查询词典 small particles

Its rule of change was obtained. On the basis of other studies, the flocculation kinetics and flocs structure was studied. By making some assumptions, collision frequency were presented. Then the the flocculation kinetics model was established through population balance equation. Comparison of experimental data and modeling results indicate that there are the same trend between the two. So the model can predict flocs number and size during flocculation of Yellow River's loess particles without using empirical parameters. The TEM and SEM were used to obsever flocs in the study of floc structure. The flocculation was divided as flocculi, floc and floc aggregate. The flocs structure model was established by assumption that particles position in floc accords with tetrahedron. The fractal dimension of model and experimental flocs was found to be coincident. So the model can reflect the structure of flocs formed in flocculation of Yellow River's loess particles by macromolecule flocculant at a certain extent.

最后，本文还对絮凝动力学和絮体结构进行了研究，在前人研究的基础上，针对高分子絮凝黄河泥沙，对絮凝过程作了一些符合试验条件的假设，建立了颗粒碰撞频率表达式，应用了颗粒数量平衡方程，从而建立了絮凝过程的动力学生长模型，模型计算结果与试验数据对比表明，二者趋势一致，在没有使用经验参数的情况下基本上能够描述黄河泥沙絮凝过程中絮体数量和尺寸分布的变化过程；对絮体结构的研究中，应用扫描电子显微镜和透射电子显微镜对絮体进行了观察，将絮体分为絮粒、絮团和絮网三个不同的生长阶段，通过假设颗粒结合位置符合正四面体，建立了絮体结构模型，计算得到的模型絮体分形维数基本与试验中的实际絮体相符，在一定程度上能眵反映高分子絮凝黄河泥沙生成的絮体结构。

Its rule of change was obtained.On the basis of other studies,the flocculation kinetics and floes structure was studied. By making some assumptions, collision frequency were presented.Then the the flocculation kinetics model was established through population balance equation. Comparison of experimental data and modeling results indicate that there are the same trend between the two. So the model can predict floes number and size during flocculation of Yellow River's loess particles without using empirical parameters.The TEM and SEM were used to obsever floes in the study of floe structure.The flocculation was divided as flocculi,floc and floe aggregate.The floes structure model was established by assumption that particles position in floe accords with tetrahedron.The fractal dimension of model and experimental floes was found to be coincidentSo the model can reflect the structure of flocs formed in flocculation of Yellow River's loess particles by macromolecule flocculant at a certain extent

最后，本文还对絮凝动力学和絮体结构进行了研究，在前人研究的基础上，针对高分子絮凝黄河泥沙，对絮凝过程作了一些符合试验条件的假设，建立了颗粒碰撞频率表达式，应用了颗粒数量平衡方程，从而建立了絮凝过程的动力学生长模型，模型计算结果与试验数据对比表明，二者趋势一致，在没有使用经验参数的情况下基本上能够描述黄河泥沙絮凝过程中絮体数量和尺寸分布的变化过程；对絮体结构的研究中，应用扫描电子显微镜和透射电子显微镜对絮体进行了观察，将絮体分为絮粒、絮团和絮网三个不同的生长阶段，通过假设颗粒结合位置符西安建筑科技大学博士学位论文合正四面体，建立了絮体结构模型，计算得到的模型絮体分形维数基本与试验中的实际絮体相符，在一定程度上能够反映高分子絮凝黄河泥沙生成的絮体结构。

PDA laser flow velocity testing technique was used to measure the flow velocity of solid particles in the solid-liquid-gas three-phase system in a flotation cell and obtained the velocity distribution of solid particles so as to provide reliable data for the study on adsorption and deadsoption mechanism of particles onto and off from bubbles.

采用PDA激光流速测试技术，在固-液-气三相体系中对浮选槽中固体颗粒进行了流速测定，获得了固体颗粒的速度分布，为矿粒与气泡粘附过程和脱附过程机理的研究提供可靠数据。

In flotation pulp, local cell was present in sulfide particles-water system, sulfide particles-modifer-water system, sulfide particles-collector-water system and grinding medium-water system; Galvanic coupling did in mineral-mineral interaction and mineral-grinding medium interaction, the material of higher potential acted as a cathode , and the lower as an anode.

在磨矿—浮选矿浆中产生的局部电池包括硫化矿物颗粒在水体系、调整剂体系、捕收剂体系和磨矿介质在水体系中的阳极氧化以及氧在同一固体表面上的阴极还原；在磨矿—浮选矿浆中的迦伐尼电偶则存在于硫化矿物—硫化矿物、硫化矿物—磨矿介质之间，其中静电位低的物质发生阳极氧化，氧在具有高静电位的阴极钝化物质上还原。

Results Brown iron particles could be demonstrated in the SPIO-labeled BMSCs under inverted phase contrast microscope. Numerous intracytoplastic iron particles were stained with Prussian blue, and diffused distribution of iron particles could be seen in the intracytoplasm under electron microscope.

