查询词典 shear force

The approximate structure of nonlinear action of climatic atmosphere and ocean is: the nonlinear action decreases usually with increasing latitude, which is related to the role of the Coriolis force in fluid motion; the nonlinear action changes with the anomalous cyclonic or anticyclonic circulation shear, for instance, when the strength of anomalous eastward zonal circulation is comparable to that of anomalous meridional circulation, the nonlinear action is the strongest; wind stress plus gradient forces enhance the nonlinear action, etc..

气候海洋与大气非线性作用的大致结构是：通常与科里奥利力对流体运动的规范作用有关，非线性作用随纬度增加而减弱。距平流场的切变结构及其沿经向与纬向上强度的比较直接改变气候大气和海洋的非线性作用(比如，向东的距平环流强度与经向环流强度相当时，非线性作用最强)，较强的外部驱动使非线性作用加大等等。

Then axil shear tractive force of the whole structure of imitate bridge was measured in each.

然后，按照随机的顺序，对模拟的金属翼板粘结桥模型逐一进行了整体结构的轴向剪切拉力测试。

Then the shear 、axial force and bending moment of governing sections of anti-seepage walls are studied.

在此基础上对防渗墙各截面的剪力、轴力和弯矩进行研究，提出了配筋方案。

Aiming at bottom roof caving and support impact problems induced with abrupt large scale caving upper roof in face 21303 of Daliuta mine, this paper put forward the motion parameter at roof caving and calculation formula of roof shear breaking force with the help of theorem of momentum, theorem of moment of momentum and D' Alembert principle. Roof caving process was simulated by Ansys Ls-DYNA program, and maxim impact force was got. The theoretical research outcomes in the paper were applied in face 21303 of Daliuta mine, and were accordant with actual observing status of roof caving process.

针对神东煤炭公司大柳塔煤矿活井21303综采工作面，上层采空区顶板突然大规模垮落对下层顶板及支架的突然冲击问题，文章采用动量定理、动量矩定理、达朗伯原理推出了顶板垮落瞬间的运动量及顶板切顶垮落所需要的剪力值计算公式，用ANSYS LS-DYNA程序对顶板垮落过程进行了数值计算，得到了最大冲击力，在大柳塔煤矿活井21303综采工作面对顶板垮落特征进行了实际观测和理论成果验证。

By the computation of program, data which concerned in engineering such as deflection of raft foundation, internal force of raft foundation, internal force of superstructure (Which include beam, columns and shear-wall) and the other useful data for structure design can be obtained. And this can provide guidance and advice for the relative engineering practice.

通过程序计算可以得出工程上关心的考虑与上部结构、地基共同作用的筏板基础的挠度、筏板基础内力、上部结构(包括上部各层梁、柱、剪力墙)内力等结构设计所需的指标，可为相关的具体工程实践提供指导及依据。

ACCORDING TO THE SYNTHETIC ANALYSIS OF STRESSESD STATE OF THE ROLLING SHEAR,THE EQUATION OF APPLIED FORCE OF THE SHEAR'S CRACK SHAFT WAS GIVEN,AND THE MOMENT ON EACH CRANK ARM OF THE CRANK SHAFT BE INDENTIFIED.

根据对滚切剪受力状况的综合分析，建立了滚切剪曲轴受力方程，并进一步确定了曲轴两个曲柄上的力矩和总的力矩，从而设计出曲轴的总体结构。

With the rapid development of the engineering actions in the highland with particular stratigraphic sequence, because of the buildings at the back of the sliding body and the cutting slope at the front, the pushing force of rock and soil in slope increased, but the anti-sliding force weakened. On the other hand, during the rainfall surface water immerged into the layer interface of the diatomite along the unloading cranny, resulting in the diatomite becoming soft after absorbing water and its shear strength lowered. At the time, the water level went up, the dynamic water pressure and uplift pressure increased, the anti-sliding force continued to reduce. Therewithal, the landslides occurred along sliding surfaces with small tilt angle.

在丘陵区此独特的层序地层近年来随着人类工程活动强度的增大，滑体后缘建筑，前缘切坡，造成下滑力增加，抗滑力减弱；另一方面在降雨的作用下，地表水体沿着卸荷裂隙通道浸入到下伏硅藻土层界面，硅藻土吸水软化，抗剪强度减弱，同时地下水水位上升，动水压力和扬压力加大，抗滑力进一步降低，于是产生了低倾角滑面滑坡。

The major advantage of PFC2D is the evolution regularity of microscopic fabric parameters including co-ordination number, contact normal, normal contact force, shear contact force, can be achieved together with the macroscopic liquefaction response. The micromechanism of sand liquefaction is further discussed.

颗粒流数值模拟的优点在于得到试样液化宏观力学表现的同时，通过不同循环加荷时刻试样内细观组构参量（包括配位数、接触法向分布、粒间法向接触力、粒间切向接触力）的演化规律，分析砂土液化过程中细观组构变化与宏观力学响应之间的内在联系，从而可进一步探讨砂土液化的细观力学机制。

This paper describs the requirements of testing members to be nominal, the precedure of exerting load upon the tension rod, specific cautions and the effect upon the construction, for the application of the shear type constant force tester to measure initial tensile force of the rod in the wharf construction for the Port of Tangshan .

阐述在唐山港码头施工中应用剪式恒力仪测定拉杆初拉力时对标定试件材料的要求、拉杆施力的过程和须注意的具体问题以及施工效果。

The rigid column base for steel of light-weight buildings with gabled frames is resisting larger moment M and shear V,and the axial force is relatively small,so the design for the shear resistance for column base is more restrict.

对于轻钢结构刚接柱脚，往往弯矩M和剪力V较大，而轴力N相对较小，对柱脚抗剪的设计要求更加严格。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。