查询词典 show-ring

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

In the North Ordos basin the sandstone-type uranium deposits developing in the system of sandstone beds of sedimentary facies of braided river course in Midde Jurassic Series,at the same time it happen some show of ore:the alteration zone of chloritization,bleaching decoloration and carbouation of epigenetic alteration,which show of ore are immediate and indirect for uranium mineralizing process.

摘 要：发育于内蒙古鄂尔多斯盆地北部中侏罗统直罗组辫状河相杂砂岩体内的砂岩型铀矿，有一系列较为特殊的与放射性铀成矿有直接或间接关系的成矿地质现象：绿色化蚀变带、漂白退色化带、二次胶结钙化砂岩团块及钙化砂岩断续层与&钙化木&后生蚀变现象；在与铀矿化和与油气的关系认识上存在一定分歧。

Seen from the present study condition,the emotions of different valence load recruit partly overlapped brain areas;the studies on the recognition of facial expression show that different facial expressions activate different neural circuitries;the studies on induced emotions show that the anterior cingulated cortex seems to play a very important role in presenting experimentinduced emotions.

继James-Lange理论以后，Arnold，Lazzrus和Izard等又相继提出了不同的情绪理论，并且试图对情绪的中枢加工机制进行探讨和解释。但由于情绪本身的复杂性和方法学的限制，有关情绪的中枢加工过程和脑机制的探讨一直停留在较低的水平上。

The results show that the technical parameters and the concentration of sodium molybdate have obvious effect on the composition of the alloy. The crystal grain size is from 6.2 to 12.7 nm and changes with current density, temperature and the pH value of the electrolyte.The crystalline growth of the alloy accords with the model of three-dimensional growth. The surface morphology is mainly determined by the rate competitions between the growing direction of vertical surface and the expanding direction along the surface towards circumambient. The results of the X-ray data show the presence of the multiphase containing solid solution and intermetallic compound in the deposits. The deposit phases alter from the FeNi and FeMo solid solution to the FeNi and MoNi4structure at 3 A/dm2. The deposits internal stress increases linearly with the decrease of the grain size. The lattice parameter of the deposits are slightly distorted

结果表明：工艺条件和钼酸钠浓度对合金组成的影响较大；所得合金晶粒尺寸为6.2~12.7 nm，并随电流密度、温度和电镀液的pH值的改变而变化；合金的晶体生长符合晶核三维生长模型，镀层表面形貌由平行和垂直于基体的生长速度的相对大小决定；镀层物相为固溶体和金属间化合物的多相结构，当电流密度为3 A/dm2时，镀层物相由FeNi和FeMo固溶相转化为FeNi和

The results show that there are many differences in the static characteristics of the rotor in large gap annular flow and that in bearings and seals, and the wall friction coefficient changes circumferentially. The results also show that the wall roughness and the eccentricity ratio have considerable effects on the static characteristics in large gap annular flow.

实例计算结果表明：大间隙环流中转子与以灿承和密封为代表的小间隙环流中转子的静特性有很大同；壁面摩擦系数沿周向变化，同时转子和静子壁面粗糙度以及偏心率对大间隙环流中转子静特性有较大的影响。

At the end of the paper, the experimental results show that the MCMC algorithm of LVCE has a better result and can show the compactedness of data points clustering.

实验结果表明，LVCE 模型的MCMC 算法能够进行聚类集成并且达到良好的效果，同时可以体现数据聚类的紧密程度。

The earthquakes mainly show normal or strike-slip faults in Yajiang, North-triangle and west o f Chengdu-block areas, indicating that the vertical forces have been pl aying an important role in the source stress fields, while the earthquake mainly show reverse or strike-slip faults in Baoxing-Tianquan area, with the horizon tal compone nts of the principal pressure stress axis identical to the south-west directi on to which the shallow mass was moving.

雅江、 北三角和成都地块西部3个分区，地震破裂以正断层、走滑型为主，表明垂向作用力在震源应力场中发挥了不可忽视的作用宝兴天全地区的地震以逆断层、走滑型为主，其主压应力轴水平分量与浅层物质运移的南西方向一致。

Our calculated results show that the relative stability of the isomers depends on the level of theory used: in the framework of DFT, Au10 trends to form planar structures, while the MP2 calculations show that the three-dimensional isomers are energetically more favorable. Based on the present results, Au10 may be conjecturably a critical species of gold clusters which bridges the planar structures and three-dimensional ones.

计算结果表明Au10团簇异构体的相对稳定性明显依赖所使用的理论方法和泛函，密度泛函结果显示Au10倾向于采用平面结构，且不同的泛函给出异构体的相对稳定性次序也不相同，而MP2计算则显示三维空间结构的Au10团簇更稳定， Au10可能是金团簇从二维结构到三维结构演化的一个临界点。

Analytical results show that: Anode evaporation rate, which determines mostly the production rate of UFMP, is influenced by the many factors including electric parameters of arc, ambient conditions and material properties et al; Existence and increase of anode ejection can influence the production rate and property of UFMP; It is firstly found and investigated that surface connexity phenomenon of Al anode material. Analyses and calculation show that formation of anode spot and existence of self-magnetic field force play an important part in surface connexity process; Effects of cathode material on prepared UFMP is also experimentally studied and theoretically analysed. It shows that effect of the cathode is inconsiderable under the experimental conditions used in the study. At last, the experimental results found in part one are analysed and discussed in detail.

然后详细分析了电弧与电极间的相互作用过程，结果表明：决定超微粉产率的阳极材料蒸发率受许多因素影响，它主要与电弧电参量，环境条件及材料性质有关；阳极表面液滴喷溅的存在和加剧将严重地影响所制超微粉的产率和性质；首次发现和实验研究了Al阳极表面凸起现象，并对此现象进行了详细的理论分析和实际估算，认为阳极斑点的形成及自磁场作用力的存在在该过程中起着重用作用；实验研究和理论分析了阴极材料对所制超微粉的影响，认为在本文所用实验方法及条件下，阴极材料对粉的影响很小。

Judge a result to already was in Shenzhen at coming 7 days on June 1, 2008 eventually news network, abstruse one network is public show, fair show consentient, classics concerned department is authorized result of this bear the palm is significant.

终评结果已于2008年6月1日至7日在深圳新闻网、奥一网公示，公示无异议，经有关部门审定该获奖结果有效。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。