查询词典 seismic vertical

Because of human's head likes an ellipse with longer vertical axis and shorter horizontal axis, we set the position to be a candidate of vertex of minor axis if the vertical projection of vertical edge is high enough in order to speed-up the template matching for ellipse detection.

首先利用Sobel边缘侦测与连续影像相减，再将两者结果交集取出前景物像素；由於头部有类似垂直轴长水平轴短之椭圆的特性，因此将垂直边缘之垂直投影量较高的位置当作椭圆短轴的可能端点，以增进用样板比对做椭圆侦测的效能。

We used NCAR/NCEPT anew analyze data and the method of bilinearity insert to fix on profile distribution of several physical field in the air on observation point and the stream field of 700hPa. We primary discussed the possible mechanism to influence aerosol size distribution.The atmospheric condition of 1000hPa~700hPa level had great influence on aerosol size distribution, and influence on coarse particle mainly below 850hPa level. The horizontal wind velocity of 925hPa level is a primary gene which contributed to coarse particles in the air. Vorticity profile especially below 700hPa level is a key gene to influence diffuse and convergence of local aerosol. The air vertical motion velocity greatly influenced aggregation and remove of aerosol particles. The vertical distribution of air temperature mainly influenced vertical transportation of aerosol.

利用NCAR／NCEP逐日再分析资料，通过双线性插值方法，确定观测点上大气中几个物理量的廓线分布；及700hPa的流场，初步探讨了影响大气中气溶胶粒子谱分布的可能机制： 1000hPa～700hPa的大气状况对气溶胶粒子谱分布影响显著，对粗粒子气溶胶的影响显著的主要集中在850hPa以下；925hPa的水平风速是影响大气中粗粒子气溶胶的一个主要因子；涡度廓线(尤其是700hPa左右及以下的涡度廓线)是影响局地气溶胶的扩散的一个关键因子；大气的垂直运动速度对气溶胶的聚合及移出影响较大；大气温度的垂直分布主要影响气溶胶垂直输送。

The telephone distribution frame is composed by a plurality of vertical ''vertical column'' 8, each vertical column includes a plurality of electronic module block set collaterally along the telephone distribution frame.

电话配线架由大量的垂直"立柱"（8）组成，每个立柱包括大量的电子模块，并且沿配线架（2）并列地放置着。

Therefore, the moist potential vorticity analysis associated with the mesoscale convective system was researched in the paper, so as to reveal the moist potential characteristics of mesoscale convective system in typhoon circulation. The results showed that, during the generation stage, convective instability characterized by MPV1 was a favorable condition for forming MCS, while the vorticity which was caused by the slantwise isentropic surface and the vertical shear of the horizontal wind characterized by MPV2 was an inspiring mechanism. The specific process was that, the atmosphere exhibited the feature of strong convective instability at the low level of convection areas and the southeast areas, which included plenty of erratic energy. The slantwise ascended the stream transfer the erratic energy to northwest, where the stratification stability was small. As decreased, the cyclonic vorticity increased. On the other hand, the vorticity caused by the slantwise isentropic surface and the vertical shear of the horizontal wind inspired the release of convective instability and as a result that the MCS formed. During the development stage, the cyclonic vorticity increased quickly with the persistent decreasing of . Meanwhile, the inclination of isentropic linewas bigger than the absolute momentum line at middle level, which exhibited the feature of conditional symmetric instability , then the conditional symmetric instability was forced to release by the vorticity resulted from the slantwise isentropic surface and the vertical shear of horizontal wind, and the MCS developed.

结果表明，在对流形成阶段，MPV1即对流不稳定为MCS的形成提供背景不稳定条件，由MPV2即湿等熵面的倾斜和水平风的垂直切变而引起的涡旋发展作为强迫机制：MCS形成的区域及东南区域中低层是强对流不稳定层，蕴含丰富的不稳定能量，倾斜上升运动把对流不稳定区具有强不稳定能量的暖湿空气向西北中层的中性层结区输送，由于的减小，气旋性涡度增强，有利于形成对流，另一方面，由于湿等熵面倾斜和低空急流加强而引起的涡旋发展作为一种强迫机制激发对流不稳定能量得到释放，从而形成对流；在对流系统地发展阶段，由于低层的对流不稳定性进一步减弱，进一步减小，气旋性涡度进一步增强，有利于MCS的增强，中层等θe 线的倾斜度比绝对动量M 等值线的倾斜度大，对应有条件对称不稳定区域，满足条件对称不稳定条件，在湿等熵面倾斜和台风低空急流作用下引起的涡旋发展强迫对称不稳定能量释放，从而使得对流得以维持和加强。

The vertical stiffness decreases with shear deformation increase and the ratio of quantity of vertical deformation producing shear deformation and vertical stress is variable.

