查询词典 side effect

In the dissertation, the study on carbon fiber reinforced concrete andplain concrete has been reviewed. Then mechano-electric effect of CFRC and plainconcrete, its mechanisms, the interaction among mechano-electric effect,piezoresistivity and seebeck effect, the electrical circuit model of concrete based onmechano-electric effect, electromagnetic emission of concrete, the mathematicalmodel of mechano-electric effect are investigated. Also the converse effect ofmechano-electric effect of CFRC and plain concrete, that is, electromechanicaleffect, and the interaction between electromechanical effect and electrothermaleffect of CFRC are examined.

本文对碳纤维混凝土和素混凝土机敏性的国内外研究现状进行了全面的评述，在大量实验分析的基础上，系统地研究了碳纤维混凝土和素混凝土的力电机敏性，研究了力电效应机理、力电效应与其它效应(压阻效应、塞贝克效应等)的耦合关系、基于力电效应的混凝土电学模型、混凝土电磁发射现象、混凝土力电效应的数学模型等；论文同时对混凝土和素混凝土的电力效应、碳纤维混凝土电力效应与电热效应的耦合关系等进行了探讨；最后开展了基于力电效应的机敏混凝土结构应用研究。

This means that the alveolar bone at the lingual side contributed more effect on the mobility of incisor than that of the facial side. However, the effect of alveolar bone of the mesial side was closely to the distal side.

即上颚正中门齿在近心侧齿槽骨缺损与远心侧齿槽骨缺损时对牙齿动摇度的影响相当，但舌侧齿槽骨缺损对牙齿动摇度的影响却大於唇侧齿槽骨缺损。

There were a certain relationship between haemoconcentration and tess score（p.05）,tess score influence male sexual function.conclusion:within a certain chloropromazine ＆clozapine haemoconcentration,higher haemoconcentration,higher impairment to sexual function,there were significant relationship between haemoconcentration and sexual function;also severely side effect with the haemoconcentration higher,there were a certain relationship between haemoconcentration and side effect,side effect also influence male sexual function.

药物血浓度与tess评分呈现一定相关性（p.05），对性功能产生影响(p.05)。结论：氯丙嗪、氯氮平的药物在一定范围内血浓度越高，对男性性功能影响越大，呈现显著正相关；而药物的副反应随血药浓度递增而增大，显现出一定的正相关性，对性功能产生一定影响。

In the long run, the cumulative effect of inequality on investment is negative.（2） Inequality has moderate effect on education, and the cumulative effect is positive.（3） The effect of inequality on investment overweighs its effect on education, so inequality has a strong indirect effect on growth instantaneously. The effect turns positive and then weakly negative.

研究发现：（1）收入差距在即期对投资有非常强的负面影响，之后影响变为正，再逐渐下降至微弱的负，从长期来看，收入差距对投资的累积影响始终为负；（2）收入差距对教育的影响较弱，其累积影响始终为正；（3）由于投资对于经济增长的作用超过了教育，因此收入差距对于经济增长的间接影响主要来自于投资的渠道。

In the first section, the effect of sodium houttuyfonate on the level of lysozyme secreted by macrophages was first tested by bacteriolytic method; then the effect of sodium houttuyfonate on the level of tartaric acid resistant acid phosphatase produced in macrophages was investigated by analyzing the phenol generated in the reaction that was catalyzed by the enzyme; the third, the effect of sodium houttuyfonate on the phagocytic activity of macrophages was observed by microscopy; the forth, the effect of sodium houttuyfonate on the production of complement C4 from macrophages was tested by hemolytic method; the fifth, the effect of sodium houttuyfonate on the expression of C3b receptors on the surface of macrophages was analyzed by observing the formation percentage of zymosan wreath; the sixth, the effect of sodium houttuyfonate on the respiratory burst in macrophages was tested by flow cytometry; the seventh, the effect of sodium houttuyfonate on the production of IL-1α and IL-1β from macrophages was tested by ELISA method.

在这一章中，首先，采用溶菌法考察合成鱼腥草素对巨噬细胞分泌溶菌酶水平的影响；其次，采用游离酚法研究合成鱼腥草素对巨噬细胞产生的耐酒石酸酸性磷酸酶水平的影响；第三，采用显微镜观察法考察合成鱼腥草素对巨噬细胞吞噬功能的影响；第四，采用溶血法测定合成鱼腥草素对巨噬细胞产生的补体C4水平的影响；第五，采用酵母花环法检测合成鱼腥草素对巨噬细胞表面C3b受体水平的影响；第六，采用流式细胞术法观察合成鱼腥草素对巨噬细胞呼吸爆发的影响；第七，采用ELISA法探讨合成鱼腥草素对巨噬细胞产生IL-1α及IL-1β水平的影响。

After all of these six changes have been carried out on one side of the palate,the operated side becomes completely relaxed.It can be moved both posteriorly and medially to lengthen the side of the palate and to contact with the cleft margin of the non-operated side without tension.Obviously,there is no need to perform the same surgical maneuvers on the other side again.The cleft is then closed by layers.

