查询词典 shaft

The location of the ball through the linear displacement sensor acquisition, controller position error calculated in accordance with the volume control to control the motor shaft angle, the angle of the control bar so that the stability ball to the target location.

小球的位置通过直线位移传感器采集，控制器根据位置误差计算控制量，控制电机轴的转角，从而控制横杆的角度，使小球稳定到目标位置。

According to the measured pressure data of the four-stroke small utility gasoline engine, the cyclical variations of the maximum pressure, the crank shaft angle at the maximum pressure, the mean indicated pressure and the largest pressure rise rate were analyzed. Meanwhile, the influences of ignition advance angle, load and rotation speed on cyclical variation were also investigated.

根据实测小型通用四冲程汽油机气缸压力，分析了最大爆发压力、最大爆发压力所对应曲轴转角、平均指示压力以及最大压力升高率等参数的循环波动特性，以及点火提前角、负荷和发动机转速对循环波动的影响。

Using laser Doppler effect , based on measurement of the rotate speed of single section , the speed difference of double sections is measured and integrated , then the torsion angle of rotating shaft on torque effect is got. The non2contact torque measurement is realized , and dynamic monitoring of rotary machine equipment is achieved.

利用激光多普勒效应，在单截面测量转轴转速的基础上，采用双截面测量转速差并积分得到转轴在扭矩作用下的扭转角，实现扭矩非接触测量，达到回转机械设备的动力监测的目的。

Integrating the rotational speed difference, the relative torsion angle of the two sections under the action of torque was obtained, so the rotating shaft torque was gotten.

同时，设计了实验系统并在扭矩实验平台进行了实验，实验结果表明，激光多普勒法与传统扭矩测量方法的相对误差小于0.2％，说明激光多普勒法具有较高的测量精度。

For example ,if the active part of a shaft is 40 in .1deg of torsional deflection would be permitted .In some applications ,the angle of twist must be smaller than this .

例如，如果活跃的一部分是40 。1deg轴扭转变形，将允许在某些应用场合，角的扭必须小于这个。

Generally speaking, the angle of twist should not exceed one degree in a shaft length equal to 20 diameters.

因此，轴应该有足够的刚度以防止支承轴承承受力过大。总而言之，在两个轴承支承之间，轴在每英尺长度上的弯曲变形应该超过0.01英寸。

The angular acceleration of a rotary shaft is one of the most important parameters for revolution mechanism, which is widely employed in practical applications.

转轴角加速度是旋转机构转动时的一项重要参数，旋转体的角加速度在实践中有着广泛和重要的应用。

Thus, angular displacement of this solid shaft tilted the spider to give appropriate cyclic pitch control.

因此，本实心轴角位移倾斜蜘蛛给予适当的循环音高控制。

Elephants in zoos and circuses are typically moved with a tool called an ankus, a nasty-looking wooden shaft with a metal hook protruding from the top.

动物园和马戏团里的象被一种叫做刺棒(顶部伸出一个金属钩的巢状木轴)的工具驱使，这种工具在保护区禁止使用。

The stress concentration factor and stress intensity factor of annularly notched shaft subjected to torsional load were given.

给出扭转载荷下环形缺口的应力集中系数和环形裂纹的应力强度因子。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。