英语人>网络例句>sag vertical curve 相关的网络例句
sag vertical curve相关的网络例句

查询词典 sag vertical curve

与 sag vertical curve 相关的网络例句 [注:此内容来源于网络,仅供参考]

The measured porosity data and the observations of thin sections and blue epoxy resin-impregnated thin sections show that the diagenesis in the Qingshui sag can be divided into two stages and five substages. There exist three abnormally high porosity zones vertically in the Cenozoic reservoirs in the Qingshui sag, Liaohe Depression, whose genesis is related to the eluviation of precipitation and the dissolution of organic acid.

根据岩心实测孔隙度、薄片观察、铸体薄片和扫描电镜等实际资料,将辽河盆地西部凹陷清水洼陷新生界成岩作用划分为早成岩阶段和中成岩阶段2个阶段,其中包括5个亚期,指出该洼陷新生界纵向上发育3个异常高孔带,这种异常高空带的形成与大气降水淋滤作用和有机酸对储层的溶蚀作用有关。

Extra sag on the front end will decrease the effective steering head angle, quickening steering, while too little front sag will slow steering.

车前端额外的下沉会减少转向头的角度,加快转向,小的前端下沉会减慢转向。

Transfer zone character and its relationship to hydrocarbon in Fula Sag ,Sudan;2. Fula sag is located in northwestern Muglad basin of Sudan Republic in Central Africa.

穆格莱德盆地福拉凹陷是在中非剪切带剪切应力场背景下形成的以中生代沉积为主的裂谷凹陷,裂陷活动可分为早白垩世、晚白垩世和古近纪3个阶段,主要形成南北和北西-南东走向两组断裂。

Tiaohu sag and Malang sag are primary source depressions in Santanghu basin.

三塘湖盆地的主要生油凹陷是条湖凹陷和马朗凹陷,按油气资源量它们属于中等丰度偏高的凹陷。

Results Malang Sag has two important times uplifting and three times subsiding, while Tiaohu Sag has three times uplifting and four times subsiding.

结果 马朗凹陷主要经历了2个隆起期和3个沉降期,条湖凹陷为3个隆起期和4个沉降期;早、中二叠世两凹陷的沉降幅度很大,沉积速率最大可达133.46m/Ma;晚白垩世的隆起幅度最大,地层剥蚀厚度可达846m。

A vertical profile of the 3D wellbore trajectory is generally.The challenge is how to draw the actual wellbore trajectory on the vertical profile of planned well trajectory.A planned 3D well path profile is depicted using vertical depth and projection length,however,the actual wellpath profile is supposed to be drawn using vertical depth and apparent projection length.

三维井眼一般都绘制垂直剖面图,其难点就是怎样在设计井眼轨道的垂直剖面图上描绘实钻井眼轨迹的剖面线,由于三维井眼设计剖面图是用垂深与投影长度绘制,其实钻井眼轨迹剖面图应该是用垂深和视投影长度绘制。

The process is characterized in that, the zoomed image being defined by its horizontal and vertical homothety ratio with respect to the coded image (1, 7), it performs the following steps: calculation of the horizontal and vertical sizes of an initial display rectangle (8) from which would be obtained the sizes of the target display rectangle (2) as defined by the profile and level information by applying the horizontal and vertical homothety ratios, storage in the display_horizontal_size and display_vertical_size fields of an MPEG2 video data stream of the horizontal and vertical sizes of the initial display rectangle.

该方法的特点是被缩放图像由它针对被编码图像(1,7)的水平和垂直缩放率定义,它执行下面的步骤:通过应用水平和垂直缩放率来计算初始显示长方形(8)的水平和垂直尺寸,从中可以获得按照轮廓和级别信息定义的目标显示长方形(2)的尺寸,在MPEG2视频数据流的display_horizontal_size和display_vertical_size字段中存储初始显示长方形的水平和垂直尺寸。

Second, transient flow for vertical well and fractural well in porous media with arealanisotropy has been researched in this paper. The analytic solution for vertical well andsemi-analytic solution for vertical fractural well is developed by using image inversion,superposition principle, Laplace transformation, Fourier transformation, as well as theirinverse transforms, and storage and skin are taken into account. For vertical fractural well,influence of pressure and productivity is studied when the orientation of artificial fractureisn't in accordance with the direction of major permeability, it is fundamental to evaluatepotential and analyze well test data.

