查询词典 slenderness ratio

Through the low cyclic load test of eight high strength concrete-filled square steel tubular columns, considering the effect of the axial compression ratio, steel ratio and slenderness ratio, the hysteretic curve, ductility, degradation of stiffness, energy dissipation capacity, failure mechanism and characteristics of the specimens were researched.

摘要］以轴压比、含钢率和长细比为参数，进行了8根方钢管高强混凝土柱的低周反复荷载试验，研究分析了该类构件的滞回曲线、延性、刚度退化、耗能能力、破坏机理和破坏特征；并与型钢高强混凝土柱的受力性能进行了比较分析。

It was estimated pulp properties with Runkel ratio more than 1 would be harder in tension for fiber and less oriented fiber to make paper into fluffiness (Casey,1980), with flexibility coefficient less than 0.5, the paper had medium tensile strength, burst strength and folding endurance, with slenderness ratio no less than 75 that be the paper of medium tearing strength but suitable beating with per cent of wall fraction less than 40 per cent would be good paper (Rydholm, 1967) while fibers completely oriented to get higher tensile and burst strength.

牙髓腔的财产据估计超过1比率将难以在紧张、纤维少使纸纤维成蓬松型、弹性系数低于0.5，该报中等抗拉强度、爆裂强度和耐折、与细比不少于75文件中被撕裂，但适当强度击打元墙上分数占不到40%将好的文件(rydholm， 1967)而获得较高的完全纤维拉伸强度和爆裂。

The parameters used in the analyses include rise to span ratio, slenderness ratio, steel ratio and load conditions.

分析的参数有矢跨比、长细比、含钢率以及加载方式。

This requirement ensures that the slenderness ratio of the individual Csection between connectors is less than or equal to one-half of the slenderness ratio of the entire compression member in the case that any one of the connectors may be loosened or ineffective.

这个要求确保在任一连接件可能松脱或失效的情形下，单段U型钢的长细比小于或等于整个抗压构件长细的二分之一。

Furthermore, the model was applied to the simulation of the spontaneous condensation in two-phase vortex tube, and the effect of slenderness ratio, diffuser, pressure ratio and cold mass fraction on separation performance has been predicted.

应用该模型对含湿气体在涡流管内的自发凝结过程进行了模拟。通过分析凝结参数的变化，预测了基本结构参数长径比、阻涡器与操作参数压比、冷流率对装置分离性能的影响。

The results show that the most remarkable factor is the slenderness ratio, the axial compression ratio takes second place and the steel ratio is third.

结果表明，对其影响最大的为长细比，其次是轴压比，再次是含钢率。

Total of 16 CFST dumbbell shape d columns subjected to eccentric loads were tested with variation of slenderness ratio and eccentricity ratio.

以长细比和偏心率为参数，进行了共16根钢管混凝土哑铃形偏压柱的试验。

With Newton-Raphson and arc-length calculation method, this paper has made research on effect of various cable style, rise-span ratio and slenderness ratio on ultimate bearing capacity.

文中使用牛顿—拉弗森法和弧长法对荷载—位移平衡路径进行跟踪研究，研究了索对结构极限承载力的影响；分析中考虑了不同矢跨比和长细比等因素对索—拱结构极限承载力的影响。

According to different axial compression ratio and slenderness ratio, this paper designs 12 types of square section column and 12 types of I section column single-story steel frame structures, and gives overall dimensions and characteristic parameters, then provides data for establishing ANSYS finite element models.

按照不同的轴压比和长细比分别设计 12 种柱截面为方形的单层钢框架和 12 种柱截面为工字形的单层钢框架，给出了单层钢框架体系的总体尺寸及特性参数，为 ANSYS 有限元分析提供建模数据。

Influences of several parameters, such as axial compression ratio, slenderness ratio, steel ratio and strength of the materials on the hysteresis behavior of the beam-columns are analyzed.

基于理论分析模型，分析了各参数，如构件轴压比、长细比、截面含钢率和材料强度等因素对圆钢管混凝土压弯构件P-△滞回关系曲线的影响。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。