查询词典 scattering angle

Based the above research, we chosen 48 cephalometric radiographs of skeletal classⅢocclusion (18-39 years old, ANB4°) and measured with computer assistant Delaire cephalometric analysis. The data were deal with ANOVA analysis through SAS9.0 statistical software. The research divided the cranio-maxillo-facial hard tissue structure feature of skeletal classⅢinto four classifications through Delaire cephalometric analysis including hypo-divergent, hyper-divergent, maxilla normal and glenoid fossa retrocession, nine parameters of four groups have significantly variability through ANOVA analysis(P.05),for example, anterior cranial base angle, sphenoidal angle, percentage of craniospinal area to cranial depth ,percentage of craniofacial area to cranial depth and so on.

在上述研究的基础上，首先选取48例骨性Ⅲ类错牙合畸形患者(18-39岁，ANB角4°)应用Delaire头影测量分析法进行测量，经SAS9.0行ANOVA分析，将骨性Ⅲ类错牙合畸形区分为低角型、高角型、上颌正常型和关节窝后移型四组，四组均数ANOVA分析发现九项分析指标的均数差异均有统计学意义(P.05)，如蝶鞍角、前颅基底角、颅面区比和颅颈区比。

The presence of hyperpneumatization of the frontal sinus concerns with the angle from the line between the junctional point and attachment point of cribriform plate to horizontal line, with the more large angle, the more high rate of frontal gasification, and the more deep olfactory fossa.

额窦高度气化与眶板垂直切线与前颅底交点，这点与中鼻甲骨质筛板附着点的连线与水平线夹角的大小有关，这个夹角越大额窦高度气化发生的几率越大、同时嗅凹也较深。

Analytic branch amount and branch angle are right produce can influence discovery: Mi Qian is planted increase of number of branch of? of You of that a pavilion or house on a terrace of joyous ǖ of Сざ sew, produce can reduce somewhat, think branch well should not seek overmuch branch amount, with 2~3 branch is advisable; branch angle increases, the yield of much branch well also can increase, but addition extent decrescent.

分析分支数目和分支角度对产能的影响发现：在总分支长度一定的情况下，分支数目增多，产能略有降低，认为分支井不应追求过多的分支数目，以2~3个分支为宜；分支角度增大，多分支井的产能也增大，但增加的幅度变小。

Result shows that the baffle of burner has very little influence on the total resistance characteristic; both the speed of rich side and lean side are affected by the angle of burner as a whole, furthermore, the lean side is influenced more greatly; the separation performance could be enhanced with the increase of burner's angle and the best separation effect could be acquired when the three baffles are dissymmetrically arranged.

结果表明，燃烧器挡板角度的调整对燃烧器的总体阻力特性影响很小；燃烧器挡板偏转对于燃烧器整体以及浓淡两侧的气流速度都有一定的影响，且对淡侧影响较大；燃烧器的浓淡分离效果随挡板偏角的增加而显著增加，且三挡板非对称布置的浓淡分离效果最好。

Through the study of the effect of contact angle on heat transfer in dropwise condensation, it has been demonstrated that an optimum contact angle in dropwise condensation exists from the view of heat transfer.

通过接触角对滴状冷凝传热影响的理论研究，从传热学角度证明了滴状冷凝过程中最佳接触角的存在。

From the theoretical angle, to analyze and summarize the morbility reason of Senile Osteoporosis, to approach the effect of the flavone of rhizome drynaria on the lipidision of marrow stroma cell, as well as the senescence and apoptosis of osteoblast through the experimental study; from the clinical angle, to observe the clinical effect of the flavone of rhizome drynania on Senile Osteoporosis, to supply scientific theory basis for clinical application.

从理论角度分析总结老年性骨质疏松症的发病原因，并通过实验研究探讨骨碎补总黄酮对骨髓基质细胞脂质化的影响，以及对成骨细胞衰变和凋亡的影响，从临床角度观察其治疗老年性骨质疏松症的效果，为临床应用提供科学理论依据。

By measuring the point features to obtain the orientation of the bone and by adding compesated cutting path, results shows that the angle error between the connection of Femoral and Tebial mechanical axis is 2.44 degree and the angle error is 0.75 degree in epicondylar axis, which met the error in practical requirement for total knee replacement surgery.

