KBr,NaCl,and NaClO on gold leaching in acid and neutral sodium chloride solution with bromide as catalyzator and industrial sodium chlorite as oxidizer.

研究了NaCl的酸性和中性溶液中用溴化物作催化剂，工业用的次氯酸钠溶液氧化剂，考察了KBr、NaCl及NaClO浓度，浸出时间和固液比对浸金率的影响。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。