查询词典 scale coefficient

Precision instrument: Mode of relative power of %26plusmn;0.02dB or %26plusmn;0.5%: Measuring %26plusmn;0.02dB or %26plusmn;0.5% are inside limits; Exceed measure limits to installed at 0 o'clock for %26plusmn;0.04dB or %26plusmn;1%: In the %26plusmn;0.5% of the most acute limits complete scale Power consults power outputs: 100mW precision:%26plusmn;1.2% The face plate after general technology index outputs: Imitate 0-1V(does not take digital filter wave) or calibration coefficient is amended, 1K%26Omega; outputs impedance, BNC connects contact voltage: 220V and 240Vac,+ 5%~10%, 48~66Hz power asks: Weight of the biggest 8W(10VA): Suttle 2.6 kilograms of dimension: 88mm %26times;212mm %26times;273mmgrows

精度 仪器：%26plusmn；0.02dB或%26plusmn；0.5%相对功率模式：在测量规模内为%26plusmn；0.02dB或%26plusmn；0.5%；超出测量规模为%26plusmn；0.04dB或%26plusmn；1%零点设置：在最灵敏的规模全刻度的%26plusmn；0.5%功率参考功率输出：100mW 精度：%26plusmn；1.2%一般技术指标后面板输出：模拟0-1V或校准系数批改，1K%26Omega；输出阻抗，BNC连贯头电压：220V和240Vac，+5%~10%，48~66Hz 功率要求：最大8W(10VA)分量：净重2.6公斤尺寸：88mm%26times；212mm%26times；273mm长

As to concrete treating method, the thesis adds the components in third dimension to the original 2D MHD code, and inward flows are embedded along the side of the current sheet, through changes of certain flow's scale, its distance to the current sheet, the viscosity coefficient and the resistivity in the plasma, the magnetic field figure, the velocity vector figure and the density distribution figure with different situations would be showed and observed, the reconnection growth rate figure is to be presented also, and the physical explanation involved will be made consequently.

在具体的处理方法上，文章在原有二维MHD流体理论基础上加入第三方向的分量，并且在电流片两侧加入入流扰动，通过改变其大小，距离电流片的位置，等离子体中的粘滞系数和等离子体电阻率，从而观察不同扰动情况下磁场重联的磁场位形、流场位形或者密度分布，绘制出磁场重联增长率在不同入流扰动下的图像，并分析其中的物理过程。

In this paper the viscous flows around a mathematical SWATH in full scale are simulated based on the computational fluid dynamics commercial software FLUENT. The numerical results of total pressure, wall shear stress and the corresponding viscous resistance coefficient at different velocity are obtained. The computational viscous resistance coefficients are compared with the estimated ones using empirical formula. The validity of the software to predict the three dimensional viscous flows and viscous resi...

利用计算流体力学商业软件 FLUENT对一实尺度小水线面双体船数学船型的粘性绕流进行了数值模拟，得到了不同航速下的船体表面总压力、表面剪切应力分布和相应的粘性阻力系数；将各航速下的粘性阻力计算结果和经验公式估算结果作了比较，验证了 FLUENT用于计算小水线面双体船三维粘性流和粘性阻力的有效性。

The results indicated that (1) the economy in Zhejiang Province was in the developing stage of unchanged scale wage;(2) the inputoutput elasticity coefficients was the most sensitive to labour element among the factors which had effect of economic growth in Zhejiang Province.The results showed that the coefficient was 0.538 5 in labour element while the coefficients were 0.247 3 in land element and 0.321 6 in fixed asset elements respectively;（3）the contribution of the input of fixed assets was 6823% and still the major impetus to economic growth during this time;(4)the land use was not intensive basically in Zhejiang Province,the input of land elements was replaced by that of other elements during the study.So,labour intensive industry should be one of the industries in the future.

研究结果表明：(1)就规模效应而言，浙江省的经济增长处于规模报酬不变的发展阶段；(2)浙江省经济增长对劳动力要素的投入最为敏感，其中土地要素、劳动力要素和资本要素增加1个单位的投入量对经济增长的推动为 0.247 3、0.538 5 和 0.321 6；（3）固定资产投入在研究期间是浙江省经济增长的主要推动力，其贡献率达到6823%，而劳动力要素与土地要素则分别为2346%和625%；(4)浙江省土地利用不够集约，在研究期间土地要素对经济增长的影响能被资本要素与劳动力要素有效替代，而劳动力要素则难以被资本投入与土地投入有效替代，劳动集约型产业应该成为浙江省未来发展方向之一。

In the initial stage of scale,the amendatory coefficient is the greatest.

随着结垢过程的进行，修正值增大，修正系数减小。

The question of the low propagation coefficient in the production of Amorphophallus at present, the research may use in the large scale production induction technology for test-tube micro-bulbodium.

针对目前魔芋生产存在种芋繁殖系数低的问题，研究可用于大规模生产魔芋试管微球茎的诱导技术。

During the process of the fore mentioned analyses, some tentative works as follows were done.(1)On the basis of the fundamental of spatial analytic geometry, the basic method for displaceable block searching was put forward and the relevant program was written. With this program one can easily search out all the displaceable blocks and omitting of blocks, which is very common in searching blocks manually, can be avoided.(2)The coefficient of stability of blocks with failure mode II-2(that is, sliding on a single sliding surface, but confined by near intersecting line )was deduced.(3)The multi-cavern effect of Laxiwa underground caverns was studied on the assumption that all of the caverns were full face tunneled at the same time.(4)The stability classification scheme of rock mass surrounding large scale underground caverns was established. In addition to inherit the merits of the method of engineering geological

在完成上述工作的过程中，本论文主要在以下几个方面进行了一些探索：①基于空间解析几何原理，提出了块体搜索的基本思路并编制出相应的程序，基本实现了块体搜索的自动化，既大大缩短了块体搜索时间，又能防止因人工搜索引起的遗漏；②推导出Ⅱ-2型(单滑面滑动，但受侧限面约束)块体的稳定性系数计算公式；③以数值模拟方法论证了拉西瓦地下厂房洞室群全断面一次开挖时群洞效应的具体特点；④以岩体质量、开挖效应、群洞效应和次生灾害效应为评价指标，建立了&大型地下洞室群围岩稳定性分类&方案；该方案既继承了水电行业规范&围岩工程地质分类&法的优点，又综合考虑了大型地下洞室群的工程特点。

Diffusion tensor imaging is a kind of new technique after diffusion weighted imaging.DTI can reflect anisotropy hydrone molecular diffusion features of damaged myeloid tissue through measuring apparent diffusion coefficient and fractional anisotropy.Accordingly,we can make more precise and allround estimate about spinal compression on microscopic scale.

磁共振扩散张量成像是继扩散加权成像后发展起来的一种新技术，它通过测量表观扩散系数及部分各向异性值来反映损伤脊髓组织的各向异性水分子扩散特征，从而在微观水平对脊髓压迫症做出更精确和全面的评价。

For large-scale geophysical measured data such as the postglacial rebounding of ground,the non-constant viscoelastic creep model can well simulate the data and calculate the viscosity coefficient.

这种修正的本质其实就是对牛顿流体假定(n=1)的修正，是时间尺度对岩石力学参数影响的一种补偿

The available methods of Seebeck coefficient of micro-scale material with MEMS structure were reviewed.

综述了微观尺度下利用MEMS结构测量硅材料塞贝克系数的已有工作。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。