在本论文中已完成实物设计制作，最后以Saw bone作为切割实验，利用量测点取特徵点得其骨头方位并加入补偿值调整切割路径，其结果股骨和胫骨之连线与机械轴误差为2.44°、epicondylar axis角度误差为0.75°，以目前实验误差已可符合实际膝关节手术之要求。

The horizontal and vertical first derivatives of magnetic anomalies of an infinite cylinder are calculated by the cosine transform method, in which the maximum errors are -0.28 nT/m and 0.47nT/m, respectively and the percent errors are generally within -3.57%~3.27% and -1.94%~1.88%, respectively except several data of the boundary and part are bigger because of remains of Gibbus effect. The calculating curve and theoretical curve are approximately coincident, and there is no influence by effective magnetic dip angle in computing. But the errors with the Fourier transform method are -10.62nT/m and 14.42nT/m, there is large departure between the calculating curve and theoretical curve and evident influence by effective magnetic dip angle in computing.

利用余弦变换法计算的无限长水平圆柱体磁异常水平和垂向一阶导数的最大误差分别为-0.28nT/m、0.47nT/m；水平一阶导数的误差一般在-3.57%~3.27%之间，垂向一阶导数的误差一般在-1.94%~1.88%之间；计算的磁异常一阶导数值与理论值大致重合，而且不受有效磁化倾角的影响而Fourier变换法计算的水平和垂向一阶导数最大误差分别为-10.62nT/m、14.42nT/m，计算曲线与理论曲线偏离大，受磁化倾角的影响也较大。

The company has about 700 employees, the factory covers an area of about 15,000 square meters, plant area of 20,000 square meters to over the past few years development, already have a certain scale, the printing workshop of existing four-color Heidelberg presses, Mitsubishi four-color, five-color presses, Akiyama four-color printing presses, two-color Heidelberg presses, single-color machine, the entire computer paper cutter, plate-making equipment group; printed paper mounting after the workshop has a fully automatic machines, semi-automatic on the mounted machine , automatic water-based UV machine, fully automatic UV machine, polishing machine, pressure-ray machine, laminating machine, automatic rolling box machine, semi-automatic folder gluer and other equipment: fine line between many existing automatically be on the white plastic plastic machine, all-purpose adhesive on the glue machine, beer machine, cutter, sawing machine, grinding machine, gong machine, towel angle machine, tipping machine, sewing machine, angle cutter, portable drilling machine, wait until the equipment corns machine.

公司现有职工约700人，厂区占地面积约15000平方米，厂房使用面积20000平方米，以过几年来的发展，已拥有一定的规模，印刷车间现有海德堡四色印刷机，三菱四色、五色印刷机，秋山四色印刷机、海德堡双色印刷机、单色机、全电脑裁纸机、制版设备一批；印后车间拥有全自动裱纸机、半自动对裱机、全自动水性UV机、全自动UV机、上光机、压光机、覆膜机、全自动轧盒机、半自动糊盒机等设备：精品国间现有自动流水线多条，白胶上胶机、万能胶上胶机、啤机、切纸机、锯床、打磨机、锣机、巾角机、烫金机、针车、切角机、笔记本打孔机、鸡眼机等到设备。

As KKД-500 gyratory crusher has large nip angle,linear steep crushing chamber profile,different throughputs of cross sections along the chamber height,it has poor crushing performance and short liner service life.Based on the structural analysis of the original crushing chamber,in the design principle of variable nip angle,the curve equations for moving cone lining and the fixed cone lining were setup by multi-stage fitted curves.

针对KKД-500旋回破碎机大啮角、直线陡锥破碎腔型，沿破碎腔高度各个截面的通过能力不尽相同，其破碎性能差，衬板使用寿命短的情况，在分析原旋回破碎腔型结构的基础上，按照变啮角设计原则，采用多段二次拟合曲线分别建立动锥衬板和定锥衬板曲线方程，利用计算机绘制衬板曲线，确定衬板结构，并优化破碎腔型。

Diabetes is a social disease that affects several million people worldwide.

糖尿病是一个社会性疾病，全世界有数百万人罹患此病。

I'll call you on Friday to see if we can reschedule our luncheon meeting at your convenience.

我星期五会给您打电话在您方便的时候我们重新安排我们的午餐约会。