结果是随着剪切变形的增加，隔震橡胶支座的竖向刚度逐渐减小：由剪切变形和竖向压力产生的竖向沉降量的比例是不断变化的。

Mian colors achieving high speed single way rainbow and scrolling effect 0-100% mechanical linear dimming (tunable from full blanking to full opening effect) Mechanical linear DIMMER and 1-10 times/s high speed STROBE effect Horizontal 450°and vertical 250°scanning range, smooth scanning action and accurate orientation Precise adjustment on horizontal and vertical position Precise speed adjustment on horizontal and vertical position Pattern internal light rotating function,freely adjusting fast , low speed , clockwise and anticlockwise GOBO position adustment Automatic focusing function 3 Prism effect, prism colorwise and anticolorwise rotating Built-in over heat protection and high voltage protection 2 convection cooling-fan,optimize internal air duct way, heat elimination rapidely Compatible with DMX512 international digital singal PFC power factor compensation According to various kinds of safety standards, IP20 protect grades, The cable accords to the CE20/22 standard

PERFORMANCE TRAIT 8种主色彩，同时可作高速单向滚动效果 0-100%机械线性调光（可控制全遮光到全开光效果） 1-10次/秒超高速频闪调整效果水平540度，垂直250度扫描范围，动作平滑、流畅、定位准确水平、垂直运动位置可精确调整位置水平、垂直运动位置速度可调功能旋转图案可正反、快慢自由调节旋转图案角度可单独调整采用电子自动对焦，图案远近均清晰度可自由调整三棱镜及棱镜正、反自由旋转功能二只对流风扇致冷，内部优化风路设计，散热充分良好内置过热保护、触发高压保护接受DMX512国际标准数码信号 PFC功率因素补偿符合各种安全标准，IP20保护等级，电源线符合CE20/22标准

Then the pile-soil stress characteristics and stabilizing mechanism of the composite foundation are fully discussed. Based on the close analysis of the influence factors of the vertical bearing capacity, circular aperture extension theory is employed to establish the computing formulas for the pile vertical stress and the foundation vertical bearing capacity, respectively. Moreover, with analyzing the features of the calculation parameters such as materials of gunite mortar, jet pressure, diameter of the jet pipe, pile length, pile layout, a design theory for chemical churning pile composite foundation is proposed. Then, the variation of the pipe deformation with loads, the deformation coordination of pile and soil are studied. And methods to decide pile-soil stress ratio and the compressive modulus are developed. Meanwhile, the corresponding design method and the design parameters are proposed. In addition, studies for construction technique and quality detection of the chemical churning pile composite foundation are presented.

在此基础上深入探讨了旋喷桩的桩土受力特性及其复合地基的加固机理，从影响旋喷桩复合地基竖向承载力的因素入手，基于圆孔扩张理论给出了桩体竖向应力及旋喷桩复合地基的竖向承载力计算公式；通过对喷射浆液、喷射压力选取、喷射直径估算、桩长及桩位设计等各种计算参数的深入分析和研究，提出了一套相应的旋喷桩复合地基设计计算方法；通过计算分析，深入探讨了旋喷桩复合地基变形随荷载变化规律、桩和桩间土变形协调关系、桩土应力比及复合地基压缩模量的确定，并提出相应的设计方法和修正参数；此外，结合工程应用，对旋喷桩复合地基的施工技术及其现场质量检测方法进行了较全面的探讨。

The peak of the bulge accorded with the vertical line through the posterior convexity of superior articular surface of atlas. The superimpose rate of the vertical line with the M line were 48% to left and 65% to right. The surplus existed in l～2mm to lateral of M line. The exit point of screw was the median point of vertical line on the anterior cortex of lateral mass. The superimpose rate of BB line the line linked with the

寰椎后结节中点及上关节突后凸尖下的骨质弧形隆起的顶点可作为寰椎椎弓根螺钉进钉点的准确标志，上关节突后凸尖及横突尖可作为寰椎椎弓根进钉点的大体标志；沿寰椎椎弓根轴线进钉较为安全，内倾17°，仰角变异大，出钉参照前结节顶点；椎动脉沟中外的厚度及进钉点处寰椎后弓的高度是寰椎椎弓根螺钉固定的主要限制性因素。

Time results could be concluded as follows: 1 During the sunshine period, the vertical distribution of external surface temperature on different orientations of buildings differs from one another, and the max discrepancy of vertical temperature appears on the external surface of west oriented wall, whose max differences of the vertical temperature are above 2℃ and the standard deviation of the temperature is above 0.6℃; 2 Most of the time from 2 p.m.

通过一段时间内对某栋典型多层板楼建筑外微气候相关参数的监测，其如下：1）在太阳强辐射时间内，不同朝向的外墙外表面温度随高度分布的情况不同，西向外墙表面温度随高度变化幅度最大，其外表面垂直温度的最大温差一般可在2℃以上，标准偏差约在0.6℃以上；2）多数时间内（主要为下午2点左右至次日凌晨），西墙外表面温度以1层最高；3）建筑热外表面可产生诱导上升热气流。

Both motor car and each trailer of HST were modeled as a multi-rigid-body system with two suspensions, and LVT was modeled as an assembly of track segment elements with 24 degrees of freedom. The vertical vibration matrix equation of the system was established on the basis of the principle of the total potential energy with stationary value in elastic system dynamics and the rule of "set-in-right-position" for formulating system matrixes, and then Wilson-θ numerical integration method was used to solve the problem. The dynamic responses of the system were calculated when the train runs at the speed of 200 km/h. And the effects of vertical stiffness of rail fastener and block pad on vertical vibration responses of the system were investigated.

其原理是：将高速列车的动车和拖车模拟为具有二系悬挂的多刚体系统；将弹性支承块式无碴轨道模拟为具有24个自由度的轨段单元的集合；基于弹性系统动力学总势能不变值原理及形成系统矩阵的"对号入座"法则，建立此系统竖向振动矩阵方程，并采用Wilson-θ数值积分法求解，计算速度为200 km/h时此系统竖向动力响应，研究轨道刚度对此系统竖向振动响应的影响规律。

"Yes, now you can give yourself airs," she said, you have got what you wanted.

"对了，您现在高兴了，"她说道，这是您所期待的。

Then the LORD said to me: Rebel Israel is inwardly more just than traitorous Judah.

上主于是对我说：＂失节的以色列比失信的犹大，更显得正义。