查询词典 sliding friction

Firstly, saltating sand grains in various height layers mostly rotate clockwise; the rate of counterclockwise rotation changes from 16.7 to 33.3% for three different friction wind speed (u*= 0.67, 0.83, and 0.87 m/s). However, their mean rotational speeds were not significantly different, irrespective of whether the grains rotated clockwise or counterclockwise. The mean counterclockwise rotational speeds of sand grains for friction wind speed u*= 0.67, 0.83, and 0.87 m/s were 427, 519, and 604 rev/s, versus 429, 522, and 609 rev/s, respectively, in the clockwise direction.

首先，风沙流中各高度层内跃移沙粒旋转均以顺时针方向为主，逆时针方向旋转的沙粒数仅占总数的16.7-29.5%，但是无论逆时针还是顺时针旋转的沙粒，它们的平均旋转速度几乎没有差别(如u*＝0.67 m/s时，分别为427 rev/s和429 rev/s；u*＝0.83 m/s，分别为519 rev/s和522 rev/s；u*＝0.87 m/s，分别为604 rev/s和609 rev/s)；不同摩阻风速条件下各高度层内沙粒的旋转速度均服从Lorentzian分布。

The effect of the friction moment of bearings on performance is researched. The forming mechanic and influence factors of the friction moment of ball bearing are analyzed. Suitable clearness and groove radius of ball bearings are obtained by experiment and calculation. The relationship between starting moment of ball bearing and various lubricants is analyzed. The measure for reducing the starting moment of ball bearing is put forward, it is the theory basis and reference for ball bearing design of small power unit system.The system is an unstable system when the 24-station ball pen tip production machine is running because of various interferences. It is too hard to describe the system by linear method, so the nonlinear formulation must be used.

研究了小动力头系统轴承摩擦力矩对运转性能的影响，分析了球轴承摩擦力矩的产生机理及影响因素，采用实验和计算的方法得到了动力头球轴承的合理间隙及球轴承沟曲率半径，分析了各种润滑剂与球轴承启动力矩的关系，并提出了减小轴承启动力矩的措施，为小动力头系统的轴承设计提供了理论依据及实践参考。24工位笔头加工机械在笔头的生产加工过程中，由于受到各种因素的干扰是一个不稳定系统，其稳定性会发生一定变化，而且很难用线性方法表述。

Compact pentroof combustion chambers and high-strength pistons that are resin-coated to reduce friction, low-tension piston rings and a low-friction valve train that uses roller rocker arms also are important features of this engine, as is an Acoustic Control Induction System that changes the length of the intake manifold runners based on engine speed and throttle opening.

紧凑pentroof燃烧室和高强度的活塞是树脂涂层以减少摩擦，低张力活塞环和低摩擦气门，使用滚子摇臂也是这个引擎的重要特色，是一种声学控制感应系统这改变了进气长度发动机转速和节气门开度为基础的多方面的选手。

The friction plate produces friction damping on the rope wheel under the influences of centrifugal force. The gear speed change helps the rope wheel produce balanced damping torgue when people descend.

利用离心使磨擦块在绳轮上产生磨擦阻尼，通过齿轮变速，使阻尼距与人下降时在绳轮上形成的主力距相平衡，以实现匀速下降，从而保证了被救者的安全。2。

Two pairs of chutes and holes on the cleaning base and the brushes form the double chute swing mechanisms by the connection of an axis and cause the brush to cling to the wall surface to clean by the friction feedback, thus achieving effective cleaning when walking error occurs and the pipe section changes, furthermore, the larger the friction on the wall surface is, the larger the forward pressure on the wall surface is, therefore, the dirtier the wall surface is, the higher the cleaning efficiency is.

清扫底座与刷子夹上的两对滑槽和孔通过轴的连接形成双滑槽摆动机构，并通过摩擦力反馈使得刷子能够紧贴壁面进行清洗，从而在出现行走误差和管道截面变化时都能够有效清洗，并且壁面摩擦力越大刷子作用在壁面上的正压力越大，因此壁面越脏时清扫效率越高。

A two-component mixed friction model is used to express the friction force in servo mechanisms.

伺服机构中的摩擦力是采用一种&两维混合摩擦模型&来描述的。

Determine (1)the angle acceleration of the tub wheel,(2) the tensile force of the rope,(3) the reaction forces at point O on the bearing,(4)the friction force between the cylinder and the inclined plane (neglecting the rolling friction).

在图示机构中，沿斜面向上作纯滚动的圆柱体和鼓轮O均为均质物体，各重为P和Q，半径均为R，绳子不可伸长，其质量不计，斜面倾角，如在鼓轮上作用一常力偶矩M。

Companies are the main product categories are: 1, iron-based friction material: including medium and heavy truck powder brake pads, brake-watt tank track; Engineering Machinery (such as forklifts, continuous casting rolling mill, etc.) brake pads, clutch friction films and so on.

公司现主要产品类别有： 1、铁基摩擦材料：包括中、重型载重汽车粉末冶金刹车片、坦克履带制动瓦；工程机械刹车片、离合器摩擦片等。

Internal friction in hardened low-carbon nickel steel was measured with a torsion pendulum and an internal friction peak was observed around 155℃ with a frequency of vibration of about 2 cycles per second.

用扭摆测量淬硬低碳镍合金钢中的内耗，当振动频率约为每秒2周时，在155℃附近有一个内耗峰出现。

Internal friction in hardened carbon steels was measured with a torsion pendulum and an internal friction peak was observed around 130℃when measurements were taken from room temperature upwards.

由内耗峰的出现可以认为马氏体在第一个回火阶段中的转变产物与母体具有共格性，由于共格界面的应力感生运动而引起内耗。

Finally, the Knight strung a line between two of the monoliths and tied the horses up there.

最后，骑士们在两颗巨石之间拉了一条绳子，将他们的座骑绑在上面。

T7zN/hyS0 The island lies south by east from here.

那个岛位于此地的正南偏东方向。