查询词典 rotating speed

The bodily center of gravity speed changes along the changing of the swivel posture. In the three axes of X, Y, Z, the speed is pindling and has no appearance difference in the front-to-back direction and left-to-right direction, but speed in the vertical direction is the fastest.The speed of the swinging leg appears three acceleration stages obviously.

在身体转动中无论手臂的引带、跟随或摆动腿的挥摆等动作，正好体现了肢体相对身体纵轴质量分布的改变，从而达到了调整身体转动速度的目的，所以古典芭蕾舞挥鞭腿转720度难度动作是满足动量矩守恒定律的。4。

The results were as follows: ET〓-RNA expression levels in hypothalamus, hippocampus and temporoparietal grey and white matters of the low and high speed injury groups were elevated significantly than that of control group (p＜0.05), but in the above areas of brain, ET〓-RNA expression in hypothalamus and hippocampus were the highest (p＜0.01), especially in the high speed injury group; ET〓 contents in hypothalamus and hippocampus in the two injury groups, especially in the high speed injury group, increased very significantly than that of control group (p＜ 0.01); ET〓 contents in CSF and plasma in the two injury groups, also especially in high speed injury group, increased markedly after 2 hours, and lasted for 8 hours after injury; ET〓 contents in the abovt areas of brain were of highly positive correlation with that in plasma or in CSF.

实验显示：致伤犬伤后海马、丘脑下部、颞顶叶灰、白质内皮素—1RNA表达较对照组显著增强（p＜0.01，p＜0.05），其中以海马和丘脑下部最显著（p＜0.01），高速组最明显（p＜0.01）；海马和丘脑下部ET〓含量较对照组显著升高（p＜0.01）；血浆、CSF中ET〓含量在伤后2h即极显著升高（p＜0.01），并持续至伤后8h，上述各组均以高速组最为显著（p＜0.01）；各脑区和血浆，CSF中ET〓含量间呈显著正相关。

Karatsu take high-speed, and then switch to high-speed Beijing-Tianjin-Tanggu, in Yixing Bu under the high-speed, and then take the Outer Ring Road in Tianjin, more than 10 minutes after taking Tsubo high-speed, it is up!

走唐津高速，然后转京津塘高速，在宜兴埠下高速，然后走天津外环线，十多分钟后，走津保高速，就到了！

The agitation power consumptions in boiling systems decrease uniformly with the increase of agitation speed, whereas the relative power demand (RPD-the ratio of agitation power input of HEDT for gassed system to that for ungassed system and under the same agitation speed) can maintain at a high level for high gas loadings even when the impeller is operating with a high impeller tip speed. The gas hold-up in the boiling system is much lower than that in the cold gassed system, and the gas hold-up in boiling system increases at first and then decreases with the increase of the agitation power consumption per liquid mass P(subscript m. It implies that the boiling three-phase system has a maximum gas hold-up point. The changes of nucleation site of vapour bubble and the character of suspension of the solid particles with the rotational speed of the impeller are responsible for those behaviors mentioned.

在沸腾条件下，搅拌功率消耗随着搅拌转速的增加有所下降，但HEDT桨具有较高的载气能力，即使在高叶端线速度下，相对功率消耗仍能保持在较高的水平；沸腾体系的气含率随单位质量流体输入功率的增加表现出先增后减的规律，即存在气含率的极大值，蒸汽成核位置和固体颗粒悬浮特性随搅拌功率增加而改变是造成上述行为的主要原因；沸腾体系中的气含率远远低于常温通空气体系。

The results show that the vehicle acceleration, the dynamic wheel load and offload factors increase with train speed, and distribute linearly. The safety of train operation and running comfort can meet the requirements when the high-speed train under secondary suspension passing through ballasted track subgrade structure. The dynamic displacement of the system is less influenced by train speed. The dynamic stress of subgrade surface increases with speed improving, and it is distributed as saddle along the lateral direction and as parabola along the longitudinal direction of subgrade surface. The dynamic stress of subgrade declines sharply along the depth of subgrade. The dynamic stress on 3 m depth below subgrade bed surface is about 16 percent of that of subgrade surface.

结果表明：车体加速度、动轮载和轮重减载率均随车速的提高而增大，呈线性分布；具有二系悬挂的高速列车通过有砟轨道路基结构时，列车的安全性及舒适度均能满足要求；系统动位移受速度影响较小；路基面动应力随速度的提高而增大，并在横向呈马鞍形分布，在纵向呈抛物线形分布；路基动应力沿路基深度方向衰减较快，在基床表面下3 m处，动应力只有基面的16%左右。

Through setting independent monitoring and control unit of traveling, hoisting traveling and speed setting are guaranteed accurately. Through optimized control of speed, damage is reduced for hoisting rope by impact of driving current. Through continual and fixed-point monitoring and control for speed, high reliability of speed protection is realized. Through control of optimizing loading and unloading process, overwinding accident caused by wrong loading fault is prevented.

