查询词典 signal plate

Electric remote control device adjustment is used, General monlchamus tuhung seat mounted above the keybed-iron plate, covering a hard plastic, and a flexible plastic to prevent ink seepage, each iron plate is fitted with a front end, eccentric roller roller bearing rings on both sides of the plastic top tight in tuhung roll, bucket seat is fitted with a total of 30 to 32 of these eccentric roll, each of which the width of the eccentric roll and 30 ~ 32 mm, when servo motor signal receiving console by mechanical structure, change the eccentric roller and rollers of the gap, so that once the monlchamus tuhung-high ink, led, according to the extruded plastic clearance form different deposit, attachthemselves in tuhung roll, roll over the ink input ink this structure is characterized by correctly restrict each supply the location of the monlchamus region of adjustment on the nearby monlchamus area for inking, plastic affected by friction, easy-to-wear constantly, you need to change on a regular basis.

而电不静调度是用遥控安拆来举行的，凡是的不朱斗座底下拆有一排琴键式铁板，暗不天包围一张软塑料片，而塑料片具有不塑性，制止油不朱的渗漏，每块铁板的前端拆有一个公道辊，辊双方的支承环不兵塑料片底不松在不朱斗辊上，不朱斗座上共拆有30～32个公道辊，每个公道辊的宽度约为30～32mm，当伺服电机剥夺把持台的暗记后，堵住板滞布局，保持公道辊与不朱辊的间隙，因此当不朱斗辊不静弹时，不静员油不朱挤不抬塑料片，不梢据间隙巨细变成差别不朱层厚度，附着在不朱斗辊上，堵住传不朱辊不输出匀不朱机构，这栽布局的特不面是可以不差不天不拘每个不求不朱区的场所，制止一个不朱区的调度差附近不朱区不求不朱度爆发感化，塑料片受到不停摩擦，难磨损，需按期调换。

By varying a small signal voltage riding on the C battery, the flow of electrons to the plate could be controlled to generate a much larger voltage.

通过改变C电池上的一个小信号电压，流向极板的电子流可以通过控制来产生更大的电压。

The following are the expressions for the mean pressure set up at the detection plate and for the time of the signal to progagate from the radiator to the detector:这里是1个公式,省略） where Re is the real part of the expression appearing within the braces, 0 is the density of the medium, vo is the amplitude of the vibrational velocity, c is the speed of sound in the medium, d2 = I +(r/zcos 8, z is the distance between the emitting and receiving plates, B is the angle between the axis of the acoustic channel and the axis of the tube, r = vro/c, v is the flow speed of the fluid, d is the diameter of the pipe, m is the circular frequency, k is the wave number, where a is the radius of the plate (this is taken as the same for the emitting and receiving plates for simplicity, but there is no difficulty in discussing plates differ~mg in radii),,~ is the vibrational frequency of the emitting plate, and The triple sums in the expressions for N~ and N2 may be neglected if the flow speed is low, since the contributions for these become negligible.

以下的表情为代表的压力设置在检测板甲，手持骑枪和时间的信号 progagate从散热器排出到检测器(这里是1个公式、省略)。在什么地方才是真正的出现在背带，表现为0密度的吗当时的媒介的振幅振动速度、c是声音的速度中、d2 =我+ r / z，8、z是距离的发射和接收板、B之间的角度对声信道和轴轴管，r = vro / c，v的流体的流动速率公式，d 管直径的圆频率，m，凯西是波数公式* n，一个是半径的板(这是作为相同的发射和接收吗为了简单，但板板是毫无困难地讨论不同半径)、镁-，~的振动频率的发光，。总结了三倍的表达方式和N2 ~能忽略的流量速度低，因为这些变得微不足道的贡献。

The following are the expressionsfor the mean pressure set up at the detection plate and for the time of the signal toprogagate from the radiator to the detector:这里是1个公式,省略） where Re is the real part of the expression appearing within the braces, 0 is the density ofthe medium, vo is the amplitude of the vibrational velocity, c is the speed of sound in themedium, d2 = I +(r/zcos 8, z is the distance between the emitting and receiving plates, B is the angle between the axis of the acoustic channel andthe axis of the tube, r = vro/c, v is the flow speed of the fluid, d is thediameter of the pipe, m is the circular frequency, k is the wave number,where a is the radius of the plate (this is taken as the same for the emitting and receivingplates for simplicity, but there is no difficulty in discussing plates differ~mg in radii),,~ is the vibrational frequency of the emitting plate, andThe triple sums in the expressions for N~ and N2 may be neglected if the flow speed islow, since the contributions for these become negligible.

以下是表达式平均压力为定于检测板和为信号时间progagate从散热器到探测器：（这里是1个公式，省略）假如再是出现在大括号表达式的实部，0是密度中期，沃是速度的振动幅度，C是健全的速度中，D2中=我+的导向8，z是对之间的距离发射与接收板，B是声之间的通道轴角该管的轴，R =中心内大多分为/荤，v是流体的流动速度，，D是管道直径，m是圆频率，k是波数，的其中一盘是半径（这是为重点，同样的发射与接收为le简单板，但没有讨论板的困难，在半径不同毫克），，是发光板振动频率，和在N的表达式的三重总结和N2可以忽略，如果流速低，因为这些变得微不足道的贡献。

The detailed analyzed and simulating of focusing error signal of optical pickup based on oblique parallel plate glass was carried out. The new scheme for generating focusing error signal based double reflection plane BSP was proposed. As a result, the structure of optical pickup was simplified, and the cost of optical pickup was reduced. The scheme was not reported in domestic and international literature formerly. Now, author obtained the patent on this scheme.

