查询词典 scattering angle

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

The main technical parameters which decide the movement speed are the ankle angle of the support leg, the horizontal velocity, the hip angle and the support leg's hip joint angle, knee angle and the former support distance at the moment of contact, and the latter leg's hip joint angle, the upper arm's movement scope, the support leg's knee angle, the swing knee's angle, the support leg's hip angle at landing phase, and the ankle angle, the support leg's hip angle, the swing velocity of the former leg, the hip angle of the swing leg and the angle of the landing knee at the pushing phase.

我国优秀男子百米途中跑着地瞬间对动作速度起主要贡献的技术指标是：支撑腿的踝关节角、着地瞬间脚的水平速度、大腿夹角及支撑腿的髋角、膝角和前支撑距离；垂直缓冲瞬间是摆动腿髋关节角、上臂前摆幅度、支撑腿和摆动腿膝关节角、支撑腿髋关节角；后蹬瞬间是踝关节角、支撑腿髋关节角、大腿前摆角速度、摆动腿的髋角及支撑腿膝角。

Drift electron mobility, the Hall factor and Hall mobility in GaN are calculated according to Mattiessen's rule as a function of temperature for carrier concentrations with the compensation ration as a parameter on the basis of taking into account the individual average scattering momentum relaxation time of four scattering mechanisms, namely, ionized impurity scattering, polar mode optical scattering, acoustic piezoelectric scattering and acoustic phonon deformation potential scattering which have an effect on electron mobility of GaN.

考虑了对纤锌矿型氮化镓低场电子输运影响最为显著的4种散射机制－电离杂质散射，极化光学波散射，声学波压电散射和声学声子形变势散射的单个平均动量驰豫时间，采用Mattiessen's rule计算了不同补偿率以及不同载流子浓度条件下，氮化镓电子漂移迁移率，霍耳因子以及霍耳迁移率随温度的变化。

Based on the Lorentz-Mie theory, the single scattering characteristics of multi-dispersed spherical and multi-layered spherical particles are studied. The extinction coefficients, scattering coefficients, single albedos, single scattering phase functions and asymmetry factors of different clouds are presented. Numerical results for single scattering of spherical and non-spherical particles are obtained in the approximation of geometrical optics. The single scattering phase matrixes of non-spherical aerosols are calculated by using the T matrix method.

基于洛伦茨-米理论研究了服从一定尺寸分布的球形和多层球形粒子的单次散射特性，计算了各种不同类型云层的消光系数、散射系数、单次散射反照率、单次散射相函数以及不对称因子；利用几何光学方法计算了球形、非球形粒子的单次散射特性；利用T矩阵方法计算了非球形气溶胶的单次散射相矩阵。

Initially the following measures are taken for association of the angle positions to physical reflectors, and for determination of the position of the vehicle (10): i at least three angle values with a suitable distribution over the search sector is selected, ii the angle values are associated to reflectors and a position is determined for the vehicle on the basis of the known position of the assumed reflectors, iii if the vehicle position determined in this way is within a certain part of the transport area the other angle values are associated to reflectors, iv for each angle value, existing deviation is determined between detected angle values and angle values expected between the vehicle position and known reflectors, v the measures taken are repeated for each possible combination of selected angle values.

最初使用下列步骤使这些角位与反射器关联以便确定车辆（10）的位置：i）在该搜索扇形上选择至少三个合适分布的角度值，ii）使各角度值与各反射器关联，根据假设反射器的已知位置确定车辆的位置，iii）如果如此确定的车辆位置在该运输区的某一部分中，则使其他角度值与反射器关联，iv）对于每一角度值，确定所检测角度值与车辆位置与己知反射器之间预期角度值之间的偏差，v）对于所选择的角度值的每一种可能组合反复进行这些步骤。

A method is provided for panoramic video stabilization by using an angle sensor, which comprises the following steps of (1) obtaining an initial rotation angle by using the collecting unit of the angle sensor before video capturing;(2) allowing the angle sensor to work synchronously with a video capturing device, and obtaining the rotation angle data of each frame of captured panoramic video;(3) if the video capturing device jitters or rotates, calculating the difference between the rotation angle of the current video frame and the initial rotation angle;(4) correcting the current video frame by using the calculated difference in rotation angle, thereby implementing the video stabilization of the panoramic video capturing device.