文中研究了平面各向异性储层不定常渗流问题,建立了平面各向异性储层交叉直线边界中一口直井渗流的数学模型,利用镜像反演、Laplace变换、Fouier变换及其反变换推导了不同边界条件下直井的Laplace空间解析解,考虑井储和表皮的影响,分析了曲线特征及影响因素的敏感性曲线;并运用影响椭圆及Duhamel叠加原理,推导了平面各向异性储层中垂直裂缝井的压力分布方程,考虑了水力裂缝与主渗透率轴成一定角度对压力及产能的影响,为垂直裂缝井的产能评价及试井分析提供依据。

With the vertical time sequence results computed by the monitoring data (until Aug, 2008) from 28 GPS stations of continuous observation in Tianjin and Beijing Area, the paper analyzes the variation characteristics of vertical component of each GPS continuous stations, calculates the vertical movement velocity of GPS stations in Tianjin and Beijing Area of 2007~2008, compares with the vertical deformation velocity calculated by leveling of 2007-2008 in Capital Circle Area; Furthermore, searches GPS stations nearby the leveling route, corresponding to the first and second leveling time period, calculates the section plane of GPS route, analyzes and compares the section results of GPS and leveling of 2 time periods.

利用北京和天津地区的28个GPS连续观测站资料(资料截至2008年8月)计算得到的垂直向时序结果,分析各个GPS连续观测站垂向分量的变化特征,计算得到2007~2008年北京天津地区GPS站垂直运动速率,并与水准测量计算得到的2007~2008首都圈地区垂直形变速率进行比较;通过寻找水准测量路线附近的GPS站点,相应于水准的初测和复测时段,计算得到GPS路线剖面图,将GPS与水准2个时段的剖面结果进行对比分析。

Firstly, it seeks the sources from which theories have been developed, by a summary of evolution or a road-map. Secondly, it explains the two basic forms taken by traditional theories on intra-industry trade, namely, horizontal intra-industry trade model and vertical intra-industry trade model. Both models take final products as trade objects and products of same industry are thus simultaneously exported and imported among developed nations and among developed nations and developing ones.Thirdly, it points out that the theory of vertical intra-industry trade has already been expanded in scope in the area of trade between developed countries and LDCs. It shows that the implication of vertical intra-industry trade has expanded to the importation and exportation of parts and components, intermediate products or processing products produced via various working procedures or different production links within the same industry, with MNCs as carriers. It gives the summary of the methods of measuring intra-industry trade and argues that the basic method adopted by this thesis is G-L Index. In addition, GHM and Input-output Analysis are introduced to demonstrate the expansion of vertical intra-industry trade.

首先,通过整理国际贸易理论的发展脉络,寻求产业内贸易的理论渊源;其次,阐述产业内贸易传统理论的两种基本形式,水平型产业内贸易与垂直型产业内贸易的理论模型,指出两者都以最终产品为贸易对象,实现了发达国家之间或发达国家与发展中国家之间的同一产业内产品的同时进口和出口;第三,结合全球化的特点和跨国公司在国际要素分工中的基础作用,指出发达国家与发展中国家之间的垂直型产业内贸易理论已经得到拓展,表明垂直型产业内贸易涵义已发展成为以跨国公司为载体的同一产业内不同生产工序或不同生产环节的零部件、中间产品或加工产品的进口和出口;最后,归纳了产业内贸易的计量方法,指出本文的产业内贸易基本计量方法是G-L指数(格鲁贝尔-洛伊德计量法),并在此基础上进一步说明与垂直型产业内贸易的拓展相关的计量方法包括:GHM计量法和Hummels投入-产出分析法。

第4/500页 首页 < 1 2 3 4 5 6 7 8 9 ... > 尾页
相关中文对照歌词
Sag Your Pants
Curve
Vertical Man
Vertical
Dead Man's Curve
Awnaw
Awnaw (Remix)
Dead Man's Curve
Lieber Gott
Where The Shit Goes Down?
推荐网络例句

Objective To study the effect of chitosan in the prevention of fibrous scar formation in the epidural space after laminectomy.

目的 观察选择性脊神经后根切除术椎板切除后硬膜外几种防瘢痕粘连物质的作用并探讨其机制。

On his way to the lift, he looked back to us or was it me his eyes pointing?

当他要进电梯时,他回头看我们(或者说是我,他的眼光?

Galileo was a famous Italian scientist by whom the Copernican theory was further proved correct.

伽利略是意大利著名的科学家,他进一步证明了哥白尼学说是正确的。