查询词典 slip on

Assuming that the friction angle on different slip planes varied with the angle between the slip plane and bedding plane, an anisotropic strength criterion was established based on the concept of SMP. The formulation for cross-anisotropic granular materials was then derived.

基于SMP准则，假定不同平面上的摩擦角随该平面与沉积面之间的夹角变化，提出了一般应力条件下各向异性粒状材料的强度准则，称为ASMP准则，给出了该强度准则在横观各向同性条件下的表达式。

He takes the bill to the cashier who prepares a credit card slip. This slip, with your card and the original bill, is returned to you, often in a folder or on a tray.

他替你到结帐台付帐，之后会把信用卡以及你原来的帐单和收款条放在托盘或文件夹之类的东西里一同递还给你。

It shows that the FE method of tireanalysis under driving state and the method dealing with large slip frictionalcontact problems are correct and reliable. The properties of tires under steady cornering state are studied with FEmethod and experiment. Based on the presented contact solution algorithm, a FEmethod is carried out to analyze the properties of tire under steady corneringstate via imposing slip-rolling-constraints on tire bead nodes which contact therim, and the modules are programmed. The mechanical properties anddeformation of tire under pure steady cornering state and steadycornering-driving state are analyzed, and the results show good agreement withthe experimental data.

对匀速侧滑条件下轮胎侧偏特性进行了试验研究和有限元分析研究，基于本文提出的大滑动摩擦接触问题求解方法，通过在胎圈和轮辋接触节点上施加侧偏滚动约束，得到了匀速侧滑条件下轮胎侧偏特性有限元分析方法，编制了有限元分析模块；利用本文给出的有限元分析方法，分析了轮胎在匀速纯侧滑和侧滑-纵滑联合工况下受力变形特性，分析了侧偏角和载荷对轮胎侧偏特性的影响。

Finding out the maximum point of the equivalent plastic strain on each of the vertical lines, a group of discrete points on the critical slip surface will be obtained. Last, the discrete points are smoothed by means of the thin-plate smoothing spline; and the position of the critical 3D slip surface is determined.

最后，采用被称为薄板光顺样条(thin-plate smoothing spline)函数的插值方法对滑面上的离散点进行了插值光顺处理，在不指定边坡滑动模式和滑面形状的前提下就可以得到三维边坡的临界滑面。

The first special techniques was the method of tightening slip knot predisposed on atrial septal via veins. The suture with loop was placed on the atrial septum incision which will be closed during the decannulation. The loop was hitched up by the drawn-string via vein and tied with two or three slip knot after inserting left atrial cannulas.

第一种特殊技术是一种经静脉应用心导管将右房内预置的滑结拉紧的方法，其要点是术中在要闭合的房间隔切口处做缝合并留好线套，穿上牵引线经左锁骨下静脉引出，插左房管后打2或3个滑结，拔管后应用这种特殊技术将滑结拉紧，并拆除牵引线。

The research contents include: slip distribution rules; slip effect on deflection in service stage; the impact of the interface friction, the paper fitting calculation formulae of cross section flexural Stiffness break subtract modulus, on the base of experimental study and ANSYS FE result, in addition to, present some significative advice for practical design.

本文在试验数据和有限元分析的基础上回归得出了组合梁截面抗弯刚度折减公式，并为实际设计提出了几点参考建议。

The numerical results of yield strength, based on considering the lamellar microstructure and the deformation mechanisms such as ordinary slip systems and true twinnings in PST crystals composed of and phase, is obtained by using calculating of resolved shear stresses in all slip systems based on micromechanical method.

基于PST晶体的微结构和相及2相普通位错和孪晶滑移启动，结合细观力学方法，通过数值模拟两相中的各滑移系上的分切应力，得出PST晶体屈服应力和外加载荷与片层之间夹角的关系。

According to the structure and characteristics of slip-form construction, the granulation tower project to be based on the top elevation from start to carry out the assembly of sliding-mode platform, with variable cross-section slope-walled tower, taking into account the technical characteristics of slip-form construction, the proposed construction here, the variable cross-section made the slopes with variable cross-section level (internal reinforcement unchanged), and then adjust the thickness to die or continue to slip.

根据工程结构及滑模施工特点，本造粒塔工程拟从基础顶标高处开始进行滑模操作平台的组装，塔壁斜坡变截面，考虑到滑模施工的技术特点，建议施工此处时，将斜坡变截面做成台阶变截面，然后再改模调整壁厚继续滑升。

For thinner films, stacking faults are preferred in the scratch process, which increase storage capacity of plastic deformation in the film, and further inhibit the stick slip amplitude in the friction oscillation process. For thicker films, dislocation loops, which glide along slip plane downward to the grain boundary, dominate over the stacking faults, and finally dissipate on the grain boundaries. Since the intergrain stacking faults are inactive in thicker films, the stick slip phenomenon is similar to that in single crystal.

摩擦过程中易在较薄的薄膜表面和薄膜晶界之间产生穿晶层错，穿晶层错的产生增加了薄膜蓄积塑性变形的能力，从而抑制材料表面摩擦力在黏滑过程中的振荡幅度；在比较厚的薄膜中不易生成穿晶层错，在摩擦过程中位错环依次向体材料发射，并与晶界反应，湮灭于晶界，黏滑动摩擦响应与单晶相似。

Is it is it gain knowledge to tire and dry to exposed to state frictional force is it is it analyse to go on to commit road surface have to rub to use at first,lagging behind in forming frictional force elasticity on function,glueing and cutting function to analyse a little separately, state the building stones lamination and construct the influence that the depth resist slippery performance to the road surface;Is it is it set up tire sport model to transfer according to elasticity of tire to to slip,is it slip person who move adhere to relation of coefficient with road surface to establish.

首先运用摩擦学知识对轮胎与路面干燥接触状态下摩擦力构成进行分析，分别对构成摩擦力弹性滞后作用、粘着与微切削作用进行分析，说明石料纹理与构造深度对路面抗滑性能的影响；根据轮胎的弹性滑转建立轮胎运动模型，建立滑移值与路面附着系数的关系。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。