查询词典 river outlet

Bellows Gate Valves However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。

However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。因此热力膨胀阀在变工况下供液量的调节方面需进一步改进。

Before fire lift room establishment positive pressure supply-air outlet, when after fire prevention alarm system warning, opens the related spot positive pressure supply-air outlet by the fire controller control, the linkage opening positive pressure air feeder, will possess the operation signal returns fire prevention control room; When opens the gusty area by the manual operation organization, can also the linkage opening positive pressure air feeder.

在消防电梯前室设置正压送风口，当消防报警系统报警后，由消防控制器控制打开相关部位正压送风口，联动开启正压送风机，将所有动作信号返回消防控制室；当由手动操作机构打开风口时，也能联动开启正压送风机。

Before fire lift room establishment positive pressure supply-air outlet, when after fire prevention alarm system warning, opens the related spot positive pressure supply-air outlet by the fire controller control, the linkage opening positive pressure air feeder, will possess the operation signal returns fire prevention control room; When opens the gusty area by the manual operation organization, can also the linkage opening positive pressure air feeder.

在消防电梯前室设置正压送风口，当消防报警系统报警后，由消防控制器控制打开相关部位正压送风口，联动开启正压送风机，将所有动作信号返回消防控制室；当由操作机构打开风口时，也能联动开启正压送风机。

In addition, the effect of the performance improvement and the influences on the flow filed due to the installation of flow-guide plate and the vortex generators and the change of outlet position will be investigated by executing a series of numerical simulation and comparison. Also, the optimum design parameters of the flow-guide plate, the vortex generators, and the outlet position will be found respectively.

接著对此集热器之循环水套，分别进行「变更出水口位置」、「加装导流板」以及在导流板上添加「涡流产生器」等一系列的改良设计与流场模拟分析比较，以找出最佳之设计参数组合。

The simulated distribution of the volume fraction of vapor phase under different outlet pressure and the variation of the cavitation flow ratio indicate that the intensity of cavitation is varied with the outlet pressure of the jet pump when driving pressure and suction pressure are fixed.

模拟所得到的不同出口压力下的气相体积分数分布以及汽蚀流量比的变化表明：当射流泵工作压力与吸入压力固定时，射流泵出口压力越低，汽蚀流量比越小，同时流量比越接近汽蚀流量比，空化也越严重。

The experimental cross current of the time-temperature curve and the related data, drawn Outlet overload caused the fire, Outlet overload described the fire danger.

那实验的交叉时间-温度的涌流弯和相关的数据，憔悴的出口超载引起火，出口超载描述火危险。

In the gasifying oven, there are coal feeding port and fuel gas feeding port at the top and the bottom, an inclined plane which drops coal grains and accumulates them onto the bottom, and the ventilating duct with opening over the fuel gas feeding port. It has also steam feeding port at the bottom, resultant gas outlet on the side and waste gas outlet at the upper part.

它是在气化炉的上部和底部分别设有煤供给口和燃气供给口，并设有使投入的煤颗粒落下、堆积到底部上的倾斜面，以及开口端在燃气供给口的上方、在炉内朝上延伸的通风管；还在气化炉的下部和侧部分别设置蒸汽供给口和生成气体排出口，并在上部设置废气排出口。

The research results show that the steam inlet pressure and water inlet temperature are the main factors which affect the lifting-pressure performance; the steam injector have the characteristics of self-adaptive outlet pressure and constant outlet flow rate; the theoretical maximum lifting-pressure coefficient calculated could be high as 14 and the experimental value is 3.0, which could be high as 1.5 even if the water inlet temperature is high as 95℃. The noise of steam injector could be induced from 80db to 50db.

研究出该升压技术具有定流量特性、出口压力具有自适应特性，计算得出的理论极限升压能力的升压系数可达14，实验得出的最大升压能力为进口蒸汽压力的3倍，进口水温达到95℃时其升压能力还可达到1.5倍，噪音从目前的80db减少为50db。

If the outlet for straw exceed too much the star shaped discharge wheel it isadvantageous to the outlet of straw.

对放铺过程中禾秆的运动进行分析，指出了禾秆被抛出时，各种因素对它的影响。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。