查询词典 routing

Then a new backup routing mechanism was proposed to replace the previously mentioned backup routing mechanism of QDSR. Route recovering could be initiated from middle nodes on the disjoined path, therefore, the route recovery could be done fast.

建议了一种从中间节点开始恢复的备用路由机制以便在链路断时能快速恢复，取代了笔者之前提出的QDSR基于源节点的备用路由机制。

The maze algorithm in a PCB routing system is described in this paper Some methods to iniprove routing rate, accelerate mazing speed and reduce storage location are presented

本文叙述了PCB布线系统中的迷路法，提出一些提高布通率，加快迷路速度和减少内存单元的有关措施。

To accommodate the current situation that nodes can frequently join and leave the overlay session, this paper presenta a load balancing algorithm based on the link available bandwidth. This algorithm utilizes the known knowledge of the physical topological structure, chooses the routing path that has the least effect on the available bandwidth among multiple routing paths, so as to obtain a lightlyloaded overlay edge.

针对节点频繁地加入和退出覆盖会话的现状，本文设计了基于链路可用带宽的负载均衡路由算法LBR，利用已知的物理拓扑知识，在多条路由路径中选择一条对网络可用带宽影响最小的路由路径，得到轻负载的覆盖边。

To accommodate the current situation that nodes can frequently join and leave the overlay session, this paper presenta load balancing algorithm based on the link available bandwidth. This algorithm utilizes the known knowledge of the physical topological structure, chooses the routing path that has the least effect on the available bandwidth among multiple routing paths, so as to obtain a lightly-loaded overlay edge.

针对节点频繁地加入和退出覆盖会话的现状，本文设计了基于链路可用带宽的负载均衡路由算法LBR，利用已知的物理拓扑知识，在多条路由路径中选择一条对网络可用带宽影响最小的路由路径，得到轻负载的覆盖边。

Between class of service and quality of service, RSVP, 802.1Q/p, VLANs, cut-through routing, routing and Layer 3 switching, it's no wonder network managers are confused about the best method for optimizing control over a seemingly chaotic environment.

在服务种类和服务质量之间，有rsvp、802.1q/p、vlan、抄近路的路由、路由与第三层交换等，怪不得网络管理人员也搞混了，弄不懂哪一种办法能优化控制这一看来越来越乱的环境。

In the research,the most importmant field is routing prob- lem,because each node have the function of host and router,so we can have reason routing protocol and algorithm to adopt to the net.

在Adhoc网络的研究中，一个非常重要的领域是路由问题，因为每个节点兼具主机和路由器的功能，这样就需要适合Adhoc这种特殊环境的路由协议和路由算法。

MAX1999EEI Pinout: 8- to 32-bit and 16- to 32-bit word packing options Programmable wait state options: 2 to 31 CCLK Digital audio interface includes six serial ports, two pre- cision clock generators, an input data port, three programmable timers and a signal routing unit Serial ports provide: Six dual data line serial ports that operate at up to 50 Mbits/s for a 200 MHz core on each data line each has a clock, frame sync, and two data lines that can be configured as either a receiver or transmitter pair Left-justified sample pair and I2S support, programmable direction for up to 24 simultaneous receive or transmit channels using two I2S compatible stereo devices per serial port TDM support for telecommunications interfaces including 128 TDM channel support for telephony interfaces such as H.100/H.110 Up to 12 TDM stream support, each with 128 channels per frame Companding selection on a per channel basis in TDM mode Input data port provides an additional input path to the DSP core configurable as either eight channels of I2S or serial data or as seven channels plus a single 20-bit wide syn- chronous parallel data acquisition port Supports receive audio channel data in I2S, left-justified sample pair, or right-justified mode Signal routing unit provides configurable and flexible connections between all DAI components, six serial ports, an input data port, two precision clock generators, three timers, 10 interrupts, six flag inputs, six flag outputs, and 20 SRU I/O pins Serial peripheral interface Master or slave serial boot through SPI Full-duplex operation Master-slave mode multimaster support Open drain outputs Programmable baud rates, clock polarities, and phases 3 Muxed Flag/IRQ lines 1 Muxed Flag/Timer expired line ROM based security features: JTAG access to memory permitted with a 64-bit key Protected memory regions that can be assigned to limit access under program control to sensitive code PLL has a wide variety of software and hardware multi- plier/divider ratios JTAG background telemetry for enhanced emulation features IEEE 1149.1 JTAG standard test access port and on-chip emulation Dual voltage: 3.3 V I/O, 1.2 V core Available in 136-ball BGA and 144-lead LQFP packages Lead free packages are also available