通过设立独立的行程监控单元，确保提升行程和速度给定准确无误；通过速度的优化控制，减轻驱动电流冲击对提升绳的损伤；通过连续和定点相结合的速度监控，实现速度保护的高可靠性；通过优化装卸载工艺控制，预防错误装载故障导致的过卷事故。

Based on the simulation data, the effects of clearances, damping coefficient and the rotation speed on the dynamic behaviors are studied: compared with ideal mechanisms, mechanisms with clearances are less stable; as for mechanisms with clearances, when the crank rotates at the speed of 100rad/s, the actual clearances are always above the radium of clearances, axle pin and axle cover keep contact throught the rotation; when the crank rotates at the speed of 20rad/s, mechanisms are in an unstable state, at an angle of about 300, the actual clearances are below the radium of clearances, pairs lose contact, which results in collision between them; with the speed of 20rad/s, when damping coefficient is assumed 175Ns/m, distinct separation and collision happen between pairs; when damping coefficient is assumed 220Ns/m, separation and collision are controlled.

在含间隙机构中，当曲柄以100rad/s转动时，运动副间隙始终大於半径间隙，轴销与轴套始终保持连续接触；当曲柄以低速20rad/s转动时，系统处於极不稳定的震荡状态，在转至300°左右时，运动副间隙小於半径间隙，脱离接触，发生明显的分离碰撞现象。在含间隙机构中，曲柄以低速20rad/s转动，当取法向阻尼系数为175Ns/m时，副元素发生明显的分离碰撞现象；当取法向阻尼系数为220Ns/m时控制了副元素的分离，副元素一直处於连续接触状态。

The machine from entering long States, that is, matching pressure, after the closing, when a machine speed up to 10% of the speed, the brush motor, heshui, ink, oil pump, and speed up to 20%, break detection work, epual character to at low speed, press the stop button to stop and automatically from the pressure.

机器进入长车状态，即能合压，合压后机器加速，当速度达到10%时，毛刷电机转、合水、合墨，开油泵；当速度达到20%时，断纸检测机器起作用，降速至最低速时，按停车按钮，停车并自动离压。

The machine from entering long States, that is, matching pressure, after the closing, when a machine speed up to 10% of the speed, the brush motor, heshui, ink, oil pump, and speed up to 20%, break detection work, epual character to at low speed, press the stop button to stop and automatically from the pressure.

机械出去不幼车状况，即能不合不抬，不合不抬后机械放慢，当速率到达10%时，毛刷电机不停、不合水、不合不朱，闭油泵；当速率到达20%时，断纸检测机械起功用，降速至最不高速时，按不泊车按钮，不泊车并自不静离不抬。

The Doppler frequency shift and the Doppler broadening are comprehensively utilized, the narrow-band phase plate is inserted between a collimating mirror and a focusing lens of an imaging probe, thereby implementing the spatial encoding of the Doppler information, realizing the imaging requirements on the spatial high-resolution three-dimensional speed vector, combining with the Doppler OCT method which is based on the phase resolution technology to meet the high-speed and high-sensitivity measurement requirements and finally realizing the speed vector imaging with high-resolution, high-speed, high-sensitivity and large-imaging range of the three-dimensional flow field of the microfluidic chip.

综合利用多普勒频移和多普勒展宽，并在成像探头的准直镜和聚焦透镜之间插入窄带相位片，实施多普勒信息的空间编码，实现空间高分辨三维速度矢量的成像要求，再结合基于相位分辨技术的多普勒OCT方法则能够满足高速度高灵敏度的测量要求，最终实现对微流控芯片立体流场的高分辨率、高速度、高灵敏度、大成像范围的速度矢量成像。

Summary In copyright infringement cases,if the alleged infringer uses or even plagiarizes the copyrighted works or parts thereof,which causes no substantially adverse effect on the normal exploitation of the work,nor does it inflict any substantial damages to the right owner,the de minis doctrine should be applied to exempt the liabilities of the defendant and seek the balance of interests between the right owner and the general public embodied by the copyright law.

在侵犯著作权案件中，如果被控侵权行为人虽未经著作权人的同意，使用甚至抄袭了受著作权保护的作品或作品的片段，但若情节轻微，未对该作品的正常使用产生任何实质不利的影响，亦未对权利人的权利造成实质性的损害，则应适用&不计琐细原则&，免除行为人的责任，以寻求在权利人利益与著作权法所体现的社会公共利益之间的平衡。

This new product will become our best seller.

这个新产品会成为我们最畅销的产品。