一种利用角度传感器纠正全景视频采集抖动的方法，其步骤为：(1)在视频采集前，先使用角度信息采集单元获取一个初始旋转角度信息；(2)在视频采集过程中，角度传感器与视频采集装置同步运动，每采一帧全景视频都获取所采这帧的旋转角度信息；(3)如果全景视频采集设备发生抖动或旋转，计算出当前所采的视频帧的旋转角度信息与初始旋转角度信息的差值；(4)利用这个旋转角度信息的差值对当前所采的视频帧进行纠正，实现全景视频采集设备视频抖动的处理。

But the value of H angle is smaller than class I malocclusion . Campared with the data of class II malocclusion , for class III malocclusion there are significant differences in LsL , LiL , lower lip angle of inclination , mentolabial sulcus angle , H angle , upper lower lip angle , Ns-Sn-Ls . For class III malocclusion the value of LsL is shoter than class II malocclusion , but the value of LiL is longer than class II malocclusion . The value of lower lip angle of inclination , mentolabial sulcus angle , upper lower lip angle is bigger than class II malocclusion .

安氏Ⅱ类错合患者与安氏Ⅲ类错合患者相比，在上唇长、下唇长、上唇倾角、下唇倾角、颏唇沟角、H角、上下唇角和软组织轮廓这些指标有显著性差异；安氏Ⅱ类错合患者的上唇长比安氏Ⅲ类错合患者的长、安氏Ⅱ类错合患者的下唇长比安氏Ⅲ类错合患者的短；安氏Ⅱ类错合患者的上唇倾角和H角比安氏Ⅲ类错合患者的大，安氏Ⅱ类错合患者的下唇倾角、颏唇沟角和上下唇角比安氏Ⅲ类错合患者的小。

The results show:(1) the probability at small scattering angle is larger than that at big scattering angle. With the increase of collision energy, the scattering probability and the tail effect slow down.

结果表明：(1)小角散射的概率大于大角散射的概率；碰撞能量越高，散射概率越小，尾部效应越弱。

Ten parameters of Doyle-Turner expression of scattering factors have been accurately fitted, which include the elastic scattering factors of 98 elements crystals, TDS absorptive scattering factors of 43 elements crystals and absorptive atomic scattering factors of 17 important materials with the zinc blende structure.

对CCD相机的几何畸变进行了矫正。通过对高能电子衍射理论及散射机制的阐述，一方面利用模拟退火算法对原子的弹性和非弹性散射因子进行含10个参数的Doyle-Turner表示的拟合。

Since the multiple scattering should be considered, the scattering problem of many-cylinders is more complicated than single cylinder. By using scattering matrix method to solve the scattering problem of many-cylinders, first we have to express the incident fieldand scattered field by special function（for example, Bessel function and Hankel function）under cylindrical coordinate, then use the addition theorem of special function to get a linear system of equations to relate the incident field coefficients and scattered field coefficients. The incident and scattered field coefficients for every cylinder can be solved from the linear equations by matching electromagnetic boundary condition pointwisely.

单颗圆柱散射体的散射场解析解很早就被解出，而多个圆柱阵列的散射场问题因为涉及到入射光在圆柱与圆柱间的多重散射，故散射行为较单颗圆柱的散射复杂，因此圆柱阵列的多重散射问题需要利用加法定理来处理；散射矩阵法的主要精神即是先用圆柱座标下的特殊函数对平面波和圆柱散射体的内外域电磁场做无穷级数展开，再藉由特殊函数的加法定理将所有圆柱散射体的展开中心移到同一个展开中心，最后可以得到一组连结整个散射系统的入射电磁场系数及散射电磁场系数的线性方程组，将该组线性方程配合电磁场在散射体边界的连续条件，便可分别求出圆柱阵列中各个圆柱体的内部电磁场与外部散射场，再利用线性叠加原理即可求得整个圆柱系统的全域电磁场分布。

Putt your way through 36 fun-filled holes of minigolf on 3D designed courses with elevated greens, bunkers, bridges and water hazards, among other crazy obstacles.

您的推杆方式，通过36个有趣的填孔迷你的三维设计的课程，以提升绿党，掩体，桥梁和水的危害，除其他疯狂的障碍。

Some participles can be used either as attributes or as predicatives.

有些分词既可当定语用，也可当表语用。