查询词典 slip-vector

This method overcome the problems of many supposition conditions in theory and difficulty in searching critical slip surface in 3D limiting equilibrium analysis; It uses the 3D FEM\'s stress field directly, differs from the practical value of 3D FEM strength reduction method used hypothesized load, and differs from the characteristic of the FEM with limiting equilibrium theory still to need to divide the columniation, and suppose the critical slip surface in advance.

该方法克服了三维极限平衡分析方法在理论上引入较多假设条件，且搜索临界滑裂面困难的问题；它直接采用三维有限元应力场，不同于三维有限元强度折减法基于虚拟荷载上得出的实用价值；同时异于沿用极限平衡理论的有限元法仍需要进行条柱划分，并事先假设滑裂面形状及位置的缺点。

It is a problem of the objects intrinsical nonlinear. For eliminating the stick-slip motion, we must start from the nonlinear field. According to the cause of stick-slip motion, a method of compensating the negative stiffness is proposed.

爬行是极限环形式的振荡，具有不稳定非线性系统的特点，消除爬行必须从非线性领域出发，根据对爬行原因的分析，提出了补偿干摩擦的负刚度的办法。

Slip as evidence) 89.Where there is a duly stamped policy, reference may be made, as heretofore, to the slip or covering note, in any legal proceeding.

在保险单有义务贴足印花之情况下，满足印花要求的承保条或承保通知书在法律诉讼中均得作为证据。

He takes the bill to the cashier who prepares a credit card slip. This slip, with your card and the original bill, is returned to you, often in a folder or on a tray.

他替你到结帐台付帐，之后会把信用卡以及你原来的帐单和收款条放在托盘或文件夹之类的东西里一同递还给你。

It shows that the FE method of tireanalysis under driving state and the method dealing with large slip frictionalcontact problems are correct and reliable. The properties of tires under steady cornering state are studied with FEmethod and experiment. Based on the presented contact solution algorithm, a FEmethod is carried out to analyze the properties of tire under steady corneringstate via imposing slip-rolling-constraints on tire bead nodes which contact therim, and the modules are programmed. The mechanical properties anddeformation of tire under pure steady cornering state and steadycornering-driving state are analyzed, and the results show good agreement withthe experimental data.

对匀速侧滑条件下轮胎侧偏特性进行了试验研究和有限元分析研究，基于本文提出的大滑动摩擦接触问题求解方法，通过在胎圈和轮辋接触节点上施加侧偏滚动约束，得到了匀速侧滑条件下轮胎侧偏特性有限元分析方法，编制了有限元分析模块；利用本文给出的有限元分析方法，分析了轮胎在匀速纯侧滑和侧滑-纵滑联合工况下受力变形特性，分析了侧偏角和载荷对轮胎侧偏特性的影响。

Finding out the maximum point of the equivalent plastic strain on each of the vertical lines, a group of discrete points on the critical slip surface will be obtained. Last, the discrete points are smoothed by means of the thin-plate smoothing spline; and the position of the critical 3D slip surface is determined.

最后，采用被称为薄板光顺样条(thin-plate smoothing spline)函数的插值方法对滑面上的离散点进行了插值光顺处理，在不指定边坡滑动模式和滑面形状的前提下就可以得到三维边坡的临界滑面。

We get both of the strike-slip distribution and the dip-slip distribution on the fault plane.

最终得到了断层面上的走滑和倾滑位错分布。

The fault-plan solutions for the two events of the injection-induced microearthquakes were determined by using the first-motion′s direction of P waves from records of the KTB surface stations the focal mechanism at 5.1 km: the nodal planes Ⅰ, strike 30°, dip 46°, slip 10°; the nodal planes Ⅱ: strike 293°, dip 83°, slip 136°; T-axis: azimuth 241°, plunge 35°; P-axis: azimuth 349°,plunge 24°.

用KTB地面台网记录的资料和P波初动方向得到了这次注水诱发地震中两个大地震的震源机制解。其中震源深度为5.1km的地震，其节面Ⅰ参数为：走向30°，倾角46°，滑动角10°；其节面Ⅱ参数为：走向293°，倾角83°，滑动角136°；T轴方位角：241°，倾角：35°；P轴方位角：349°，倾角：24°。

When did we give the slip the slip?

那么衬裙是何时悄悄溜走的呢？

The glassiness barrier layer mixes glass dust and mill addition into slip glaze, 50-180 um barrier layer is prepared by painting slip glaze on the surface of stainless steel, components of the glass dust according to the percent by weight comprises SiO2 37-40, B2O3 11-14, one or two kinds of Na2O and K2O18-20, one or two kinds of BaO and SrO 3.5-6.5, one or two kinds of Al2O3 and Cr2O3 2.5-10.5, one or two kinds of residues such as CaO, CaF and Na3AlF6, and the mill addition comprises agglomerants such as kaolin, borax, sodium nitrite and the like, adhesive agents such as CMC, PVA and the like and water.

该玻璃质壁垒层是将玻璃粉和磨加物混合成釉浆，涂在不锈钢表面制备50-180μm涂层，玻璃粉的成分按重量百分比：37-40 SiO 2 ，11-14 B 2 O 3 ，18-20 Na 2 O、K 2 O中的一种或两种，3.5-6.5 BaO、SrO中的一种或两种，2.5-10.5 Al 2 O 3 、Cr 2 O 3 中的一种或两种，余量CaO、CaF、Na 3 AlF 6 中的一种或多种；磨加物包括高岭土、硼砂、亚硝酸钠等粘结剂、CMC、PVA等密着剂和水。

By the time of its fall, most of the prisoners were writers who had written against the corruptions of the government.

到它被攻陷的时候，里面多数的犯人是写了反对政府贪污文章的作家。

The most obvious variation to ovum morphological character was that the color was changed from light green to sepiaceous in embryonic development, and all the ovums were almost hatched after 96h.

在胚胎发育过程中卵的形态特征最明显的变化是颜色从淡绿到深褐色，卵在发育96h后卵基本全部孵化。