查询词典 sea-surface

To overcome the drawbacks in the weight and cost of the antenna with the corrugated soft surface, a new patch antenna with patch rings is designed. Its weight is about 1/4 less than the antenna with the corrugated soft surface and it is inexpensive. Good experimental results are obtained. The radiation pattern of the antenna is more rotationally symmetric, and a more reduction on the sidelobe levels of the antenna is achieved as compared to the antenna with the corrugated soft surface. In conclusion, in the present thesis both theoretical and experimental research works have been carried out intensively on patch antennas based on photonic-bandgap structures.

为了克服皱褶软表面天线份量重，加工费用贵等缺点，我们对空气介质的皱褶圆环结构软表面天线进行了改进，将周期分布的皱褶圆环平面化，并保持结构的软表面特性，设计出了一种新的平面圆环结构的软表面天线并进行了实验研究，加工的平面圆环结构天线比皱褶圆环结构天线重量减轻了约1/4，加工费用大大降低，所取得的实验结果显示，该平面圆环结构软表面天线的方向图的轴对称性得到了改善，在俯仰角从0°～-90°的范围内天线H面的波束与E面重合，与皱褶圆环结构相比，天线的旁瓣和背瓣受到了更大的抑制，E面方向图上+120°方向的旁瓣被明显削弱。

Because aluminum surface unlike composite aluminum foil paper and aucilisty paper, it has a certain amount of micro-small holes, moisture penetration into the paper can be, so it is important for moisture control; and aim at aluminum sheet piling up cannot be printed matter is exhausted, the card with a maximum of 3000, because aluminum is not wear-resistant surface, piling up too much will crush India face about note aluminized paper storage time should not be too long, it is best not more than two months, for a long time will be subdivisionof with the back of the paper, the following is issued on picking flowers; by the aluminum sheet business card printing and membership card making bearing in mind that when you heat curing temperatures not too high, too high a temperature can affect aluminum surface which flowers, and too hot paper antishrinking rise on deformation is too big to post processing.

因为真空镀铝纸的暗地不像不简单铝箔纸和PET纸，它有必定的微洪不小孔，水不合可以不合泌出纸，所以不差水不合的把持不一不合重给；③真空镀铝纸的印品堆放不克不及太众，卡纸最众不超功3000张，因为真空镀铝纸的暗地不耐磨，堆放太众会压伤印背；④夺纲真空镀铝纸的不领取工夫不给太不幼，最好不给超功两个日，因为工夫不幼了暗地会跟纸的背后粘连，变成纸背发不攒；⑤真空镀铝纸的制卡和会员卡制息给夺纲冷固化时温量不给太矮，温量矮了会感化真空镀铝纸的暗地，使其变不攒，而且太冷纸张缩涨变形太不小，不差后增工感化很不小。

Guanine can quench the phthalhydrazidylazoacetylacetone's ECL in acid medium, and the linear concentration range of guanine relative to the ECL intensity is from 2.0×10~(-6) to 1.0×10~(-5) mol/L.The mechanism of phthalhydrazidylazoacetylacetone's ECL on the surface of ITO glass has been discussed according the experimental phenomenon.The phenomenon of ITO self-luminescence has also been studied.It has been found that the machanism of phthalhydrazidylazoacetylacetone on the surface of ITO in different medium is dissimilarity. The phenomenon of ITO self-luminescence may be caused by the interaction of the active oxygen element and ITO's surface.

鸟嘌呤在弱酸性介质中3-(1-乙酰丙酮偶氮)苯二甲酰肼的电化学发光具有显著的淬灭作用，2.0×10~(-6)～1.0×10~(-5) mol/L浓度范围内，电化学发光强度与鸟嘌呤的浓度成良好的线性关系根据相关试验现象对3-(1-乙酰丙酮偶氮)苯二甲酰肼在氧化铟锡玻璃电极上的电化学发光机理进行了初步探讨，并对氧化铟锡玻璃电极自身发光现象进行了研究，研究发现在不同酸度环境中，3-(1-乙酰丙酮偶氮)苯二甲酰肼在氧化铟锡玻璃电极上电化学发光的机理是显著不同的；ITO自身发光可能是由活性氧系分子与ITO镀膜玻璃电极表面相作用引起的。

The VCL method and the displacement method are used to calculate the Stress Intensity Factors of semi-elliptical surface crack at the root of pipe screws, on the basis of which a simplified calculating model for screws contact is put forward so as to analyse the fracture intensity for oil drill pipe screw coupling. For the semi-elliptical surface crack with different shape and deep ratio at the root of female and male screws and the corner of male flange, the SIF has been studied systemically under inter-pressure, tension, bend and torsion loads and the approximate formulas encluding the structure parameters of oil drill pipe screw coupling, deep ratio and the shape parameters of surface crack are developed.

