查询词典 sliding friction

The pressure responses of polymer packaged fiber Bragg grating sensor are analyzed, a special kind of pressure-resistant polymer is used to coat FBG in a metal tube. A kind of soft elastic material is used to reduce the friction between tube and polymer, and to eliminate chirp effect caused by different friction distribution to improve the pressure response of FBG.

分析了聚合物封装光纤光栅的压力响应特性，通过采用特殊聚合物材料将光纤光栅封装于金属套管中，并通过在金属套管预涂覆一层软弹性材料，以消除封装过程中由于聚合物固化收缩以及聚合物与套管壁粘接与摩擦产生的光纤光栅啁啾化，改善了光纤光栅压力响应特性。

The experimental results indicate that, over a ranger of tube side Reynolds number and Prandtl number (Re=4000~20000, Pr=6~7.5), the internal Nusselt number and friction factor of spiral-flat tube increased by 30%-150% and 20%-50% respectively compared with smooth tube at the same Re and Pr. The value of friction factor decreases with increasing the value of B/A as well as increasing that of S/de, and the same phenomena can also be observed for Nusselt number.

实验结果表明：管内Nu和f值均随均随B/A值和S/de值的增大而减小，但随B/A值的增加而减小得更快，B/A值对螺旋扁管管内传热与流阻性能影响更大；在相同Re和Pr下，螺旋扁管管内Nu数为光滑管的1.3～2.5倍；阻力系数f是光滑管的1.2～1.5倍。

According to experiment study of anti corrosive-wear capability about tube and rod friction pair which are made of ordinary materials and surface treatments,some straight figures were drawn about selecting friction pair's corrosive-wear ratio.

对抽油井常用管杆材料以及表面处理后的管杆材料摩擦副耐磨蚀性能进行了试验研究，结果表明：J55与N80普通油管与QT60接箍配合时，接箍磨蚀最小；而无论与哪种接箍对磨，涂层油管最耐磨，并且与非调质钢(FG20)接箍磨蚀时，接箍最耐磨。

Possible cause is that top roller bearing failure "" flufenoxuron, cots from being subjected to excessive friction, or other mechanical reasons, such as inking rollers rupture Peel, with water in chrome-plated iron roller surface is "" Burr "" Peel, and so on, may cause abnormal COTS bear "" friction cause unexpected damage cot.

不定的来因是胶辊轴承生效&卡活&，胶辊秉承超度磨擦而毁坏，或是其它板滞上的来因，如串不朱软辊分裂起皮，带火镀铬铁辊暗不天有&毛刺&，&起皮&等，城市使胶辊秉承&否变态&磨擦造不败胶辊的否预期毁坏。

In order to improve the accuracy of the existing transformation ratio model of the hydraulic transformer, a mathematical model is established by introducing the friction coefficient, the viscous drag friction coefficient and the laminar leakage coefficient.

为解决已有的液压变压器变压比模型与实际结果偏差较大的问题，通过对实际工作过程中不应忽略的摩擦与泄漏损失进行研究，引入机械摩擦损失系数、黏性摩擦损失系数和层流泄漏系数，建立了液压变压器变压比模型。

By experiments,three sources of the antilock friction moment and the static antilock friction performance on the Fe-based SMA locknut were tested separately,as a result the feasibility of the new-type nut was proved.

通过试验对铁基SMA螺母防松摩擦力矩的三个来源和静态防松性能分别进行了测定，从试验的角度证明了这种螺母的防松性能。

Since the last century, with the industrial and technological development in the theoretical study of friction further to the mid-century, the birth of a new adhesion of friction.

自上个世纪，随着工业和技术的发展，在理论学习中的摩擦，进一步向本世纪中叶，诞生了一个新的粘附摩擦。

By designing and selecting oils that minimised friction between the moving parts of the engine, it is possible to minimise the power and friction losses in an engine.

通过设计和选用适当的润滑油，可以减小发动机活动部件之间的摩擦，就可以降低发动机中的功率和摩擦损失。

In order to analyze force easily,we simplify the model of FA cyloid,taking no account of friction,supposing that there is the maximum of distortion in the largest arm of force,but in fact,friction must be exist and there is not always needle tooth in the largest arm of force.

为了便于分析受力，传统齿形简化FA针摆传动模型：不考虑摩擦因素、假定在摆线轮最大力臂处产生最大变形等，而实际上摩擦一定存在、在线轮最大力臂处未必有针齿存在。

The paper folding machine also consists of air-breathing into the paper and friction type feed two, the best selection of air-breathing into the paper-folding machine, because friction type feed easily damaged, as good as a digital business card printing and membership card making prints.

折页机的给纸部分又分为吸气式进纸和摩擦式进纸两种，最好选择吸气式进纸方式的折页机，因为摩擦式进纸容易损坏已印好的数码制卡和会员卡制作印品。

Finally, the Knight strung a line between two of the monoliths and tied the horses up there.

最后，骑士们在两颗巨石之间拉了一条绳子，将他们的座骑绑在上面。

T7zN/hyS0 The island lies south by east from here.

那个岛位于此地的正南偏东方向。