查询词典 si

The above facts indicated that silicon accumulation in the rice leaf sheath inside, the leaf surface and the sclerenchymatous cell, played the physical barrier role, delayed the hypha of sheath blight expansion.5、Analysing the physiological and biochemical mechanism of the resistance to rice sheath blight improved by silicon application in several respects.(1) After being inoculated with R.solani, O2 and POD activities disordered, CAT activities obviously declined. O2 producingvelocity in 91SP\'s leaves and leaf sheaths of Si+ rice plants were lower than those of Siriceplants, MDA content in leaves and leaf sheaths of Si+ rice plants were lower thanthose of Si- rice plants significantly in three days after inoculating, SOD、POD、CATactivities in leaf sheaths of Si+ rice plants were higher than those of Si- rice plantssignificantly in one day after inoculating, SOD、POD、CAT activities in leaves ofSi-treatment were higher than those of Si- rice plants significantly in three days afterinoculating. O2 producing velocity and MDA content in Lemont\'s leaves and leafsheaths of Si+ rice plants were lower than those of Si- rice plants significantly afterinoculating, and SOD、POD、CAT activities of Si+ rice plants were higher than those ofSi- rice plants significantly.

说明硅在水稻叶鞘内侧、叶表和厚壁细胞积累，起到了物理屏障的作用，延缓了纹枯病菌的扩展。5、阐明了施硅增强水稻抗纹枯病的生理生化机制(1)接种纹枯病菌后，两个水稻品种91SP和Lemont的叶鞘和叶片超氧阴离子自由基O2性紊乱，CAT活性明显下降；抗病品种91SP叶鞘和叶片施硅处理的O2产生速率小于缺硅处理，叶鞘和叶片MDA含量在接种第3 d后显著低于缺硅处理，叶鞘SOD、POD、CAT活性在接种1 d后一直显著高于缺硅处理，叶片SOD、POD、CAT活性在接种3 d后显著高于缺硅处理；感病品种Lemont叶鞘和叶片施硅处理的O2产生速率、MDA含量始终显著小于缺硅处理，SOD、POD、CAT活性始终显著大于缺硅处理。

The Molecular Interaction Volume Model is introduced for the prediction and fitting of the activities of liquid alloys Ni-Mg-Cu,Ni-Al-Si and Ni-Cu-Co in the ternary systems.

对Ni-Mg-Cu，Ni-Al-Si及Ni-Cu-Co三组三元系预测的总平均相对误差及最小的拟合总平均相对偏差分别为12.0%和9.0%，表明分子相互作用体积模型比较适用于这类液态合金的活度预测

Based on the FT-IR analysis of molecular sieve film on the cordierite supports, a shoulder peak at 1050cm-1 should be the vibration of out framework Si-O, and not strong interrelated with the size and shape of TS-1 crystal.

通过对堇青石上的分子筛涂层进行FT-IR分析，发现1050 cm-1处的肩峰是由分子筛骨架外的Si-O键振动所引起的，而与分子筛的晶粒大小和晶体形状关系不大。

Plasma assisted molecular beam epitaxy was employed to prepare ZnO thin films on Si(111) substrate.

在Si(111)衬底上利用等离子体辅助分子束外延生长氧化锌薄膜，研究了在不同衬底生长温度下(350～750℃)制备的ZnO薄膜的结构和光学性质。

The SiC films were grown by solid-source molecular beam epitaxy at different deposition rates on Si (111) substrate.

采用固源分子束外延生长技术，用不同的蒸发速率，在Si(111)衬底上生长SiC薄膜。

The intensity of NP peak of type-Ⅱ initailly increased with the increase of the excitation power and decreased thereafter. This is due to the electrons and the holes were localized in different space of typ-Ⅱ QW, then the band bending occurs when the carrier concentration increases with the power, NP peak shft to high energy. The electron transited to relaxed Si〓Ge〓 layer and combined with the localized holes radiatively.

型量子阱的NP峰随激发功率增加先增加后减小，这是由于在Ⅱ型量子阱中电子和空穴不在空间同一位置，较强激发功率下产生的高浓度载流子引起能带弯曲严重，NP峰向高能方向移动，到某一定程度时开始出现电子跃迁至弛豫Si〓Ge〓层与其中的空穴复合发光。

VCTS-KH560-Si was characterized by means of FTIR,TGA and gravimetric analysis.

然后将香草醛接枝壳聚糖作为反应的原料，制备键合硅胶固定相(VCTS-KH560-Si)，并用傅立叶变换红外光谱、热分析和质量分析法等手段进行表征，证明键合产物性质稳定。

The refractive index of the films fabricated on the Si(111) and fused quartz glass was measured and calculated by the ellipsometry and optical transmission spectra respectively.

用椭偏仪和透射光谱分别测量并计算了制备在Si（111）、石英玻璃基片上薄膜的折射率。

Influences of Sn and Si content on the mechanical properties of the alloys were ascertained.

探明了Sn、Si含量对合金力学性能的影响规律。

WSi2/Si multilayer Laue lens with 324 layers and a total thickness of 7.9 \mu m is successfully fabricated using direct current magnetron sputtering method.

Laue透镜外层理论衍射效率达到60%，聚焦分辨率达到10.5nm。利用直流磁控溅射成功制备了总层数为324、总厚度为7.9μm的WSi2/Si多层膜Laue透镜。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。