查询词典 slag hole

Our products can be used sand, stone, coal slag, fly ash, coal gangue, all kinds of tail slag, ceramic, perlite, and other industrial waste processing into a variety of new wall materials, high efficiency, energy saving, environmental protection, rich source of raw materials , The production process is simple, less investment and quick, broad applicability and broad prospects.

本厂产品均可采用砂、石、煤渣、粉煤灰、煤矸石、各种尾矿渣、陶粒、珍珠岩等工业废料加工成各种新型墙体材料，高效、节能、环保，原料来源丰富，生产工艺简便，投资少，见效快，适用性广，前景广阔。

The samples of MgO-C brick with slag-splashed layer were obtained in taphole after slag splashing for 4 min.

研究了镁碳砖和铝碳砖在高钛渣中的侵蚀行为。

Mould slag entrapment brings out the phenomenon of break wire in the drawing of high-purity steel C72DA.Through studying mould flow field,conclusion is considered that mould slag entrapment is near the mould wall and is caused by serious undulation of the steel level,the hot metal bias or unmelted mould power.

结晶器卷渣引起高纯净度的C72DA钢在拉拔过程中出现断丝现象，通过对结晶器流场的研究，认为结晶器卷渣主要在结晶器壁附近，是由于表面钢水的波动严重、钢水偏流、或保护渣熔化不良引起的。

In low basicity, because of the low melting of the slag phase, it is bad for the gas-solid reaction of ferric iron oxide and separating iron from slag The research discovered: Sulfur can be deprived above 90% during direct reduction. The mechanic of desulphurization is gasification desulphur.

研究发现，在直接还原过程中可以脱除90%以上的硫，脱硫主要机理是气化脱硫，内配煤团块中的硫化物和有机硫进入气相，一部分随炉气脱离团块，一部分被配入的CaO吸收。

By analyzing the dynamics condition of ladle top-slag desulphuration and the physical and chemical properties of slag and combining production practice, the compositions of the modifier were confirmed, that is, Al 13%～17%, Al2O3 58%～62%, SiO2 8%～12%, MgO 3%～7% and salts＜8%. In the experiment, different amount of modifiers were used instead of the refining agent in original process (for Q235C steel grade).

为降低钢包顶渣的氧化性，通过分析钢包顶渣脱硫的动力学条件及炉渣的理化性能，结合生产实际，确定了顶渣改质剂的组成：Al 13%～17%，Al2O3 58%～62%，SiO2 8%～12%，MgO 3%～7%，盐类＜8%，改质剂具有高效实用、成本低、环境友好的特点。

It is noticeable that while w/c ranges from 3 to 5, long term strength of the grout increases significantly because of the existing of slag in the grout, i.e. while w/c are different, the grouts are affected differently because of the slag added to the grouts.

而值得注意的是添加炉石对於水灰比介於3-5之浆体的晚期强度提升有较明显之帮助，这也显示了在不同水灰比的情况下，添加炉石对浆体亦会产生不同程度之影响。

According to variation of slag oxidizability and basicity with time, the routes of slag formation during smelting medium and low phosphorus liquid iron were discussed in detail.

为此从炉渣碱度和炉渣氧化性两个方面讨论了复吹转炉冶炼低磷铁水和磷含量较高的铁水的成渣路线。

Through comparing and analyzing the metallurgical effects, proper addition quantity of the modifier was 80 kg per heat. The experiment results showed that the modifier smelted the slag fast and reduced the oxidizability of the top-slag rapidly. Comparing with the original process, the average content of aluminum in the steel was increased by 0.06%, desulphurization ratio was increased by 89.25% and TFe was reduced by 0.6%, then stabilizing the production of aluminum containing steel.

试验中用改质剂代替原工艺中的精炼剂（Q235C钢种），通过对改质剂不同加入量的冶金效果进行对比分析，确定的改质剂加入量为每炉80 kg，试验表明，改质剂化渣快，能迅速降低顶渣的氧化性，与原工艺相比，钢中平均铝含量提高0.06%，脱硫率提高89.25%，渣中全铁降低0.6%，稳定了含铝钢的生产。

The components involving slag composition are divided into 2 categories, namely ① quadribasic series SiO2-CaO-MgO-Al2O3, base salinity variation being 0.9~1.3;② range of of ferric oxide is FeO 1%~7%, magnesia MgO, and base salinity is fixed at 1.08 pentabasic system SiO2-CaO-MgO-Al2O3-FeO slag.

研究的炉渣成份主要分成两大类，分别是①四元系列的SiO2-CaO-MgO-Al2O3，盐篡度变化为0.9~1.3；②氧化铁范围为FeO1%~7%，氧化镁MgO，盐基度因定为1.08的五元渣系SiO2-CaO-MgO-Al2O3-FeO炉渣。

CaO in the converter slag was examined by petrographic microscopy analysis and its stabilization was investigated in 5～10 mm steel slag through a designed digestion device.

的分布规律，并设计钢渣消解装置对5～10 mm的钢渣进行了转炉钢渣稳定化试验，采用热重法对试验完的物料进行分析。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"