查询词典 shear force

In this research, scrapples spray coating technology has been applied to replace the role of recoator. By the knowledge of no scraping, there is no shear force during layer additive process.

本研究中是利用雾化铺层技术取代使用刮板铺层的动作，而此方法就不会有剪切力影响快速原型系统在刮板铺层时的问题。

Shear force scanning near-field optical microscopy on biological materials is more critical to implement in liquid than in air because of viscous damping and sample softness.

基于剪切力的探针-试样间距控制扫描近场光学显微镜用于生物材料在液体中的成像比在空气中难得多。

This paper analyzes from the theories and engineering examples to review rationality of the different torsion effect indexes, such as relative torsion effectθr/u, shear force ratioλbetween torsion and translation, eccentric angle of torsion.

本文从理论分析和算例考证两个方面，考查相对扭转效应θr／u、扭转与平动引起的剪力比值λ和楼层偏心扭转角α等不同扭转效应指标的合理性，研究不同指标的影响因素及它们之间的内在联系。

Removal mechanism may include biological adsorption, electrostatic adsorption and chemical precipitation. Fluid shear force had some effect on removal process, which proved that the effect of fluid force chemistry existed.

结果表明：用活性污泥去除钙离子可以获得较好的效果，去除量可达19mg/g，并且去除速度很快，5min即可完成；且去除机理可能有生物吸附、静电吸附和化学沉淀；适当的剪切力可以加速吸附反应的进程，证实了流体力化学效应的的存在。

With a smooth inwall, the shear effect will be weaken for the reason of decrease of shear force.

内壁越光滑，物料越不易挂壁，物料层间的相对运动速度减小，剪切速度变慢。

These indicated that endothelial cells of the mural coronary artery are free from atherosclerosis due to higher shear stress caused by myocardial bridge. The intima of the section proximal to mural coronary artery was likely to be sclerosed due to the lower and oscillatory shear force.

提示 壁冠状动脉内皮细胞受到心肌桥压迫导致血流切变力增高产生适应性反应，对内皮细胞有保护作用，而其近段内皮细胞由于切变力较低容易被损伤，成为动脉粥样硬化发生的基础。

For the structure that the side-frusta is also used as retain wall,considering the side frusta fastened on the weir body,the plane stress is calculated at first. Then the moments,horizontal shear force and vertical force on the bottom of the retain wall are applied as fixate,and stress distribution on the weir body are calculated piecewise.

对于边墩兼作挡上墙结构，通常是将边墩视为固端于岩体上，先进行下端为固端的挡墙平面受力计算，再将挡墙下部的弯矩、水平剪力和垂直力作为集中外荷载进行堰体的应力计算，堰体也只能分段进行片面受力计算。

In this thesis, an effective analysis model, named "equivalent column" model, was proposed for the wall inside the RC frames, and consideration the wall can resist axis force, moment, and shear force. The "equivalent column" model can simulate the brick wall, the RC wall as well as the wing wall. The experimental and analytical results of the RC column, pure RC frame, RC frame in-filled with RC wall, RC frame in-filled with brick wall, RC frame in-filled with wing wall, and RC column repaired by using the steel wire cables and the carbon fiber reinforced plastics were compared in the thesis.

中文摘要本研究主要分析补强前后含墙RC构架之耐震行为，目的是希望能合理有效地分析建筑物之侧向力与位移曲线，以利后续作为耐震评估之用，并考量墙体具有承受轴力、弯矩与剪力之较高自由度行为，以「等值柱」模型模拟含砖墙与含RC墙构架以及「墙柱」模型模拟含RC翼墙构架之耐震行为，分别对国内实验数据及理论分析方法-极限软化桁架模型进行比对。

Misplacement of the shearing tool produces invalid bond shear failures, the shear force readings of which must be excluded from analysis.

因剪切刀头放置位置错误而产生的读数是无效的，不应供分析使用。

The principle of the hydraulic shear system, the change of the shear force in the steel bar cutting-off process, and the structure and action principle of the buffer of the cylinder were analyzed at first in the paper.

文中首先分析了液压剪切系统的原理、钢筋切断过程中剪切力的变化以及液压缸缓冲的结构和作用原理。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。