作者对采用倾斜平板玻璃进行误差信号的提取方案进行了详细的理论分析和模拟，并提出采用双反射面BSP进行聚焦误差信号的提取，该方案可以简化光学读取头的结构，并降低光学读取头的成本，该方案未见国内外报道，目前已经获得专利。

Results (1) Osteitis and destruction of end-plate showed long T1 and long T2.(2) Anterior and lateral abscess had long T1 and long T2 presenting even and structure-less signal.(3) The intervertebral discs showed normal or only degeneration at the early stage, and destroyed at later stage.(4) With Gd-DTPA enhancement, fibrotic granulation around abscess and destroyed area was well demonstrated.(5) Abscess in the bone and/or paraspinal abscess, destruction of end-plate were the important evidence for early diagnosis.

结果 (1)椎体骨炎及终板破坏呈长T1长T2信号，(2)椎旁或椎前冷脓肿呈长T1长T2均匀无结构信号，且上下跨越范围较大，(3)早期椎间盘信号正常或只出现退变，晚期则被破坏，(4)Gd-DTPA增强扫描可清楚显示冷脓肿周围纤维肉芽组织及椎管内侵犯，(5)骨内小脓肿和/或椎旁脓肿、椎体终板破坏是MRI诊断早期脊柱结核的重要依据。

So we designed a adaptive synchronizing controller based on hereinbefore hardware environment: first a small magnitude reference signal r is outputted to system through the signal card (to ensure that the vibrating system works in a linear state), and this signal is sent to the moving coil of vibrator through the power amplifier, so vibration is produced through electromagnetic induction. Secondly the vibration signal can feedback to the data acquiring card in the servo system through the acceleration sensor on the Vibroseis reactor M〓 and the base-plate M〓, then the computer can get the current vibrating state y〓 of the coil of vibrator according to the feedback information from the data acquiring card, and give a real time comparing between the current state y〓 and the reference output y〓 of the set-in reference model with current reference input being r , then regulates the correlative controlling parameters according to the error e〓=y〓-y〓 till y〓→y〓, finally normal signal sweeping begins with a certain phase fixed. Meanwhile a synchronization signal for seismic signal record is sent to seismograph from synchronization signal outputting component in the Vibroseis system to perform the controlling process of synchronization of sweeping phases.

为此，我们基于以上的硬件环境设计了一个自适应同步控制器：首先通过信号发生卡对系统输出小幅度的参考信号r(从而保证振动系统工作处于线性状态)，信号通过前置放大器、功率放大器等送到激震器动圈，并通过电磁感应产生振动，振动信号通过可控震源激震器反应块M〓和基板M〓上的加速度传感器反馈给伺服系统中的数据采集卡，工控计算机根据采集卡的反馈信息，获取当前激震器动圈的振动状态y〓，并实时地将该状态与内置的参考模型在当前参考输入r下的参考输出y〓进行辨识，再将两者输出误差e〓＝y〓-y〓对系统的有关控制参数进行调整，直至y〓→y〓，最后在经过某一固定的相位后，开始信号的正常扫描过程，与此同时，由可控震源系统的同步信号输出部件向地震仪送出一地震信号记录同步信号，进而完成扫描相位同步控制过程。

The kernel of thecontrol system hardware is an industrial control PC, voltage AD, current AD anddigital input/output plates are equipped to respective signals collected, which collectand control main parameters of transmission assembly. For the convenience of wiringand signal modulating, a harness plate adapting to collection plate is configured.

测控系统的硬件以一台工业控制PC机为核心并根据采集信号的性质配置了电压-数字量转换板、电流-数字量转换板及数字量输入/输出板，对变速箱总成的主要参数进行采集和输入转速等的控制；为方便接线和信号调理，配备了与采集板对应的接线和调理接口板以及接线盒。

The disclosed stripline resonator comprises two parallel metal ground plates 4, an inner conductor 5 between two plates 4, a metal short-circuit board 6 connected to with two ends of plate 4, and two coupling loops 7 on proper position of connected part of plate 4 and conductor 5 for input/output of microwave signal.

一种带状线谐振器及微波薄膜材料电磁参数测试装置，属于微波测试技术领域。带状线谐振器包括金属接地板4、内导体5、金属短路板6和耦合环7等四个部分，所述两块相互平行的金属接地板4的两端分别与金属断路板6连接，内导体5处于两块金属接地板4的中间，其中一块金属接地板4与内导体5相连的上下方的适当位置具有两个耦合环7，以实现微波信号的输入和输出。

The system is based on optical heterodyne structure, and use half wave plate, quarter wave plate and polarization beam splitter to improve the intensity of Doppler signal and signal-noise-ratio.

系统采用了外差式纵向激光多普勒测量结构，利用1/2波片、1/4波片与偏振分光棱镜相结合及外差式参考光结构，有效地提高了多普勒信号的强度与信噪比。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失