查询词典 sea-surface

Based on the analysis of the characteristics of triangular Bezier surface construction and surface/plane intersection, in chapter 4, the author puts forward a construction method of surface/plane intersection curves.

第四章针对三角Bezier曲面的构造特性以及平面与三角曲面求交的特点，提出了一种任意截面曲线的保形构造方法。

At 135 mm depth and 0.28 m/sec speed, the biomimetic furrow opener surface with UHMWPE tubular ridges recorded 0.62 kN and 0.17 kW, while at 135 mm depth and 0.92 m/sec speed, the values were 0.91 kN and 0.82 kW. The experimental values of resistance force and power for the conventional surface furrow opener at 100 mm depth, and 0.28 m/sec speed were 0.72 kN and 0.20 kW, while at 100 mm depth and 0.92 m/sec speed, the values were 1.11 kN and 1.0 kW. At 135 mm depth and 0.28 m/sec speed, the conventional surface furrow opener recorded 0.93 kN and 0.25 kW, while at 135 mm depth and 0.92 m/sec speed, the values were 1.50 kN and 1.35 kW.

试验测试结果：当耕深100 mm和耕作速度0.28 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为0.72kN和0.20kW；当耕深100 mm和耕作速度0.92 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为1.11kN 和1.0kW；当耕深135 mm和耕作速度0.28 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为0.93kN和0.25kW；而当耕深135 mm和耕作速度0.92 m/sec时，实测的普通表面开沟器的土壤阻力和动力消耗分别为1.5kN和1.35kW。

The predicted values of resistance force and power for the conventional surface furrow opener at 100 mm depth and 0.28 m/sec speed were0.51 kN and0.14kW, while at 100 mm depth and 0.92 m/sec the values were0.98kN and0.88kW. At 135 mm depth and 0.28 m/sec speed, the conventional surface furrow opener recorded 0.70 kN and 0.20 kW, while at 135 mm and 0.92 m/sec speed, the values were 1.40 kN and 1.26 kW. The predicted values of resistance force and power for the biomimetic furrow opener surface with UHMWPE tubular section ridges at 100 mm depth and 0.28 m/sec speed were 0.45 kN and 0.12kW, while at 100 mm depth and 0.92 m/sec speed, the values were 0.73kN and 0.66 kW.

对于超高分子量聚乙烯材料仿生脊型非光滑结构表面，当耕深100 mm和耕作速度0.28 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.45kN和0.12kW；当耕深100 mm和耕作速度0.92 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.73kN和0.66kW；当耕深135 mm和耕作速度0.28 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.62kN和0.17kW；而当耕深135 mm和耕作速度0.92 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.91kN和0.82kW。

According to the request of construction features, processing spot, size precision, surface roughness and productivity that diesel engine air cylinder, sets the machine tool for single location horizontal type modular machine tool. Considered to the factor of the size precision, surface roughness, scrap removes and productivity and so on of the work piece, selects the Hard alloy not grind type surface milling cutter.

根据柴油机气缸体的结构特点、加工部位、尺寸精度、表面粗糙度及生产率等要求，确定该机床为单工位卧式组合机床；考虑工件尺寸精度，表面粗糙度，切屑的排除及生产率等因素，选用硬质合金不重磨式面铣刀；根据工件的尺寸、特点及其材料选择切削用量；然后，再经过切削用量来确定组合机床的通用部件；最后进行组合机床的总体设计。

The research on bound rubber and reinforcing effect of mineral filler showed that there are four kind of interactions between filler and rubber matrix in uncured mix The unbounded rubber on the surface of filler will solve in organic solvent The rubber bounded by stronger physical or chemical interaction with filler will dissolve in organic solvent The bound rubber on the surface of filler by different extent acid-base interactions will solve in basic organic solvent The bound rubber on the surface of filler by chemical action (no acid-base type) will dissolve in basic organic solvent

结合橡胶和增强作用的研究表明，在混炼胶中，硅橡胶与矿物填料的作用形式有四种。没有联结在矿物表面的非结合橡胶和仅靠物理吸附联结在填料表面的硅橡胶将溶解于有机溶剂；与填料有较强相互作用的硅橡胶不溶于有机溶剂；通过不同层次的酸碱作用联接在矿物表面的硅橡胶将溶解于碱性有机溶剂；与填料有牢固化学结合的硅橡胶不溶于碱性有机溶剂。

According to the case of billet heating in a regenerative type heating furnace, the temperature distributing of billet about upper surface, undersurface and center surface in length and width is studied by computational fluid dynamicsin this article, and the questions of billet such as different temperature of upper surface and undersurface, the higher temperature of foursquare margin and the lower temperature of tapping orifice are put forward.

