查询词典 shell plating

The boatswain store where the forward hydraulic machinery power pack is located, had water stain marks on the shell plating, indicating that the space had been port flooded with water.

放置前甲板液压机械电源组的甲板部物料间的壁板上有水渍，表明此处曾部分受水浸。

Half-round fender to be fitted to the shell plating from forward shoulders to the aft shoulders at upper deck level and 1.50 m below upper deck. In addition, half-round fender to be fitted in way of forecastle and poop at two levels to secure that no mooring rope touch the shell. The fender to be of pipe 150 mm x 15 mm with flat bar inside. Fenders to be well supported from backside.

在船壳板的上甲板和上甲板以下 1.50m 位置处，分别安装有从艏尖突至艉尖突的半圆形护舷木，同时在艏楼和艉楼的两个位置上应安装有半圆形护舷木以确保系泊缆绳不与船壳板接触，并直径为 150mm×15mm 钢管的护舷木内部带有扁钢，以便对护舷木从背部进行很好地支撑。

In way of hawse pipes, shell plating around bell mouth to be increased in thickness. Anchor pocket to be arranged.

JIANGSU EASTERN SHIPYARD 江苏东方造船有限公司 38 1100TEU 集装箱船建造规格书在锚链管的位置，应对喇叭口四周的船壳板增加厚度，并布置有锚穴。

It was further reported that the cargo of the lower hold had canted against the port side plating, leaving a space of about 1 to 2 meters on the starboard side between the cargo and side shell plating.

根据进一步的报告，底层舱的货物向左舱壁板倾斜，在右侧的货物与右舱壁板问留下1米至2米的空间。

The average wastage of the remaining shell plating and deck plating is about 20% of the original thickness.

其余船壳板和甲板板的平均耗蚀约为原厚度的 20%。

The hull body fractured and broken at about 1/3 of the length from the stem and in way, the shell plating, upper deck plating, inner bottom plating and internal structural members within the scope of about 10m torn or destroyed; the remaining shell plating, upper deck plating, inner bottom plating and internal structural members seriously indented and buckled or bent and deformed in different degrees.

船体从船首起约 1/3 处折裂破断，该处船壳板，上甲板，内底板，内部构件在约 10 米范围内撕裂或损毁；其余船壳板，上甲板，内底板，内部构件严重凹陷，皱折或不同程度上弯曲变形。

In addition, Builder and propeller manufacturer to determine pressure variations on shell plating in way of propeller well to ensure that scantlings of plating and frames are heavy enough to avoid local vibration.

此外，建造方和螺旋桨生产商应确定螺旋桨围阱处船体板的压力变化，从而使板和肋骨的结构具有足够的重量以避免局部振动。

Thus a point is reached where there will be no actual rupture of shell plating, but severe dishing of plating will occur over a large area.

因此在这种情况下虽然舰底壳板很可能并不会破裂，但却会造成大范围的凹陷。

It was further reported that the cargo of the lower hold had cant ed against the port side plating, leaving a space of about 1 to 2 meters on the starboard side between the cargo and side shell plating.

根据进一步的报告，底层舱的货物向左舱壁板倾斜，在右侧的货物与右舱壁板问留下1米至2米的空间。

Shell Plating, Fender 船壳板,护弦木 Shell plating to be of welded construction with longitudinal framing in upper and lower range for about 60 % of the ship's length and transverse framing in between.

船壳板为焊接式结构，并且在上部和下部的范围内带有纵向结构(范围约为60%的船长)，并在这些结构布置有横向的构件，同时在船体前部和船体后部布置有横向构件。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。