查询词典 seed-grain

Starch has gelatinization effect in hot water, elevatory and amylaceous grain is easier when temperature burst, the degree of polymerization that brings about starch is reduced, the opposite element quantity of amylaceous grain is reduced, as the change of amylaceous grain, the package that iodine and starch fashion adds up to content color to also can produce a series of change.

淀粉在热水中具有糊化功能，温度时升高淀粉颗粒更轻易破裂，导致淀粉的聚合度降低，淀粉颗粒的相对分子量减小，随着淀粉颗粒的变化，碘和淀粉形成的包合物颜色也会发生一系列变化。

In this paper, several texture techniques, such as hot processing, oriented consolidation of anisometric particles, templated grain growth, reactive templated grain growth and multi-layer grain growth techniques, and along with their development and applications to Lead-free piezoceramics, are reviewed.

本文综述了几种常用的织构化工艺，包括热处理技术、非等轴粒子取向固化技术、模板晶粒生长技术、反应模板晶粒生长技术和多层晶粒生长法的发展与应用，并详细讨论了每一种工艺对陶瓷微结构和织构化生长机制的影响。

The result showed that toughness of coarse-grain zone in X70 grade steel pipe HAZ was weak.Coarse grain,granular bainite,high binate and other unbalance low temperature variation result in quantity increasing. In addition to,impact toughness of coarse grain zone decrease with the t8/5 increasing.

结果表明：粗晶区是X70级管线钢热影响区中韧性较差的区域，粗晶区韧性恶化主要是晶粒粗化以及粒状贝氏体、上贝氏体等非平衡低温转变产物数量增多造成的，且粗晶区的冲击韧性随着 t8/5 的增加而降低。

The amount of H2 released from olivine increases rapidly with decreasing grain size of the crushed sample and orthopyroxene and clinopyroxene show the optimal grain size for H2 release with decreasing grain size of the crushed sample.

在幔源矿物的流体组分中含有一定数量的H2，这些H2在地球演化过程及地幔动力体系中起着十分重要的作用，其在幔源矿物中的赋存状态具重要的研究价值。

The composition of TB6 alloy ingots after heat treatment then water colling and air colling was analyzed. The results show that the segregation in the grain boundary is more serious than the segregation in the grain both in air cooled ingot and quenching ingot, the composition in grain boundary are not uniform; the segregation of Fe is more serious than the segregation of Al and V; the composition in air cooled ingot and quenching ingot are more uniform than the composition in cast; the segregation in quenching ingot is lowest, quenching can reduce the segregation.

中文摘要：对热处理之后进行水冷与空冷的TB6合金铸锭进行了成分分析，对两种热处理所得结果进行分析，发现无论铸态还是空冷与水冷之后的试样，晶界偏析总比晶内严重，而且晶界处的成分分布很不均匀；Fe元素的偏析要比Al元素与V元素的偏析严重；空冷与水冷后的试样，各个元素分布较原始态的更加均匀，各测试点之间的差距减小；水冷之后的试样成分分布更理想，比空冷的效果好，水冷可以显著改善TB6合金铸锭偏析现象。

Experimental results show that rapid solidification technology can remarkably optimize Mg-Zn-Nd alloy's microstructure and property,there are three zones of fine grain zone,columnar grain zone and equiaxial grain zone in ribbon's solidification structure,which reserve structure character of cast-magnesium alloy.

结果表明：快速凝固技术可显著优化Mg-Zn-Nd合金的组织结构与性能；薄带的凝固组织分为细晶区、柱状晶区、等轴晶区三个区域，保留了铸态凝固组织的特性；快速凝固技术的细晶强化和固溶强化可明显改善Mg-Zn-Nd合金的强度与塑性。

The recent development of grain refining, interaction between Si and grain refiners, and grain refining mechanisms in hypoeutectic Al-Si casting alloys are overviewed in this paper.

仅对Al-Si铸造合金细化处理的最新进展、Si与晶粒细化剂的交互作用和晶粒细化机理进行综合评述。

The result makes clear, xiang Di decides size of grain of course complex Mg2 jumbly (100~600 Nm), grain of retrorse titrate complex slants small (200 Nm controls), distributinging concentration of diameter of bead of grain of two-way titrate complex (400 Nm controls).

结果表明，正向滴定过程合成的Mg2晶粒大小混杂(100~600 nm)，反向滴定合成的晶粒偏小(200 nm左右)，双向滴定合成的晶粒粒径分布集中(400 nm左右)。

Twelve density treatments were designed, which were 225×10^4 (T1), 300×10^4 (T2), 375×10^4 (T3), 450×10^4 (T4), 525×10^4 (T5), 600×10^4 (T6), 675×10^4 (T7), 750×10^4 (T8), 825×10^4 (T9), 900×10^4 (T10), 975×10^4 (T11) and 1050×10^4 (T12) basic plants/hm^2. Grain dry matter growing process and grain filling rate could be described by Richards Model and Monodic Quadratic Equation, and the grain filling parameters could be calculated from Richards model fomula. Relation analysis, stepwise regression analysis and path analysis were made by DPS, SPSS software.

方法设计了225万(T1)、300万(T2)、375万(T3)、450万(T4)、525万(T5)、600万(T6)、675万(T7)、750万(T8)、825万(T9)、900万(T10)、975万(T11)、1050万(T12)基本苗／hm^2共12个密度处理，分别运用Richards模型、一元二次方程模拟了冬小麦籽粒干物质增长过程及籽粒灌浆速率随花后时间的变化情况，并对所建立的Richards模型进行推导得到基本的灌浆参数，通过SPSS、DPS软件对籽粒灌浆参数与千粒重进行相关、逐步回归及以及通径分析。

But the grain growth, grain semiconduction and grain boundary insulation were influenced by many factors, such as the type and contents of dopants, sintering temperature and so on. Therefore, in this thesis the effect of the restore sintering temperature, the oxygenize temperature, the donor and acceptor dopant on the dielectric and varistor properties of devices were studied. With SEM, the microstructure of SrTiO3-based double function ceramic was analyzed.

而晶粒生长、晶粒半导化和晶界绝缘化受到多种因素的影响，诸如杂质的种类和含量、烧成温度等，因此本论文研究了还原烧成温度、中温氧化温度、施主和受主掺杂等对SrTiO_3基陶瓷的压敏和介电性能的影响，并借助于SEM分析对SrTiO_3基双功能陶瓷的微观结构进行了分析。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。