查询词典 sample method

The 5th chapter studied the crucial problem of floating detection application, develop the traffic flow information collection technology based on GPS, put forward the general principle and optimization method of the floating detection minimum sample size, and simulate several sample size scenarios of floating detection on the city road with the microscopic simulation software The 6th the combination application optimization of the dynamic traffic flow information collection technology, put forward the necessariness of combination application optimization, then analysed the principle and work steps of combination application optimization design, finally gived an example for the combination application optimization.

第五章是移动型检测器应用的关键问题研究。本章对移动型检测器的空间布置问题进行了研究，设计研究了基于GPS的动态交通流信息采集技术，提出了移动型检测器最小样本量确定的一般原则和方法，并利用微观仿真模拟软件进行了模拟分析。第六章是动态交通流信息采集技术组合应用优化设计研究。本章首先提出了进行动态交通流信息采集技术组合应用优化设计的必要性，然后分析了组合应用优化设计的原则，设计了组合应用优化设计的工作步骤，并举例分析了动态交通流信息采集技术组合方案的优化设计方法。

The 5th chapter studied the crucial problem of floating detection application, develop the traffic flow information collection technology based on GPS, put forward the general principle and optimization method of the floating detection minimum sample size, and simulate several sample size scenarios of floating detection on the city road with the microscopic simulation softwareThe 6th the combination application optimization of the dynamic traffic flow information collection technology, put forward the necessariness of combination application optimization, then analysed the principle and work steps of combination application optimization design, finally gived an example for the combination application optimization.

第五章是移动型检测器应用的关键问题研究。本章对移动型检测器的空间布置问题进行了研究，设计研究了基于GPS的动态交通流信息采集技术，提出了移动型检测器最小样本量确定的一般原则和方法，并利用微观仿真模拟软件进行了模拟分析。第六章是动态交通流信息采集技术组合应用优化设计研究。本章首先提出了进行动态交通流信息采集技术组合应用优化设计的必要性，然后分析了组合应用优化设计的原则，设计了组合应用优化设计的工作步骤，并举例分析了动态交通流信息采集技术组合方案的优化设计方法。

In order to deal with the problem of face recognition with one sample per person, a method called sub-block Principal Component Analysis based on partitions of the sample is presented in this paper.

针对单样本人脸识别问题，本文提出了一种基于单样本切割的子模块主成分分析方法。

The influence of different assembled condition such as assembly method, concentration of zirconium source and pH value on the effectiveness of assembly were evaluated via DSC-TG, FT-IR, Uv-vis and SAXRD et al. It showed that the assembly effectivness of uncalcined 3 Si/Zr_10# sample was best.c The optical characteristic, which including light-conduction in infrared band and polarity in visible band, of dip-coating film and membrane assembled zirconia after processing parameters of assembly optimized were observed via FT-IR and Uv-vis. The polarity was characterized by polarizing angle through calculation from light-transmittance, light-reflectance and fresnel coefficient. qualitative analysis showed that the polarity of Si/Zr_10 # dip-coating film assembled was best.d Adopting zirconium oxychloride as zirconium source, CTAB as template, employing different CTAB adding sequence, two mesoporous zirconia samples were prepared. The template effect of two samples was discussed. It showed that the effect of the sample which CTAB adding sequence was same as mesoporous silica film was better. The light-conduction in infrared band of these samples was also studied, which offered comparison to the polarity of zirconium dioxide assembled within mesopore.

结果显示：组装条件优化后的uncalcined 3 Si/Zr_10#厚膜样组装效果最好，其组装液对应的pH值最利于该锆源离子模板交换组装； c选用FT-IR、Uv-vis对组装条件优化后纳米氧化锆/介孔氧化硅厚膜、纳米氧化锆/介孔氧化硅薄膜包括红外导光性、可见光区内的偏光性在内的光学特性进行了分析，其中偏光性以膜层透光性、反光性及菲涅耳系数计算出的偏振角即布儒斯特角表征，定性分析显示，Si/Zr_10#ZrO_2/介孔氧化硅厚膜偏光性最好； d以氧氯化锆ZrOCl_2·8H_2O为锆源，CTAB为模板剂，采用不同的模板剂加入顺序，探索性地制备两介孔氧化锆样，分析了两介孔氧化锆样的模板效果，得出模板剂加入顺序同介孔氧化硅薄膜时介孔氧化锆样的模板效果较好，并分析了所得样品的导光性，为锆氧粒子引起的附加光学特性分析提供了参考和对比。

For a given proportion p (where p is the confidence level), a confidence interval for a population parameter is an interval that is calculated from a random sample of an underlying population such that, if the sampling was repeated numerous times and the confidence interval recalculated from each sample according to the same method, a proportion p of the confidence intervals would contain the population parameter in question.

对于一个比例 P而言，一个群体参数的置信区间中的区间是由一个基础群体的随意样本计算出的，假如样本被重复了无数次，置信区间也根据每个样本，以同样的方法重新计算，那么这个置信区间中的比例 P 将要重新定论。

Based on maximum likelihood estimate, the estimate method of sieving rate of connectivity sieve was presented. Three key issues in the estimate were analyzed:calculation of sample size,generation of random sample, and recognition of connectivity of induced subgraph. By preassigned credibility and precision, effective estimate of sieving rate of connectivity sieve is achieved.

目前，产品拆卸过程规划基本上是建立在图的基础上，即首先根据产品拆卸回收或拆卸维修信息，选用一种适合的图模型进行描述，然后在图模型的基础上，以拆卸回收或拆卸维修的经济性、环境协调性和技术性等综合指标最优为目标，进行拆卸过程规划，最终得到产品的最优拆卸序列【1一。1连通性筛子拆卸与或图是拆卸模型中的一种，文献[7]给出了拆卸与或图的定义及建模过程。

Base on the data from the secondary industry of 30 sample cities, this dissertation adopts the method of empirical analysis — Primarily the statistical technique named "Prime Component Analysis", to answer the basic question "what are the prime factors in determining the secondary industrial grads of the sample cities?"

鉴于此，本论文运用实证分析的方法，以长江三角洲和珠江三角洲30个城市的第二产业为例，将研究重心放在对产业梯度影响因素的分析之上，进而粗略地总结了这两个区域从1978年到1990年，再到2002年这二十多年之中，第二产业梯度转移的大致规律。

With the sample of the newest financial data of the company issued by the ST in 2006-2007, and the sample of the normal company at the same time, the study takes example for the financial data released by the listed companies and selects the ROE（Rate of Return on Common Stockholders'Equity ）, the sales net profit rate and the current ratio of three financial targets, which are discriminated and analysed with univariate method.

摘 要：本文以我国上市公司为研究对象，通过对上市公司财务危机的定义、财务危机与企业失败的关系、以及财务危机预警的研究，以2006-2007年上市公司最新一次被ST发布的财务数据为估计样本，以同期的正常公司为配对样本，选取净资产收益率、销售净利率和流动比率三个财务指标，运用单变量方法进行判别分析。

The interference method for determination of refractive index has many advantages, such as easy-producing sample, extensive testing range, and the reutilization of sample.

因此，不断的寻找新的测量方法来满足技术发展的需要，一直是光学测量的重要研究任务之一。

Riffle division method: a riffle is a kind of non-mechanical sample divider, which is usually fed manually. The sample is divided into 2 equal parts by riffle, with one retained and one rejected.

二分器缩分法：二分器系非机械式样品缩分器，通常用手工给料，样品通过二分器被分成二等份，一份保留，另一份弃去。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。