查询词典 seminal fluid

Bellows Gate Valves However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。

However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。因此热力膨胀阀在变工况下供液量的调节方面需进一步改进。

A 3D two-fluid model is also built in order to describe more accurately the fluid flow on distillation trays by comparing the computational results of quasi-single phase mathematical model with of two-fluid mathematical model.

本文采用有限体积法及计算流体力学软件&STAR-CD&对单块板以及首次对全回流下的全塔流体流动、传质过程进行了计算，计算结果如下：1。

If the displaced fluid is thicker than the displacement fluid, the larger the difference is, the more the blending volume of displacement and displaced fluid is.

反之，顶替液的粘度越高两者的掺混量越少。因此，注水泥过程中前置液的粘度应介于钻井液和水泥浆的粘度之间。

This paper discusses the dynamic response of beams resting on fluid withthe general asymmetric deformations assuming that the fluid resistance is related to the velocity potential of the fluid.

本文讨论了置于液体表面上的梁在一般的非对称变形模式下的塑性动力响应问题。

In ALE formulation the fluid-structure interaction analysis becomes a three-field coupling problem of the fluid field、the solid field and the fluid dynamic mesh.

其次，流体N-S方程的求解有中间速度法的三步减为直接法的两步，提高了计算效率。

The following are main contents studied: A finite element method for Navier-Stokes equation with ALE formulation is considered and by combined with theNewmark method of numerical intergration a pressure correction scheme is obtained for the solution of the FE formulation of N-S equation. Because the incompressibility condition can be satisfied approximately in this scheme, the interpolation functions of elements can be equalorder for the velocity field and pressure field. In the ALE formulation the fluid-solid interaction analysis became a three-field coupling problem of the fluid field, the solid field and the fluid dynamic mesh. The properties and charactiristices of this three-field coupling problem are deeply discussed.

研究的主要内容有：主容器中流体大晃动是一种强非线性问题，文中研究了求解ALE描述的粘性流体N-S方程的有限元方法，以有利于大晃动自由液面的跟踪和流体大晃动中非线性现象的描述；并结合Newmark数值积分法推出了求解ALE型N-S方程的压力修正解法，由于这种解法可以近似满足不可压条件，因此可以采用速度场和压力场等阶插值的有限元离散格式，从而较好地解决了普遍采用的不等阶插值解法中，速度场和压力场数值精度不一致、程序编制不便等的不足。

Apart from the working limitations resulting from its structural property, the flat plate heat pipe carries out heat dissipation through the evaporation and condensation of the working fluid. Thus, if the working angle of the fluid is adverse to its backflow, the heat pipe will fail easily. Furthermore, not the orientations of all the heat sources are favorable to the functioning of the heat pipe. To compensate for this drawback, this research focuses primarily on the development of a composite structure which will reduce the effect of gravity on the working fluid. Generally speaking, the heat pipe is divided into three main categories: the groove type, sintered metal type and mesh screen type, as shown in Table 2. As far as capillary force is concerned, the sintered metal type and mesh screen type show better performance. As mentioned in R.

平板式热管除了因其结构特性而产生的工作极限之外，由于其作用乃是透过工作流体的蒸发及凝结进行散热，故若是其工作角度不利于液体之回流，便容易使热管失效，且并非所有之发热源都是位于有利于热管工作之位置，因此本研究之主要目的为设计一可减少重力对工作流体影响之复合式结构；一般而言，热管之结构大致可分为沟槽、烧结及网格三种(如表2所示)，其中烧结及网格结构有较佳之毛细力，在 R。

In this paper, the environment of tectonism occurrence, the similarities and differences of the subsurface fluid force and tectonic stress, and the influence of the subsurface fluid and fluid force on multi-forms of tectonism are analyzed first.

分析了地壳构造变动产生的环境、构造应力与流体力的异同性以及地下流体及流体力对多种形式的构造变动的影响。

The concentric tapered pipe/reducing socket is advantageous to the fluid flow, in changes the diameter time is small to the fluid fluid state's disturbance, therefore the gas and vertical mobility's liquid pipeline use concentric tapered pipe changes a diameter.

同心异径管/大小头有利于流体流动，在变径的时候对流体流态的干扰较小，因此气体和垂直流动的液体管道使用同心异径管变径。

These rules reflect some inherent feature of self and nonself, and they are the basic detection criterion of GECISM.

这些规则反映了"自我"和"非我"的内在特征，是GECISM进行"非我"检测的判据。

Until today, the media from China and the outside world still uses the term "Post 89". Regardless to whether it is for commercial gimmick or convenience, everybody still remember "Post 89", a term which carries a strong Cantonese accent.

时至今日，国内外艺术媒体还是在沿用&后八九&这个称谓，不管当初是为了商业噱头还是容易上口好记，反正大家现在是记住了&后八九&这个广东口音很重的词。