查询词典 shearing

In this model, not only natural convection that is caused by different vertical density, and the baffle effect of shearing stress caused by viscosity is considered, but also the effect of concentration distinction itself to leaky flow is considered

该模型不仅考虑了由于密度差引起的自然对流作用，粘滞性产生的切应力对水流运动的阻滞作用，还考虑了溶质浓度的差异对越流的影响。

With the increase of the grafting degree, the shearing stress and apparent viscosity increased, and the bonding strength increased as well.

当接枝率达到3.0%左右时与碳钢的粘接强度达到最大值，随后粘接强度不再随接枝率的增加而增加。

The finite element method is employed to analyze the shearing stress of the concrete bridge decks with waterproof layer.

应用有限元法，对设防水层的水泥混凝土桥桥面沥青铺装结构进行剪应力计算，分析了防水层的厚度、模量、泊松比、沥青混凝土铺装层厚度和模量等参数对结构层剪应力的影响，认为层间最大剪应力主要取决于面层厚度和防水层模量，相同的防水层模量通过增加面层厚度是降低层间剪应力的最有效手段。

And can also follow the magnitude of the direct stress and shearing stress ,the method can be used to effectively simulate the continuum cracking and sliding on the interface .

并且还可以根据所求正应力和剪应力的大小，很方便地模拟坝体层面的连续、滑移以及开裂等工作状态。

Although usually not critical ,the shearing stress on the cylindrical area where the flange joins the hub should be checked.

尽管，通常在法兰与~连接的圆柱面上的切应力并不是关键性的问题，但也应对其进行校核。

The project discussed influence of damp force to the parameter of MR damper and carried finite element analysis of MR flow field and shearing stress.

推导出Nano-MR阻尼器阻尼力的计算公式。讨论了阻尼器结构参数对阻尼特性的影响。

If we do not control, it will lose sensitiveo this paper put forward the distributing of shearing stress to the double

作用。若不加控制，会产生失敏。这里对双金属片中的剪应力分布提出见解，从而为控制剪应力大小

Objective To study the main causes of low cure rate of femoral neck fractures treated by traditional internal fixation,how to effectively eliminate the shearing stress after fracture.

目的探讨传统内固定手术治疗股骨颈骨折愈合率低的主要原因，如何有效的消除骨折后产生的剪切应力，将剪切应力转变为压应力以及增加股骨头的血供是保证骨折愈合的关键因素。

The main points of wall surface shearing stress cementing are as follows. The results of three type of cementation logging, e.g.

中文摘要：应用壁面剪应力固井解决了委内瑞拉Caracoles油田固井实践中存在的顶替效率问题。

For some calculating cases, it is analyzed that how the primary shearing stress and the average film thickness change during the whole course from the beginning to the end of meshing.

对部分算例，分别分析了一对轮齿从入齿到脱啮的整个啮合过程中最大主剪应力和平均油膜厚度的变化规律。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。