查询词典 scanning speed

The major contribution of this dissertation is as follows:1 according to the format of laser scanning data, suggest the method that search the corresponding point in known vicinage region , seeks new nearly corresponding point, accelerates register speed.

本方的主要贡献如下： 1 针对激光扫描数据的格式，提出了在已知对应点的邻域内进行局部搜索，查找新的最近点对的方法，加快配准速度。

Carbon source,nitrogen source,cultivation temperature,the initial pH of the culture medium,the speed of shaker are involved in the experiments,and the evaluation of retting is based on the residual gum content in retted flax roving.Then flax roving treated under the optimal conditions is compared with untreated roving in ingredient analysis,scanning electron microscope and infrared spectrum analysis.The result shows that the microbe treat...

用筛选出的一种真菌对亚麻粗纱生物处理的工艺进行了探讨，以残胶率作为评定标准，研究了碳源、氮源、温度、pH值、摇床转速对亚麻粗纱生物处理效果的影响，并在最佳工艺下对亚麻粗纱再处理，对处理后的粗纱进行成分分析、扫描电镜、红外光谱等测试，结果表明：亚麻粗纱的生物处理是可行的。

Sulfide layer was made on the surface of high speed steel (W6Mo5Cr4V2) by means of low temperature ion sulfurization. The tribological properties of the sulfide layer under dry sliding were investigated on an MM 200 friction and wear test rig. An atomic force microscope and a scanning electron microscope equipped with an energy dispersive spectrometer attachment were adopted to analyze the morphologies and compositions of the original and worn surfaces of the sulfide layer. The phase structure of the sulfide layer was determined by X ray diffraction.

采用低温离子渗硫工艺在 W6 Mo5 Cr4 V2高速钢表面制备了硫化物固体润滑层，在 MM- 2 0 0型摩擦磨损试验机上对渗硫层的摩擦学性能进行了干摩擦试验研究，用原子力显微镜及扫描电子显微镜和 X射线光电子能谱分析渗层表面、截面、磨面的形貌及成分，用 X射线衍射仪分析了渗硫层相结构。

Migration parameters for the overflying population - density, speed, direction, flux, collective orientation - and their variances are estimated from these datasets, and profiles of these quantities can be obtained by the usual scanning entomological radar technique of observing at a sequence of antenna elevations.

利用该系统可以获得昆虫在空中迁飞获动的密度、速度、方向、群体定向及变化情况。进行按一定仰角的系列观测，即可获得各个高度层昆虫迁飞分布的情况。

The corrective force was adjusted to 60g.Salvia miltiorrhiza combination was implanted to each rat in the experimental group every day.The animals of both experimental group and control group were killed at 7,14 and 21 days.The upper dens malarias and periodontal tissue slices were observed under the light microscope and transmission electro microscope,and the X-ray dental films were taken and measured with digitization dental scanning apparatus and its software.Result:The most fitting concentration of combined biological membrane was 0.80g;the speed of the remodeling of the periodontal tissue at the compression side in the experimental group was faster than that of the control group.

以36只体重(250±10)g的雄性大鼠为样本，随机分为正常组、实验组和对照组，设定不同浓度丹参复合膜，以同体对照方式在正常组进行体内植入实验，在2周内观察不同浓度丹参的牙周组织诱导作用，寻找最佳应用浓度；在实验组和对照组的上切牙与磨牙之间隙安装正畸装置，建立大鼠磨牙移动实验模型，矫治力的大小为60g；实验组每日每只体内植入丹参复合生物膜，两组动物于正畸加力7、14、21d，分三批处死；处死后立即切取双侧上颌磨牙及牙周组织制取标本，制片透射电镜和光镜观察；拍摄X线牙片，用数字化牙科扫描仪及软件对其进行测量分析。

Our laser scan micrometer measure 1,800 time per second. The speed of scanning beam is 176m/s. The accuracy is ±3 micros.

该产品具有每秒1800次的测量速度，光束扫描速度为每秒176米，测量不确定度不大于±3微米。

The apparatus mainly consists of a high temperature environmental chamber, a power circuit of heating, two high-speed pyrometers, and a laser scanning system.

测量装置主要包括高温环境实验箱、加热供电回路、两套高速高温计及一套激光扫描系统构成。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。