手术时，在腭部的一侧作完改变的六项操作以后，手术侧的腭部即彻底松弛，可以充分后退，增加该侧腭部先天不足的长度，并随意向近中侧移动，与对侧的裂缘接触，不需要在对侧再作同样的手术操作，即可将裂隙缝合。

The head is slowly turned 90° toward the side where nystagmus is induced less intensely. Then the head is rotated 180° rapidly toward the opposite side. This article reports three cases of the ageotropic form of HC-BPPV that were cured by rapid head rotation. The three cases demonstrated that rapid head rotation was an effective maneuver to treat cupulolithiasis on the utricle side. It is recommended that rapid head rotation can be used for therapeutic diagnosis: If nystagmus subsides immediately after this maneuver, the diagnosis is cupulolithias is on utricle side. If nystagmus changes into the geotropic form, the diagnosis is cupulolithiasis on canal side or canalolithiasis in the anterior arm of horizontal semicircular canal. A repositioning maneuver for geotropic form can then be applied to treat these patients.

逆地眼振型水平半规管良性阵发位置性眩晕的3种耳石可能位置如下：水平半规管前臂的管耳石、管侧的顶帽沉石(canal side cupulo-lithias1s)与囊侧的顶帽沉石，本文报告3例以快速转头治疗逆地眼振型水平半规管良性阵发位置性眩晕成功的病例，显示快速转头法对囊侧的顶帽沉石具迅速有效的治疗效果，对於逆地眼振型水平半规管良性阵发位置性眩晕的治疗，作者建议先以快速转头作治疗性诊断，若病人马上复原，诊断为囊侧的顶帽沉石；若眼振转为向地型，则诊断为水平半规管前臂的管耳石或管侧的顶帽沉石，进一步再以向地型的耳石复位法治疗病人。

Based on 3D steady and incompressible N-S equation and k-ε turbulent model, the aerodynamic performance of three different design options of 160 km/h container flat wagon was analyzed and compared using finite volume method. The three design options are as follows: the first design option has no headwall and the side surface of side beam is flat; the second and the third both have headwall and high side beam, and the side surface of side beam of the second is obtuse, while the third is cambered.

基于三维、不可压、定常N-S方程和k-ε双方程湍流模型，采用有限体积法对3种不同设计方案在运行时速为160 km/h的集装箱专用平车在有、无横风情况下的气动性能进行分析与比较，其中：方案一的平车无端墙，侧梁侧面平直；方案二和三的平车均加有端墙，且侧梁加高、侧面形状分别为钝形和弧形。

Based on 3D steady and incompressible NS equation and kε turbulent model, the aerodynamic performance of three different design options of 160 km/h container flat wagon was analyzed and compared using finite volume method. The three design options are as follows: the first design option has no headwall and the side surface of side beam is flat; the second and the third both have headwall and high side beam, and the side surface of side beam of the second is obtuse, while the third is cambered.

摘 要：基于三维、不可压、定常 N S 方程和 k ε双方程湍流模型，采用有限体积法对3种不同设计方案在运行时速为160 km/h的集装箱专用平车在有、无横风情况下的气动性能进行分析与比较，其中：方案一的平车无端墙，侧梁侧面平直；方案二和三的平车均加有端墙，且侧梁加高、侧面形状分别为钝形和弧形。

A machine component comprising: an elongated base plate with side edges, a linear actuator assembly having two parts which can move away from and toward each other, first mounting means on said base plate, said mounting means supporting one part of said assembly, a slide plate rectangular in cross-section and having parallel straight side edges, two elongated guide members each having a rectangular slot adapted to slidingly receive the edge of the slide plate, each elongated guide member including a lowerpart and an upper part and means for securing them together, the lower part having means for attachment to the base plate, said rectangular slot having (1) a first side wall adjacent to and parallel with the base plate, said first side wall being definedby a surface of said lower part,(2) a second side wall defined by a surface of said upper part, and (3) a bottom wall defined by a surface of one of said upper and lower parts, the upper and lower parts having oblique mating surfaces such thatlongitudinal meovement of one part with respect to the other causes the parts to separate from or approach each other in a manner to change the width of said slot, and second mounting means establishing a connection between the slide plate and the other part of said assembly.

有一长条形底座与身边的边缘，一个线性驱动器装配有两个部分，可以离开，彼此之间，首批意味着在说底座、说安装方式支持之一说总成，一个矩形截面板、平行直边棱、两种细长的引导会员都有一个矩形槽适应slidingly收到边缘的细长板，每一个lowerpart引导会员包括一个上方和手段，确保他们在一起，下方附件的方式，在底座，说矩形槽有(1)第一次侧墙毗邻，平行底座，一边说：definedby墙表面说下方，(2)第二次侧墙表面的定义，并说上方(3)底壁由一个表面的上部和下部零件，说上部和下部阀部件表面的thatlongitudinal拥有斜meovement这样的一部分的原因部分可以分离或接近对方的方式来改变宽度的槽，第二次安装方式，建立连接板之间，另一部分说总成。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。