查询词典 shock pressure

The experiment results show that enstatite is transformed into the perovskite structure under the shock compression whereas the perovskite structure is transformed retrogressively into the single-chain structure during the process of pressure release.

对回收样品进行的X射线衍射分析结果表明：两发顽火辉石回收样品的主相均是单链状结构硅酸盐，而非钙钛矿结构；另外，回收样品中均未观察到氧化物SiO2 和(Mg0.92， Fe0.08)O的XRD特征谱线；两发MgO+SiO2回收样品中均观察到SiO2和镁橄榄石(Mg2SiO4)而没有氧化物MgO。

The vapour and plasma ignition times of the target are got based on the equation of heat conduction and cascade model. We suppose that the plasma is ignited when 210 generations of new electrons are born in vapour generation time. The influence of temperature on the thermodynamics and optics parameters of material also have been considered in the model. The resulting theory has good agreement with the experiment and overseas report. A blade method to measure the laser spot is given in this paper with validation and error analysis. The plasma threshold of metals in atmosphere and water ambients both are diagnosed with the light deflection and piezoelectric transducer. A Q-switched pulsed Nd:YAG laser operating at infrared (1064nm), visible(532nm) and ultraviolet (355nm) wavelengths has been used. Al、Fe、Cu are used as targets and get a similar results with both method. Theoretical and experimental analyses are applied on the influence of wavelength on the threshold have been done, both of which have shown that the plasma threshold of metals decrease as the laser wavelength increases; The plasma threshold of metals are higher in water than in air and the pressure of the shock wave in water is five times higher than in air.

从热传导方程和雪崩电离机制出发，假设当电子增值2~(10)倍时，考虑了温度对材料热力学和光学参数的影响时，得到了气化和等离子体点燃的时间，利用该模型进行计算得到的结果与国内外报道及自行通过实验测得的阈值基本一致；提出了利用刀刃法测量激光光斑面积的方法，并通过实验进行了验证和误差分析；利用光偏转装置和压电换能器分别对空气和水中金属等离子体点燃阈值进行了实验诊断，激光器均为调Q—YAG激光器(波长1064nm，532nm，355nm，脉宽10ns)，靶材分别为Al、Fe和Cu，两种测试方法得到的等离子体点燃阈值基本一致；本文从实验和理论计算两个方面讨论了波长对等离子体点燃阈值的影响，均得到了等离子体点燃阈值随着波长的增加而减小的结论；对空气中和水中不同环境下金属等离子体的点燃阈值进行了比较研究，得到了金属在水中的等离子体点燃阈值比空气中的大，且水中产生的冲击波的压强是空气中的5倍左右的结论。

Should check whether the wheel rim deformation; wheel has a horizontal deflection or radial swing; shock absorber has loose or worn; turned horizontal, the ball straight rod section, or has loose steering gear assembly; spring steel U - shaped bolt, the center clamping bolts loose or whether there is any damage; Caster is correct; tire pressure is correct

应检查车轮轮辋有否变形；车轮有否横向偏摆或径向摆动；减震器有否松动或磨损；转向横、直拉杆球节，或转向器装配有否松动；弹簧钢板的U形螺栓、中心夹紧螺栓是否有松动或损坏；后倾角是否正确；轮胎气压是否正确。

Should check whether the wheel rim deformation; wheel has a horizontal deflection or radial swing; shock absorber has loose or worn; turned horizontal the ball straight rod section or has loose steering gear assembly; spring steel U - shaped bolt the center clamping bolts loose or whether there is any damage; Caster is correct; tire pressure is correct

应检查车轮轮辋有否变形；车轮有否横向扁摆或径向摆动；减震器有否松动或磨损；转向横、直拉杆球节，或转向器装配有否松动；弹簧钢板的U形螺栓、中心夹紧螺栓是否有松动或败坏；后倾角是否正确；轮胎气压是否正确。

The article corrected the inexactitude conceptions of gravitational shock, swoon by low blood pressure when standing and swoon by blood vessel dilatation.

该文对"重力性休克"、"直立位低血压性晕厥"、"血管扩张性晕厥"这三个欠严谨的概念进行了必要的修正。

It is discovered by the test during initial stage of linear charge explosion that the main forces for fragmentation are the shock wave and the gas pressure.

试验发现条形药包爆炸初期，破裂的发展主要由冲击波和高压气体膨胀力驱动。

The capacitance is 4.1μF,initial voltage is 10kV,and interelectrode gap is 7mm.The measured pressure of the first and second shock wave is 1.55MPa and 0.55MPa respectively.

通过压力传感器测得放电所产生的冲击波和气泡首次回胀时产生的冲击波在离通道 0 3m处的峰值压力分别为 1 5 5MPa和 0 5 5MPa ，模拟计算所得的峰值压力分别为 1 0MPa和 0 3 8MPa ，两者基本相符。

Objective To investigate the effect of increased intra-abdominal pressure on organs after traumatic hemorrhagic shock in rats.

目的探讨创伤失血性休克后大量液体复苏引起腹腔压力升高对机体脏器功能的影响。

Calculate what forecasted the pressure coefficient of wing section surface as a result to distributing, the circumstance such as isopleth of the position of average rate section plane, shock wave, Mach number.

计算结果猜测了翼型表面的压力系数的分布、平均速度剖面、激波的位置、马赫数等值线等情况。

Resistance pure water system, 3-waste treatment system, and shock-proof working-table, and about 80 sets of micro-electrical-mechanical technical equipment are installed, including AMS200 ICP plasma etching system, ICP-2B etching machine, AWB04 bonding machine, MA6/BA6 Karlsus double-face photolithography machine/bonding machine, POLI-400 chemical-mechanical-polishing tool, WL2040 aluminum-wire press welder, OPTI CAOT 22i decktop precision spin coasting system, ZSH406 automatic dicing saw system, DQ-500 plasma photoresist-removing machine, HXS150S automatic centrifugal spinner, AXTRON MOCVD metal organic chemical vapor deposit system, 4470 micro-control 4-tube diffusing furnace, type 4371 LPCVD low pressure chemical vapor deposit system, OMICRON MBE molecular beam epitaxy system, JS-3X100B magnet-control spattering equipment, PECVD-2E plasma deposit apparatus, ZZSX500C electron-beam vapor equipment, JC500-3/D magnet-control spattering-coating machine, H63-14/ZM quartz-tube cleaning machine. Measurement instruments include OLS1100 Confocal Laser Scanning Microscope, DEKTAKIII Surface Profiler, D41-11A/ZN 4-probe resistance test instrument, Nikon L150 metallurgical microscope, and so on.

中心现有80多台各种微机电工艺设备，如AMS 200深硅等离子体刻蚀系统、ICP-2B刻蚀机、AWB04键合机、MA6/BA6 Karlsuss双面光刻机和键合机、POLI-400化学机械抛光机、WL2040铝丝压焊机、OPTI CAOT 22i喷涂胶机系统、ZSH406全自动划片机、DQ-500等离子去胶机、全自动清洗甩干机、AXTRON MOCVD金属有机物化学气相沉积系统、4470微控四管扩散炉、4371LPCVD低压化学沉积系统、OMICRON分子束外延系统、JS-3X100B磁控溅射台、PECVD-2E等离子淀积台、ZZSX500C电子束蒸发台、JC500-3/D磁控溅射镀膜机、石英管清洗机，以及多种常用测试仪器，如OLS1100激光共聚焦显微镜、DEKTAK-III台阶测量仪、D41-11A/ZN四探针电阻测试仪、Nikon L150金相显微镜等。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。