结果 倒置相差显微镜下观察，标记BMSCs的细胞内含有棕黄色铁颗粒，普鲁士蓝染色呈阳性；电镜下胞浆内可见散在分布的铁颗粒。

To validate the above conclusion, a series of mixture tests were performed and different samples were made by mixing each of three kinds of nature silt and the nature clay with different mixture ratio. The liquid-plastic limits of all the samples, in which the clay particles content were between the nature silt and the nature clay, were attained using the combined test method. The results showed that the lowest clay particles content of the silt, when it was suitable with the combined test method, is 12% to 15% with little differences. If the point of 3～4mm depth of penetration of fall cone exist, and the loglog relationship between the depth of penetration of fall cone and the water content of all the points were clearly linear, it could be concluded that the clay particles content of the sample is over the lowest value when the combined test was suitable.

3其后为了进一步验证所得结论，针对三种粉土，分别与一种黏粒含量较大的天然黏土进行多种组合的配比试验，配比后的土样其黏粒含量均介于原粉土与原黏土之间，并对各种配比后土样进行联合测定法确定液、塑限的试验研究，得出各种土对联合测定法适用的最低黏粒含量限值因粒径组成不同、矿物组成不同等因素，存在微小差异，在12%到15%之间；当圆锥下沉深度在3～4mm之间的试验点存在，且与其他试验点之间能形成良好的双对数直线关系，即认为土中黏粒含量超过该土对联合测定法适用的最低限值，联合测定法适用。

The gas-to-powder conversion is carried out following the route: DMS pyrolyzes and forms product molecule and molecular clusters, the product molecular clusters that grow to and above the critical size by random collisions with molecules and other clusters become elementary particles, the elementary particles grow further by collisions and fusion with molecules, clusters and other elementary particles to form resulted SiC particle.

论文采用TEM、HREM、XRD、IR、NMR、中子衍射、Raman光谱和定量化学分析、光透沉降粒度分析等手段，对制备得到的纳米SiC粉体进行了系统表征研究，并研究了SiC纳米粉体的成核、生长、晶化过程和机制，指出化学气相反应法制备SiC纳米粉体的过程是一个均匀成核→核子生长形成初始颗粒→初始颗粒熔融碰撞→产物粉体的过程。

Multilayer latex particles with carboxylic polymer as core, polymer with low glass transition temperature and film-formable under room temperature as shell, and lightly crosslinked polymer as intermediate layer were prepared with unsaturated carboxylic monomers by multistage seed emulsion polymerization. Finally, the room-temperature-film-formable polymer particles with hollow structure were obtained via the alkali treatment to the multilayer latex particles.

采用羧基单体进行多阶段的种于乳液聚合，制备了内核为带羧基的聚合物、最外层为易成膜的低玻璃化温度聚合物、中间为轻度交联中间隔离层的多层核壳结构乳胶粒，最后通过碱处理制成了具有室温成膜性的中空结构聚合物微粒。

The invention provides a preparation method of small crystal SAPO-43 molecular sieve, which is characterized in that: the stepwise procedures are adopted to synthetize SAPO-43 molecular sieve, temperature-rising rate in different temperature phase during crystallization is controlled, so that the synthetized SAPO-43 molecular sieve has small particles, even crystal particles, short crystallization time, and reduce the amount of templates greatly, thereby reducing environmental pollution.

本发明的目的是提供一种小晶粒SAPO-43分子筛的制备方法。本发明的特点在于它是采用分阶段程序升温来快速合成小晶粒SAPO-43分子筛。通过对晶化过程中不同温度段内升温速率的控制，从而实现了合成的SAPO-43分子筛晶粒小，晶粒尺寸分布均匀，晶化时间短，且大大的降低了模板剂的用量，从而减少了对环境的污染。

Today, I read an article called "strong and the small snail's pace", the main author stresses small walk in the garden and found a snail is a small climb a tree, climbed up at the tree tops seemed to boost small author Zibuliangli think snails, but after a month later, when another author came to the small tree, the snail has climbed more than 30 meters, the authors looked at this small scene, this little life was touched by the strong.

今天，我读了一篇名叫《坚强的小蜗牛》，主要讲小作者在花园里散步时，发现了一只小蜗牛正在一棵树上爬，好像要想爬上树顶上去，小作者觉得蜗牛自不量力，可是过了一个月后，当小作者再来到树下时，蜗牛已经爬上30米以上了，小作者看着这一幕，被这个小生命的坚强所感动。

The dissecting of samples in group2 were difficult. The root of pulmonary artery and ascending aorta failed to be unfolded because fibrous tissue was tough, right and left fibrous trigone were too firm to be solved by hand. Cardiac muscle fibers couldn't be stripped along myofibrillar trajectory since they were prone to break because of their friability.

组2的心脏解剖困难，表现为纤维组织坚韧，游离肺动脉非常困难；徒手无法松解左、右纤维三角，肺动脉和主动脉根部的游离非常困难；心肌纤维坚硬、质脆，解剖时容易断离成碎块，无法沿纤维走行方向剥离。

We have battled against the odds in a province that has become increasingly violent.

我们对在一个争夺日益激烈省的可能性。