查询词典 scale modulus

In this paper, we review relationship of bulk and shear modulus and apply the Gassmann's equation to predict shear modulus.

本文对体变模量和剪切模量之间的关系进行讨论，并使用Gassmann方程来预测剪切模量。

However, we found that for loose sands, the dry bulk modulus seems to be greater than the shear modulus, especially at low pressures.

但是我们发现，尤其在低压条件下，疏松砂体中的干燥体变模量似乎比剪切模量大得更多。

The items of shear modulus and bulk modulus which are not instantaneous are input when define the viscous items.

定义粘性项时需输入剪切模量和体积模量的PRONY级数表达式的非瞬时项。

The dry bulk modulus should be consistent with shear modulus as follows

这个干燥体变模量应该与剪切模量在以下这些方面一致

The results show that the structure parameters of the bulk-modulus measuring device and the pressure and flow parameters of the testing system are set properly. The measured value of the bulk modulus of hydraulic oil is nearly equal to the theoretical value.

在AMESim仿真软件平台上进行了该装置测量历程的仿真分析，效果表明油液弹性模量检测装置的结构参数和测量系统的压力流量等设定得合理，测得的油液弹性模量值与理论值吻合较好。

Based on Three Gorges Project, the following aspects about the three typical embedding manners are studied:(1) The border condition of cyclic symmetry is applied to the finite element models with contact among cushion layer, penstock and concrete. The effects of elastic modulus, thickness and placement extent of cushion layer on the stress of its around concrete are analyzed. It is suggested that the ratio of thickness to elastic modulus can be used as an important parameter in the design of cushion layer.

因此，本文结合三峡工程建设实践，在收集和总结前人经验的基础上，以大型通用有限元分析软件ANSYS为平台，对不同埋设方式的巨型蜗壳结构进行以下几个方面的研究：(1)引入循环对称边界条件，考虑垫层-钢板-混凝土之间的接触摩擦，建立有限元模型；并对垫层敷设范围、垫层厚度和弹性模量等设计关键参数进行了优化，并把"垫层弹性模量与垫层厚度之比"作为参考指标进行设计。

Deformation modulus: the ratio of the vertical load to the vertical strain is called as Deformation modulus.

土的变形模量：土体在无侧向约束条件下，竖向应力与竖向应变的比值。

It is found that in certain water ratio and consolidation pressure, the values of initial elastic modulus and principal deviator stress increase with intermediate principal stress increasing; in certain intermediate principal stress, the values of initial elastic modulus and principal deviator stress increase with water ratio falling.

试验结果表明：在一定的含水率和固结压力下，偏差应力和初始切线模量均随中主应力比b的增大而增大；在中主应力比b确定的情况下，偏差应力和强度最大值随着含水率的增大而减小。

It is shown that both deviator stress and confining Stress greatly affect resilient modulus, and the influence of water content is great. Degree of compaction is also an important factor affecting resilient modulus.

结果表明：偏应力σ(下标d和侧向应力(σ3)对路基土回弹模量均有显著影响，含水量对路基土回弹模量的影响非常大，而压实度同样是一个主要影响因素。

Dynamic mechanical analysis,mechanical properties and the thermal dilatability measurements were used to study the effects of SF content on dynamic mechanical properties,impact strength,bending strength,bending modulus,specific strength,specific modulus,wear resistance and thermal dilatability.

采用动态力学、力学性能、热膨胀性能等测定研究了剑麻纤维的加入量对复合材料的动态力学性能、冲击强度、弯曲强度、弯曲模量、比强度、比模量、耐磨性能、热膨胀性能的影响，用扫描电镜观察了材料冲击断面和磨损面的形态。

Now she was hungry and angry.She began to smoulder.

现在她又饿又气，她开始流露难以抑制的怒火。

You have placed our iniquities before You, Our secret sins in the light of Your presence.

诗90：8 你将我们的罪孽摆在你面前、将我们的隐恶摆在你面光之中。