查询词典 shaft

Because of the connecting rod is one of dyadic engine of piston and main compression engine part, whose larger end hole and crank shaft link up , the small head hole links up by the wrist pin and the piston , whose effect is that the piston gas pressure is transmitted to the crank shaft , collect crank shaft gas in driving but setting a piston in motion to compress a cylinder.

因为液压是活塞式发动机和压缩机的主要零件之一，其大头孔与曲轴连接，小头孔通过活塞销与活塞连接，其作用是将活塞的气体压力传送给曲轴，又收曲轴驱动而带动活塞压缩汽缸中的气体。

Because of the connecting rod is one of dyadic engine of piston and main compression engine part, whose larger end hole and crank shaft link up , the small head hole links up by the wrist pin and the piston , whose effect is that the piston gas pressure is transmitted to the crank shaft , collect crank shaft gas in driving but setting a piston in motion to compress a cylinder. the intensity is high.

因为连杆是活塞式发动机和压缩机的主要零件之一，其大头孔与曲轴连接，小头孔通过活塞销与活塞连接，其作用是将活塞的气体压力传送给曲轴，又收曲轴驱动而带动活塞压缩汽缸中的气体。

"A slip joint consists of outside splines on one shaft and matching internal splines in the mating hollow shaft , the splines cause the two shaft s to rotate together But permitthe two to move endwise with each other."

伸缩花键由在传动轴上的外花键和与之相连的空心轴中对应的内花键组成。伸缩花键使两轴一起转动，也能使两轴相对移动。

These designing parameters include stiffness of epicyclical bearings, synthetic meshing stiffness of gears, stiffness of supporting bearing of out put shaft, mass of inner rack, meshing angle of gears, distance between inputting shaft and supporting shaft and input speed etc..

这些设计参数包括：行星轴承刚度、齿轮综合啮合刚度、输出轴支承轴承刚度、内齿板质量、齿轮啮合角、输入轴和支承轴间距及输入转速等，根据这些分析，可以提出改善三环传动动态性能的可能途径。

The feature of the shaft furnace-iron bath smelter charging carbon-bearing pellets is that partial off-gas of shaft furnace is mixed with gas from smelter and then put into shaft for preheating and pre-reduction. The optimum operational parameter is at the point of prereduction degree of 52% and post-combustion degree of 32% where the coal consumption is 750kg/tone-hot metal and oxygen consumption is 420Nm〓/tone-hot metal.(5) The systematic simulation of rotary hearth furnace-iron bath smeter is firstly formulated.

4本文建立的含碳球团竖炉—铁浴工艺流程模型的特点之一是竖炉炉顶出口煤气的一部分与铁浴煤气混合后，重新进入竖炉，本文报道的对系统部分出口物流返回反应器的非序贯式流程进行的系统模拟，为今后类似问题的模拟提供了参考，本工艺的最低消耗点的操作条件是：预还原度52％，二次燃烧率32％，这时的最低煤耗为750kg／tFe（中挥发份煤VM=19％），氧耗约420Nm〓／tFe，对应于预还原度30～70％的优化组合的二次燃烧率为32～13％。

The pressure roll cooperates with the building drum has a plurality of discs mutually slidable with respect to one another and on a shaft so as to extend radially with respect to the building drum, the discs being mutually uniformly shaped, and each disc having an interior part and an exterior ring surrounding the interior part and being rotatable about a ball bearing, the interior part having a recess whose sidewalls slide radially on the sidewalls of the shaft and whose length is greater than the corresponding size of the shaft.

压力辊合作与建立鼓有一个多元性的光碟slidable互相尊重，互相对竖井等，以延长呈辐射状与敬意，向建设鼓，碟片相互均匀状，每个圆盘有一个内部的一部分和一个外环周边内政部分，并正在旋转约球轴承，内政部分，有一个休会期间，其侧板滑动呈辐射状上侧板的竖井，其长度大于相应规模的竖井。

By using the boundary conditions of the statically indeterminate shaft with three fulcrums,the deflection curve square of the shaft is got;By utilizing the energy method to improve the calculation formula, the accurate first order critical speed of the statically indeterminate shaft with three fulcrums is obtained quickly.

通过满足三支点静不定轴的边界条件来求解基本方程，得到多跨静不定轴的挠曲线方程，并应用能量法改进了计算公式，快速准确地求得三支点静不定轴的一阶临界转速。

As above three condition can't be assure simultaneity,then Imput shaft and output shaft can't do instantaneous synchronization ,and no synchronization become more obvious along with fold angle of shaft's increase.

当上述三条件不能同时保证时，则输入轴和输出轴不能瞬时同步，随着轴折角的增大，不同步愈加明显。

The structure brief introduction the dense thick liquid pump of one stud of i-1b s series is formed by four parts electromotor , shaft coupling , pump and bases motive force joining in marriage usefulness uses y s series asynchronous electromotor of three-phase the shaft coupling uses the water pump with the paw mould elasticity shaft coupling the pump by the pump shell , become hollow inside axle and universal twists joints and winds axle , stud , bush and axle seal and package places and goes out the material mouth etc and forms , and the section of stud is the oval for round and bush section , and his interior surface is the duplexing spirals faces .

结构简介 i-1b系列单螺杆浓浆泵由电动机、联轴器、泵和底座四个部分组成。配用的动力采用y系列三相异步电动机。联轴器采用水泵用爪型弹性联轴器。泵由泵壳、空心轴、万向绞接头、绕轴、螺杆、衬套、轴封装置和出料口等组成，螺杆的断面为圆形、衬套断面为椭圆形，其内表面为双螺旋面。

For connecting the output shaft of the gear box to the rear axle,a ling shaft known as propeller shaft is used.

为把齿轮盒子的输出桥连结到后面的轮轴，鳕即是螺旋桨桥的桥被用。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。