MAX1999EEI引脚说明： 8 - 32位和16 - 32位字包装选择可编程等待状态的选择：2至31个CCLK数字音频接口包括6个串行端口，两个前643时钟发生器，输入数据端口， 3可编程定时器和一个信号路由单元串行端口提供：六双串口数据线，在高达50 Mbps的操作/为200兆赫的每个数据行每个人都有一个时钟，帧同步的核心秒，和两个数据可以作为任何一个接收器或发射器对左对齐和I2S配对样本的支持下，最多可同时接收或传送24个频道，每使用两个系列的I2S兼容立体声设备配置可编程方向线；港口的TDM通信接口，包括支持128个电话接口的TDM的渠道，如H.100/H.110支持多达12个的TDM流的支持下，每帧128个频道每个压缩扩展每通道的基础上选择在TDM模式输入数据端口提供了一个额外的输入路径的DSP核心配置为I2S或串行数据或7加一个20位宽的SYN -异步的并行数据采集接口通道或8通道；支持接收通道I2S音频数据，左对齐样本对，或右对齐模式信号路由单元组件之间提供所有戴配置和灵活的连接，6个串行端口，一个输入数据端口，两个精密时钟发生器，3个定时器，10个中断，六旗投入，产出6个旗，20曼谷南南区域股的I / O管脚串行外设接口的硕士或奴隶通过SPI串行启动全双工运作主从模式多主机支持开漏输出可编程波特率，时钟极性和第三期合并调制旗/ IRQ线路1合并调制旗/定时器过期线光盘的防伪特征：JTAG的访问与64位受保护的关键允许内存内存可分配给程序访问控制的限制下对敏感地区有一个代码锁相环/遥测分比率为背景的JTAG仿真功能增强的IEEE 1149.1 JTAG标准测试访问端口的软件和硬件多钳各种各样和片上仿真双电压：3.3六/输出，可在1.2 V核心136球BGA封装和144引脚LQFP封装无铅封装，也可

TDA4864 Pinout: 8- to 32-bit and 16- to 32-bit word packing options Programmable wait state options: 2 to 31 CCLK Digital audio interface includes six serial ports, two pre- cision clock generators, an input data port, three programmable timers and a signal routing unit Serial ports provide: Six dual data line serial ports that operate at up to 50 Mbits/s for a 200 MHz core on each data line each has a clock, frame sync, and two data lines that can be configured as either a receiver or transmitter pair Left-justified sample pair and I2S support, programmable direction for up to 24 simultaneous receive or transmit channels using two I2S compatible stereo devices per serial port TDM support for telecommunications interfaces including 128 TDM channel support for telephony interfaces such as H.100/H.110 Up to 12 TDM stream support, each with 128 channels per frame Companding selection on a per channel basis in TDM mode Input data port provides an additional input path to the DSP core configurable as either eight channels of I2S or serial data or as seven channels plus a single 20-bit wide syn- chronous parallel data acquisition port Supports receive audio channel data in I2S, left-justified sample pair, or right-justified mode Signal routing unit provides configurable and flexible connections between all DAI components, six serial ports, an input data port, two precision clock generators, three timers, 10 interrupts, six flag inputs, six flag outputs, and 20 SRU I/O pins Serial peripheral interface Master or slave serial boot through SPI Full-duplex operation Master-slave mode multimaster support Open drain outputs Programmable baud rates, clock polarities, and phases 3 Muxed Flag/IRQ lines 1 Muxed Flag/Timer expired line ROM based security features: JTAG access to memory permitted with a 64-bit key Protected memory regions that can be assigned to limit access under program control to sensitive code PLL has a wide variety of software and hardware multi- plier/divider ratios JTAG background telemetry for enhanced emulation features IEEE 1149.1 JTAG standard test access port and on-chip emulation Dual voltage: 3.3 V I/O, 1.2 V core Available in 136-ball BGA and 144-lead LQFP packages Lead free packages are also available

TDA4864引脚说明： 8 - 32位和16 - 32位字包装选择可编程等待状态的选择：2至31个CCLK数字音频接口包括6个串行端口，两个前643时钟发生器，输入数据端口， 3可编程定时器和一个信号路由单元串行端口提供：六双串口数据线，在高达50 Mbps的操作/为200兆赫的每个数据行每个人都有一个时钟，帧同步的核心秒，和两个数据可以作为任何一个接收器或发射器对左对齐和I2S样本对支持，最多可同时接收或传送24个频道，每使用两个系列的I2S兼容立体声设备配置可编程方向线；港口的TDM通信接口，包括支持128个电话接口的TDM的渠道，如H.100/H.110支持多达12个的TDM流的支持下，每帧128个频道每个压缩扩展每通道的基础上选择在TDM模式输入数据端口提供了一个额外的输入路径的DSP核心配置为I2S或串行数据或7加一个20位宽的SYN -异步的并行数据采集接口通道或8通道；支持接收通道I2S音频数据，左对齐样本对，或右对齐模式信号路由单元组件之间提供所有戴配置和灵活的连接，6个串行端口，一个输入数据端口，两个精密时钟发生器，3个定时器，10个中断，六旗投入，产出6个旗，20曼谷南南区域股的I / O管脚串行外设接口的硕士或奴隶通过SPI串行启动全双工运作主从模式多主机支持开漏输出可编程波特率，时钟极性和第三期合并调制旗/ IRQ线路1合并调制旗/定时器过期线光盘的防伪特征：JTAG的访问与64位受保护的关键允许内存内存可分配给程序访问控制的限制下对敏感地区有一个代码锁相环/分比率背景遥测的JTAG仿真功能增强的IEEE 1149.1 JTAG标准测试访问端口软件和硬件多钳各种各样和片上仿真双电压：3.3六/输出，可在1.2 V核心136球BGA封装和144引脚LQFP封装无铅封装，也可

The OSPF protocol is a dynamic routing protocol, which uses of the link state database to maintain and calculate routings. Its routing algorithm is the most important part.

OSPF协议是一种动态路由协议，它利用内部的链路状态数据库来维护和计算路由，它的路由算法是本协议的关键部分。

Control plane processing leads to the construction of what is variously called a routing table or routing information base.

控制平面处理导致建造什么是各种所谓的路由表或路由信息库证明

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失