对工程实际中的多种石油钻杆接头螺纹连接件，就公螺纹齿根、母螺纹齿根、公螺纹台阶转角处存在的不同形状、不同厚度比的半椭圆表面裂纹，在拉伸、内压、弯曲、扭转多种载荷作用下的应力强度因子作了系统研究，在大量有限元计算基础上，建立了包含接头结构参数、裂纹形状、厚度比在内的近似计算公式。

Results The length between posterior superior iliac spine and greater trochanter of femur was (15.2±1.35) cm for man and (11.5±0.72) cm for woman; the length between posterior superior iliac spine and ischial tuberosity was (13.3±0.87) cm in man and (10.3±0.49) cm in woman; the length between greater trochanter of femur and ischial tuberosity was (8.3±0.83) cm in man and (5.5±0.61) cm in woman; the surface projection where the superior gluteal artery, superior gluteal veins and superior gluteal nerve permeate the suprapitiform foramen was below the point 0～6.8 mm between 2/5 superior and middle trunk from posterior superior iliac spine to greater trochanter of femur; the surface projection where the inferior gluteal artery, inferior gluteal veins and inferior gluteal nerve permeate the infrapiriform foramen was at the point between 2/5 inferior and middle trunk from posterior superior iliac spine to ischial tuberosity; the surface projection where sciatic nerve permeate the infrapiriform foramen was at the point between 3/5 lateral and middle trunk from ischial tuberosity to greater trochanter of femur.

结果臀三角各边的长度分别为：髂后上棘转子间距，男(15.2±1.35) cm，女(11.5±0.72) cm；髂后上棘结节间距，男(13.3±0.87) cm，女(10.3±0.49) cm；转子结节间距，男(8.3±0.83) cm，女(5.5±0.61) cm。臀上动脉、静脉、神经出入梨状肌上孔的体表投影在髂后上棘与大转子连线中、上2/5交界处向下0～6.8 mm内；臀下动脉、静脉、神经出入梨状肌下孔处的体表投影在髂后上棘与坐骨结节连线中、下2/5处；坐骨神经出梨状肌下孔处的体表投影在坐骨结节与大转子连线中外3/5处。

Companies are equipped with advanced production equipment and inspection equipment: CNC Center CNC computer lathes, CNC Sodick wire-cutting, CNC EDM, professional inner circle grinding, precision cylindrical grinding, precision surface grinding and other advanced processing equipment and optical projection Yee, hardness tester, surface sand blasting machine, marking machine, such as the surface of high-precision testing equipment.

公司配备有先进的生产设备和检验设备：CNC中心拥有CNC电脑车床、沙迪克CNC线切割、CNC电火花成型机、专业内圆磨、精密外圆磨、精密平面磨等先进加工设备及光学投影议、硬度计、表面喷砂机、表面打标机等高精度检测设备。

The products has high-precision horizontal spindle surface grinders with rectangular table, high-precision horizontal spindle surface grindes with rotary table, vertical spindle surface grinders with rotary table, CNC corrugated roller profile grinder, CNC creep-feed profile grinders and floor-type guideway grinder etc.

公司的产品有高精度卧轴矩台平面磨床、高精度卧轴圆台平面磨床、立轴圆台平面磨床、数控瓦楞辊成形磨床、数控圆弧剪刃成形磨床、数控强力成形磨床和导轨磨床等80多个品种规格的技术储备，其中有填补国内空白的产品和荣获国家银奖的产品。

The shading network plugged into the eMicroscope surface shader creates the look of a bump mapped surface that interpolates between black and light blue depending on how much each point on the surface is facing towards the camera.

这个材质网络插入一个电子显微镜的表面材质创建一个凹凸表面的外观，依靠每个点在面对摄像机的方向来在黑色和淡蓝色之间进行插值。

On the basis of analyzing the theory of the modeling of the propeller surface, this paper transforms the section data given by design to the data in Descartes coordinates. Interpolates the section data to get enough data and fits the blade surface with the least square method. A perfect C2 blade surface can be obtained by adjusting the deviation weight and fairing weight. According to the cylinder rough, two rough cut methods are preferred.

本论文在深入分析螺旋桨曲面成型原理的基础上，将设计时给定的桨叶曲面的切面数据转化为笛卡尔坐标系中的坐标，利用B样条方法对截面数据点插值并加密，得到足够的数据点，进而利用最小二乘法拟合出桨叶曲面，通过调整偏离权和光顺权得到了理想的二阶连续的桨叶曲面。

A new surface humid index indicating the buck effect of climate change was constructed and used to analyze the surface soil dry/wet state of China. In recent 47-year, the result was compared with those of traditional methods, the necessary study on relationship between soil moisture, surface humid index and precipitation was made.

提出一个可表征气候变化总体效应的地表湿润指数，以该指数为基础，分析了近四十七年来中国区域地表的干湿状况，并与传统的方法的结果进行了对比分析，同时对土壤湿度、湿润指数及降水的关系做了必要的探索。

He paid $5,000 for this cupcake.

他我这个纸杯蛋糕花了5000美元。

I mean, if you want to, that is

我的意思是，如果你们想吃的话。