查询词典 sample

Advection—For a given sample, we advect flow by fetching the velocity value of that sample.

平流。对于给定样本，通过提取该样本的流速值来执行平流输送。

The representative points of positive case support vectors and negative case support vectors in sample set are defined, the measure and eigenfunction between sample x and y allusiveness from initial space to eigen space under a kernel function k are researched, and a correlative theorem with demonstration is given.

定义了样本集中的正例支持向量和反例支持向量的代表点，研究了原始空间样本x，y在核函数k映射下在特征空间中的x，y映象之间的度量和特征函数并给出了相关的定理及证明。

In recent years, capillary electrophoresis has been become an alterative technology for sample analysis and widely used in environmental research due to its extraordinary separation facility, high speed of analysis, low requirement of sample volume and cost.

毛细管电泳技术自身浓度灵敏度比较差的缺点限制了它在环境痕量分析中的应用前景，但是只要适当对样品进行预处理，毛细管电泳技术仍然是具有重要应用价值的分析工具。

The effects of the ratio of water and the sample, extracting temperature, extracting time, and the sample particle size on water-soluble active ingredients of Ampelopsis grossedentata were investigated with single factor and orthogonal experiments as a measure of total flavones and water extraction ratio.

以水溶性活性成分总黄酮和水浸提率作为衡量浸提效果的评价指标，分别采用单因素和正交实验L9(34)确定了茶水比、浸提温度、浸提时间和样叶粒度对显齿蛇葡萄总黄酮和水浸提率的影响，得出了影响的主次顺序为茶水比、浸提温度、样叶粒度和浸提时间。

We have performed partial melting experiments on a massive amphibolite sample under 1.5 GPa and 950 ℃ for 101 hours: the sample was collected from Archaean terrain in the northern margin of the North China craton.

在1.5 GPa，950 ℃，恒温101 h条件下对华北北缘太古宙地体中的斜长角闪岩块状样品进行了脱水部分熔融实验，实验产物组合为Hb+Cpx+Gt+Gl，获得的熔体为花岗闪长质成分。

By extending the concept of MBE technique and employing the uniform buffers to separating the sample electrophoresis, the zone electrophoresis was developed. The isotachoporesis technique is based on the separation in a discontinuity form between two buffer solutions and results in separation of samples. The isoelectric focusing is a method that concentrates the ampholyte sample by the pH gradient introduced in the background ampholytes.

区间电泳法以移动边界电泳法作为基础的技术，其在系统环境充满均匀的缓冲液进行分离；等速电泳法则利用两缓冲液进行不连续分离之技术；等电点聚焦电泳法则利用背景溶液建立出pH值梯度，双性电解液样品因其位於等电点所受库伦力为零而聚焦於此。

This ellipsometric method does not need to rotate the sample azimuthally. The physical parameters of sample are measured under various linear polarized lights through the numerical fitting to its theoretical model. In addition to the orientation of the first layer of nematic liquid crystal is considered, the total phase retardation and twist angle of twist Nematic Liquid Crystal cell are the physical parameters measured by this method.

本论文以椭圆偏极术为基础，在不需转动样本方位角的情况下，以不同偏振方向的线性偏振光入射样本，藉由出射光偏振态的变化，用数值方法拟合出样本矩阵模型参数；我们所量测的样本为扭转式液晶盒，其矩阵模型包含了三个参数：总相位延迟、扭转角及第一层液晶锚定方向。

Sample analysis shows that within alumina glaze formula, when Si/Al〈4.0, there is anorthite phase and little quartz and submellite to separate out; When Si/Al〉4.0, sample stays fine at glass state; anorthite crystal forms at the highe

样品呈良好的玻璃态；高铝釉式（Si／Al〈4.0）汝瓷釉内钙长石晶体在最高烧成温度（1260℃）保温过程中就已生成，在降温过程中晶体继续长大。

Traditional statistics is mainly conducts the research to the sample number approach in the infinity time evolution theory, but counts the theory of learning is conducts the research to under the small sample condition theory of learning.

传统统计学主要是对样本数目趋近于无穷大时的渐进理论进行研究，而统计学习理论则是对小样本条件下的学习理论进行研究的。

In this study, the silicon and platinum in catalyst sample were both dissolved with aqua regia and hydrofluoric acid to dissolve the sample completely for platinum analysis.

本文采用王水与氢氟酸共同溶解硅和铂的方法，达到铂分析的全溶制样目的。

The large quantity of input to the comprehensive coal mining equipments leads to the booming of the coal mining equipment market,and the brutalizing of competition in medium and low grade coal mining equipments.

煤矿综采设备的大量投入，煤机市场走热，中低端设备市场竞争激烈，高端设备较为短缺，用户亟需适用性好、性价比佳的设备。

Procecding from the view of system theory and making the actual require-ments as a condition in piling work ,the velocity parameter of unloaders was caculated by the use of ideal point method in comprehensive evaluation.At the same time .the total power was minmum and the productivity was maximum.

本文从系统理论的观点出发，以装卸桥在贮木场从事归楞作业的实际要求为约束条件，同时以装卸桥系统总功率大小和生产率最大为目标，采用综合评比法中的理想点法对装卸桥的速度参数进行优化计算。