查询词典 socket screw

Ensure that the suction valve and the leakage discharge hole alignment, hydraulic end of the screw and the corresponding four holes aligned.

确保吸液阀与漏液排出孔对齐，液力端的螺丝与相应的4个孔对齐。

So in the same rated capacity, the power consumption of the vertical screw shipunloader is 20%~ 28% of the pneumatic negative pressure suction machine. Energy-saving is more than 3 times.

即在额定卸船能力相同的前提下，垂直螺旋卸船机的实际卸船能力是气力式负压抽吸机耗电的20%～28%，节能达3倍以上，节能效果显著。

In the same rated capacity, the actual capacity of the vertical screw shipunloader is 1.4 ~ 1.65 times of the pneumatic negative pressure suction machine.

即在额定卸船能力相同的前提下，垂直螺旋卸船机的实际卸船能力是气力式负压抽吸机实际卸船能力的1.4～1.65倍。

This research is concentrated on the interactive behavior between the cold-formed steel wall stud and sheathing. Three kind of test specimens used in this study includes:(1) both stud and calcium silicate board are under compression;(2) the stud sheathed with calcium silicate board is under compression; and (3) the calcium silicate board supported by stud is under compression. Three different thicknesses of calcium silicate board and three different spacing of the connecting screw were adopted in the test. Totally, 36 specimens were tested in this research.

本研究乃针对冷轧型钢墙体立柱与外覆材产生束制的能力进行探讨，实验所采用的试体分为三种，具外覆材之墙体、具外覆材支撑之立柱、外覆材受压内含支撑之立柱，并配合不同厚度之矽酸钙板与改变不同螺丝间距进行互相比较，共进行了36组试验。

It was also found that the strength of FF specimen is close to the sumation of the strengths of FC and FS specimens with the same board thickness and screw spacing as FF specimen. As compared the test results with the research findings from Li [2]and Luo [3], It can be concluded that the failure mode of specimen is affected by both the sheathing thickness and the stud thickness. Different from this study, the failure mode of Li's test specimens is torsional-flexural buckling for most cases. The predicted values computed based on the AISI Specification seem to be conservative as compared to the tested values of FF specimens. Therefore, it is suggested that the effective length factor, K, can be taken as 0.5 to determine the wall stud assembly strength.

在三种不同试体组合分析时也发现，具外覆材支撑之立柱与外覆材受压内含支撑之立柱，两者之破坏强度相加，约等於具外覆材之墙体之破坏强度；试验结果与李岱真、罗浩之研究比较后，发现不同厚度之立柱与不同厚度之矽酸钙板之间束制关系明显影响强度之差异，且李岱真之试体破坏模式多为整体扭转-挠曲挫屈破坏，与本研究有较大差异；对於具外覆材之墙体与AISI预测值比较后，AISI规范预测值较保守，因此本研究有效长度系数建议采用0.5。

The main products are bolts, nuts, stud, screw shaped high strength fasteners.

主要产品有螺栓、螺母、螺柱、螺钉等高强度异型紧固件。

If this method of mounting is desired, accelerometers should be purchased that are designed for stud and/or screw mounting.

如果需要的就是这种安装方法，那么采购加速表时，必须设计用于螺柱/螺丝安装。

The best mounting method uses a threaded stud or screw.

最佳安装方式使用螺纹柱或螺丝。

Regular readers of this football boot blog may remember a post we made back in May, Puma " We invented the screw in stud, not Adidas ".

经常阅读，本足球靴博客可能还记得后，我们早在5美洲豹&我们发明了在螺丝钉，而不是阿迪达斯&。

Both football boot manufacturers claim to have invented the screw in stud, but Puma had been investigating their archives and believed they had proof.

足球靴厂商声称拥有发明螺钉螺柱，但美洲豹了他们的调查档案，并相信它们已证明。

We are in a good position to meet your requirements.

我们完全可以满足你方的需求。

We are all pervade d with a sense of disaster.

我们普遍有大祸降临的感觉。