中文摘要：借助CFD仿真手段，模拟蓄热式加热炉内钢坯加热的实际状况，研究了钢坯长度、宽度方向上下表面和中心温度的温度分布，提出钢坯存在上下温差、四角边缘温度高和靠近出钢口钢坯温度低等问题。

The thickness of the ice cover on the wall surface heat transfer is greater than the thickness of it on the air heat transfer form. The thickness of the ice cover on the wall surface heat transfer along the way changes slowly, but it on the air heat transfer along the way changes significantly. Reducing the entrance velocity, lowering the wall surface or air temperature, the formation of the thickness of the ice cover will increase; in the 3D circumstances, The thickness of the ice cover was relatively uniform in the import of the U-turn model, the ice cover was gradual accumulation in the convex bank when the stream traversed the import of the U-turn model, the thickness of the ice cover in the convex bank was significantly bigger than the thickness in the concave bank. The temperature field under the ice cover tends to be complex because of the existence of the secondary flows. The temperature in the convex bank is greater than it in the concave bank. Compared with the data from experiments, the laws in the numerical simulation are similar with them in the experiments

模拟结果显示：二维情况下，运用壁面传热形成的冰盖厚度大于运用空气传热形成的冰盖厚度，壁面传热形成的冰盖厚度沿程变化缓慢，而空气传热形成的冰盖厚度沿程变化明显，减小入口流速，降低壁面或空气温度等，形成冰盖的厚度都会增大；三维情况下，弯道入口处凸、凹岸形成的冰盖厚度基本相同，进入弯道后，凸岸形成的冰盖厚度逐渐增大，而凹岸的冰盖厚度逐渐减小，受横向环流的影响，冰盖下水流的温度场趋向复杂，并且凸岸的温度小于凹岸的温度；与实验室实验所得数据相比较，数值模拟研究得到的规律基本符合实验规律。

It is shown that polystyrene has been grafted on the surface of nmSiO2 particles and the grafting ratio is about 40%. The surface of nmSiO2 could be treated effectively by KH570in absolute ethanol at 25℃, 48h. The nmSiO2-g-PSt unpurified by toluene appear microsphere in which nmSiO2 particles are contained, whereas the purified one appear internet formed by many pieces. The grafting ratio of PSt on nmSiO2 surface could be influenced obviously by dispersion agents content and agitation speed, whereas the morphology of nmSiO2-g-PSt purified is rarely changed.

结果表明：常温下在无水乙醇介质中处理48h以上可获得良好的硅烷处理效果；PSt已接枝包覆于nmSiO2表面，接枝率约40%；经甲苯洗涤前nmSiO2-g-PSt呈多粒子包覆微球状，洗涤后呈单粒子包覆网状结构；分散剂用量、搅拌速度改变对接枝率有影响，但对包覆形态影响不大。

Protect your Cell Phone's LCD screen against dust and scratches and eliminate glare Designed for perfect fit with the LCD screen Offers tough, durable, transparent surface while keeping the LCD screen clean and unscratched Attaches smoothly with self-adhering surface; leaves no residue when removed Features 99% UV Protection: Reduces eye strain caused by the LCD screen Anti-Scratch Film: thickest and most durable 99% Transparent: unmatched clarity Washable and Reusable: Never need to buy another screen protector again Silicone Adhesive Coating: No glue residue when removed Ultra Smooth Surface: Enhance the experience and utilization of touch screen and stylus features Includes Reusable Screen Protector Lint-free Cleaning Cloth Accessory ONLY.

保护您的手机的液晶显示屏对灰尘和划痕，消除眩光专为完美配合液晶屏幕提供坚韧，耐久，透明的表面，同时保持液晶屏幕清洁和刮痕使节顺利与自我坚持表面；留下任何残留物时，删除功能99％紫外线防护：减少眼睛疲劳引起的液晶屏幕防划伤薄膜：最厚，最持久的99％，透明：无与伦比的清晰可清洗和重复使用：永远不需要再购买另一屏幕保护有机矽粘合剂涂料：无残留胶时取消超光滑表面：加强经验和利用触摸屏和手写笔功能，包括可重复使用的屏幕保护林特免费清洁布配件只。

At present,the rate laws and reaction mechanisms of pyrite oxidation,pyrite and chalcopyrite formation,uraninite and magnetite dissolution in aqueous solutions are mainly studied,and it is discovered that (1)oxidation rate of pyrite controlled by surface reaction assume fractional dependence on Fe3+ and O2 molalities in acid solutions;(2)Pyrite cannot nucleate directly from solutions below 300 ℃,it can only form initially through sulfidation of a FeS precursor. The rate equation of reaction between FeS and H2S to form pyrite is of the second order;(3)Chalcopyrite is formed by reactions of pyrrhotite or pyrite with Cu2+,the former proceeds via a series of mediate metastable phases of Cu-Fe sulfide,whereas the rate equation of the latter is apparently of the first order which is controlled by surface reaction;(4)The nonlinear behavior of magnetite dissolution at acid pH can be represented by a shrinking core model coupling with surface reaction and diffusion transport.

目前主要研究了水溶液中黄铁矿氧化、黄铁矿和黄铜矿形成、晶质铀矿和磁铁矿溶解的速率定律和反应机理，发现：(1)酸性溶液中黄铁矿的氧化速率对Fe3+和O2浓度呈分数依赖并受表面反应的控制；(2)低于300 ℃时黄铁矿不能从溶液中直接成核，而需初始地通过FeS先驱物的硫化生成，FeS与H2S反应形成黄铁矿的速率方程为二级；(3)磁黄铁矿或黄铁矿与Cu2+反应均可形成黄铜矿，前者经历了一系列准稳的Cu-Fe硫化物的中间物，后者的速率方程为表观一级并受表面反应的控制；(4)酸性pH时磁铁矿的非线性溶解行为可采用表面反应扩散输运耦合的收缩核模型来描述。

He paid $5,000 for this cupcake.

他我这个纸杯蛋糕花了5000美元。

I mean, if you want to, that is

我的意思是，如果你们想吃的话。