查询词典 sinter

The use of cheap raw materials, simple processes and simple equipment, while in the legal system for a Zirconia-based ceramic materials of valuable hardware, through the precursor decomposition by zirconium oxide ceramic micro base, and on this basis, the use of dry-pressed shaped and without pressure sinter prepared for the implications for sinter explore sintering processes.

本文使用价格低廉的原料、简单的工艺和简易的设备，固相法制备出氧化锆基陶瓷粉体的前驱体，通过前驱体分解得到氧化锆基陶瓷粉体，并在此基础上，利用干压成型和无压烧结对所制备的粉体进行烧结，探讨烧结工艺。

The cuspidine is all long known as the main factor leading to the low strength o the sinter bearing fluorine, But with the fluorine decreasing by a wide margin, the strength of the sinter bearingfluorine get lower. So, the first work is to fine out the reason to cause the strength low.

含氟烧结矿中的枪晶石一直被认为是制约包钢烧结矿强度的主要因素，但随着含氟量的大幅度降低，烧结矿的强度却进一步恶化，因此，弄清影响低氟烧结矿强度的原因是提高烧结矿强度的前提和基础。

It is convenient for sinter to be leached, and the secondary reaction appears little. The slurry after sinter leaching is transferred into autoclave for desilicification at about 170℃, and the siliceous modulus of solution reaches more than 200. Then some lime is added for deep-desilication at normal pressure, the siliceous modulus of solution increases more than 600 even if the Al2O3 content is more than 200g/L.The SiO2 coefficient in hydrate garnet from deep-desilication is more than 0.28. Under conditions of the addition of seed and application of novel technology of carbonization, the contents of Na2O and SiO2 in product are less than 0.37% and 0.025%, respectively.

实验结果显示：烧成的熟料溶出条件宽松，二次反应程度弱；溶出浆液在170℃左右直接进行加压脱硅，脱硅后溶液的硅量指数大于200，再加入适量的石灰进行深度脱硅，即使溶液中氧化铝浓度超过200g/L时，精液的硅量指数也大于600，且得到的水化石榴石中二氧化硅饱和系数大于0.28；通过加入晶种和采用新的碳酸化分解工艺制度，产品中的SiO2 含量降至0.025%， Na2O含量小于0.37%；加入表面活性剂，不仅能将碳分母液蒸发至Na2OT浓度大于300g/L，而且还可有效减缓表面上结疤的形成速度。

The furnishing and the endmost section of sinter machine automatic supervision and picture analysistaking advantage Of specialist's experience system for Magang the second sinter plant are developed.

研制了马钢第二烧结厂烧结机布料及机尾断面自动监测图象专家分析系统，简要介绍了该系统的应用及硬件和软件主要基本结构及设计方案。

In response to this situation VAI has recently developed the so-called MEROS process- standing for Maximized Emission Reduction Of Sintering in which dust and harmful metallic and organic components present in sinter offgas are removed in a series of treatment steps to levels previously unattained with conventional gas-treatment techniques. In a number of test campaigns conducted in a demonstration plant at voestalpine Stahl from 2005-2006, the technical and economical advantages of this innovative sinter offgas-cleaning process were verified.

基于这种情况，VAI近来开发出了一套名叫METRO的系统，能最大限度的减少烧结系统的排放，在这一系统中，烧结过程废气存在的粉尘、有害的金属物质和有机物质都在一系列的处理步骤中排除并且达到一定的水平，而这是传统的废气处理方法所无法达到的。2005到2006年间，在奥钢联位于澳大利亚林芝的实验厂里，进行了很多的试验，这一改革的烧结烟气净化处理系统的技术和经济优势得到了验证。

A laboratory test was conducted to add small amount of fluorite,boryte,iron-manganese ore and boron mud to vanadium titanomagnetite concentrate sinter mix and to investigate the effect of SiO_2/TiO_2 variation on the sintering process and sinter metallurgical properties.

探讨了实验室条件下，在钒钛磁铁精矿烧结混合料中添加少量萤石、重晶石、铁锰矿、硼泥等辅料及改变SiO＿2／TiO＿2对烧结过程和烧结矿冶金性能的影响。

In a previous project implemented by VAI, the sinter-strand length was extended by 18 m to increase the total sinter production.

之前，由VAI完成的工程，带式烧结机的长度已经增大到18米以提高总体烧结产量。

Investigation shows that decreasing the bed thickness and mix moisture and increasing the fuel content of raw mix and granularity of coke breeze can all increase the FeO content in sinter. In addition, reducing R and increasing SiO2 content in sinter can also increase FeO content.

生产中发现，烧结矿FeO含量不仅受配碳量、混合料水分、返矿配加量等作用的交互影响，还与原料结构、烧结矿碱度、MgO含量和SiO2含量等因素有关，是多个变量共同作用的结果。

As a result, some ideas about the fabrication are put forward.The EPMA experiment results show that the main element such as W, Mo, Ti, Ni, Cu, Fe element are changed gradually in W-Mo and W-Mo-Ti FGM. In the layer rich in W, the grain are intervained and are mixed mechanismly. The same is to the layer rich in Mo and W-Mo. These grain felt up by some sinter. In Mo-Ti layer rich in Mo, the grains are also mixed mechanismly. Ni, Cu, Fe element assembled at interface. Ni melt by Cu plays an vital role in sinter effect. The microstructure characteristics result show that the compactness of W-Mo and W-Mo-Ti FGM is good.

电子探针实验结果表明W-Mo系、W-Mo-Ti系梯度功能材料中主要元素W、Mo、Ti、Ni、Fe、Cu分布整体上具有梯度变化规律，发现富W区、富Mo区、W-Mo混合区中颗粒交错分布，基本上以机械混合的形式存在，颗粒之间主要靠烧结剂的粘结作用实现致密化；以Mo为主要组分的Mo-Ti混合区，也是以机械混合的形式存在；Cu溶解于Ni形成固溶体更好地起到活化烧结能力，Ni、Cu、Fe在宏观层间界面富集，有利于烧结致密化。

Consequently, the permeability of cohesive zone in blast furnace can be improved and the total pressure drop in blast furnace can be decreased by use of such sinters. In order to ensure proper MgO content in the BF slag and improve the RDI of sinter, a new process of adding MgO in BF is proposed.MgO; sinter; blast furnace; cohesive zone

本文考察了MgO对烧结工艺及烧结矿冶金性能的影响，提出了合理添加MgO新工艺的建议。1 MgO对烧结工艺的影响1.1 烧结试验在实验室条件下，以各种铁精矿粉为原料，使用j6150 mm烧结杯系统，考察MgO含量对2种碱度(R=1.36和R=1.76)烧结工艺的影响，烧结试验中的MgO以白云石的形式添加，MgO的质量分数分别为1.3 、1.7％、2.1 、2.6 和3.0％，其他烧结工艺参数见表1.1.2 试验结果及。。。。。。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失