查询词典 river outlet

The mathematical correlation model of heating surface area and flue outlet temperature has been established,and the best flue temperature at furnace outlet upon condition that the heating surface area is minimized has been obtained by optimization.

建立锅炉受热面积与炉膛出口温度的数学关联模型，并通过解的最优化处理得到锅炉最少受热面积下的最佳炉膛出口温度。

Drill in the floor following the standard of the outlet box when setting up the outlet box.

安装地插座时必须根据地插座的规格进行开孔。

A luminaire intended to be mounted on or over an outlet box shall be provided with supply conductors long enough to extend 150 mm (6 in) into the outlet box.

将要安装在出线盒是的灯具，应当同时配备足够长和导线，可延长至盒子内150 mm (6 in)。

A ballast intended to be mounted on a standard outlet box shall include an outlet-box cover that, if of sheet steel, shall have a thickness of not less than 0.067 inch (1.70 mm) and shall be protected against corrosion on all surfaces.

整流器需要安装在标准的出线盒上，出线盒盖子如果是钢板，厚度应不少于0.067英寸(1.70 毫米)，并保证所有的面抗腐蚀

The temperature probe of Figure 16.9.1 shall be positioned in the outlet box adjacent to the outlet box mounting tabs, as shown, by a mechanical means, to determine the temperature of the branch circuit conductors during the temperature test.

图16.9.1中的温度测试探头应当放在出线盒中靠安装插片旁，采用机械的方式，确定在作温度测试时支路导线的温度。

A high-precision liquid filter includes a liquid treating device among which the interior has a filtrating device with filter screen along the periphery set up, the lower end of its one side is the liquid inlet, and the upper end is the treated liquid outlet and the lower end is the impurity outlet, a steel plate for hoisting the filtrating device is set up in connection below the cover shell at the upper end of liquid treating device in which or on its outside a magnetizing device is further set up and on its bottom two stands are fixed.

高精度液体过滤器，包括一液体处理装置，其中内部设置有周缘设置有滤网的过滤装置，其一侧下端为液体入口，上端为处理过的液体出口，下端为杂质出口，处理装置上端盖壳下连设一用以吊设过滤装置的钢板，液体处理装置内或外侧还设置有一磁化装置，液体处理装置底部设有两支架。

The overflow pipe and the outlet pipe must be connected to the outlet of the siphon using a gasketed fitting.

溢 流管和排出管必须连接在虹吸管的出口处，通过使用一个带衬垫的装置就可以实现该操作。

In this model, the velocity was controlled below50 m /s so that it is easy that the temperature of outlet propellant exceeds 1000K. By the measure of advancing the melting point of metal panel to 3000K, the temperature of outlet propellant even could be close to the very high temperature of the metal panel. It is very active to improve the capability of the whole propulsion system.

在本文模型中，将管道内工质的流速控制在50 m /s ，热交换器的出口工质温度就能够提升至1000K以上；提高换热器高温加热段的金属平板熔点到3000K以上，完全可以将工质出口温度提升至接近金属平板的温度，这样可以大幅度提高推进系统的性能。

Is recommended.8.2 The weld bonds of changed outlet pipes of Huaneng ShanhaiShidongkou Second 8.2 The weld bonds of changed outlet pipes of Huaneng ShanhaiShidongkou SecondPower Plant high temperature reheaters which were welded with thPower Plant high temperature reheaters which were welded with th e qualified e qualifiedprocedures all meet the requirements.

焊后为改善焊接接头性能，建议采用750 ±10℃温度进行焊后热处理。750 ±10℃温度进行焊后热处理。8.2 根据所评定的焊接工艺进行焊接，华能上海石洞口第二电厂高温再热器出口段管子更8.2 根据所评定的焊接工艺进行焊接，华能上海石洞口第二电厂高温再热器出口段管子更换焊口经检查均符合要求。

When the load smaller than the first outlet pressure adjustment valve set pressure, pilot valve Poppet head off an oil chamber, oil chamber 2 is equal to the pressure on the outlet pressure, the main valve of the sliding shaft 2 inside the cavity in the oil a rigid under the action of a small spring at the lowest position, the main valve and the valve slider protruding shoulder posed by all the valve port opens, pressure reducing valve without decompression.

当负载较小，出口压力低于先阀的调定压力时，先导阀的提动头关闭，油腔1、油腔2的压力均等于出口压力，主阀的滑轴在油腔2里面的一根刚性很小的弹簧作用下处于最低位置，主阀滑轴凸肩和阀体所构成的阀口全部打开，减压阀无减压作用。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。