查询词典 rim

There are two entrances to the park; the more-developed south rim entrance is located 15 miles (24 km) east of Montrose , while the north rim entrance is located 11 miles (18 km) south of Crawford and is closed in the winter.

黑峡谷名称的由来是由于峡谷的窄与深使得一天里绝大多数时间太阳只能照到峡谷很小的一部分，所以岩石看上去总是黑黑的。

Main products of Car Decoration Department are: ABS spoiler, bodykit, roof-carrier, rim, window rim, wheel mud preventor, tyre covers.

改装部生产的产品主要有：ABS汽车定风翼、大包围、行李架、轮眉、窗饰条、PU挡泥胶、备胎罩等。

The second hole is 30mm behind the first one with its inferior rim 15mm above the extended line of the superior rim of zygoma arch.

第二部分后颞部静脉、天幕窦的应用解剖研究目的：探讨颞部外侧面引流静脉，尤其Labbé氏静脉的解剖变异。

No Ⅲ° atrioventricular conduction block happened, 9 patients developed right bundle branch block, and 2 patients showed junctional rhythm. Two patients with perimembranous extending outlet were repaired because of residual shunt(0.4cm,0.3cm) on the anterosuperior rim of defect. One patient with trivial residual shunt(0.15cm) on the posteroinferior rim of defect was found closed spontaneously six months later. Tricuspid valve was incised in 10 patients of VSD sextending outlet,8 patients vertical to the valve ring,2 patients parallel to the valve ring. Moderate tricuspid valve regurgitation was found in 1 patient, mild in 5 patients, trivial in 4 patients. No one aggravated. One patient complicated with pericardial effusion.

无Ⅲ°房室传导阻滞发生，9例发生右束支传导阻滞，2例结性心律。2例膜周偏流出道型VSD患者因前上缘残余分流分别为0.4cm和0.3cm，再次手术修补；1例后下缘残留细束样分流，直径0.15cm，随访6个月后自愈；10例膜周偏流出道型VSD患者剪开三尖瓣，8例垂直瓣环，2例平行瓣环；1例三尖瓣中度反流，随访无加重；5例轻度反流，4例轻微反流，随访均无加重；1例心包积液；1例再次进入手术室止血。

The virtual assemblage of a rim （22.5×9.00） and a tubeless radial tire （12R22.5） were created by Autodesk Inventor, and the insertion model was designed based on the virtual assemblage of the rim and tire through inplace designing, the interference checkout, the presentation views, and the engineering drawings were associatively created and the consistent data were ensured among them during designanalysisredesign cycles.

利用该软件创建22.5×9.00轮辋和12R22.5无内胎子午线轮胎虚拟装配体，基于装配体在位设计内支撑模型，并进行干涉检查、创建表达视图和工程图。

The company built up three rim producing lines newly (including one rolled wheel rim producing line), one disc producing line, one spring circle producing line, two raw material cutting-off lines, one cathodic electrocoating line and one face-painting line, The company's porducing capacity is 2.6 million suits of wheels including 2 million suits of section steel wheels and 6 hundred thousand suits of rolled wheels.

滚型车轮生产线引进了当今世界最先进的关键设备和工装（轮辋生产线由荷兰 Fontijne 公司提供、轮辐旋压机由德国 WF 公司提供、检测设备由德国 Hafner 公司提供），吸收和掌握欧洲一流车轮生产厂家（如德国的 Lemmerz 、意大利的 Gianetti 和 FAD 等）的技术和工艺。

These four aspects are: the foreworn and frature of the wheel rim , tread foreworn bedded d ecrustation, regional crush and subside and early brittle fracture of the wheel rim .

为了有效地提高行走车轮的工作寿命，使其接近或达到设计周期，笔者从车轮损坏的形式、部位即轮缘磨损断裂、踏面磨损层状脱皮和局部压碎凹陷、轮缘早期脆性断裂四个方面进行了分析，找出了之所以产生磨损和断裂的原因，并提出了延长车轮工作寿命的对策。

Because the assembly locomotive wheel which is widely used in our country may cause the digression and subversion accident because of the rim relaxation, which badly affects the safety of the railage, this article brings forward the method that adds a safety retaining ring to the rim of the assembly locomotive wheel , which can effectively prevent the serious accident such as locomotive.

针对我国机车广泛采用的组装式机车轮对，可能因轮箍弛缓造成的机车脱轨事故、颠覆，影响铁路运输安全的问题，本文提出给组装式机车轮对轮箍加装安全扣环。

We don't like the rim. The rim should be ridged.

我们不喜欢这样的盘边，盘边必须是脊状的。

The semicarbazone derivatives of propylatedcalix[4]arenes can form colloid in ethanol owing its hydrophilic upper rim andhydrophobic lower rim.

下沿丙醚化的杯[4]芳烃缩氨脲衍生物在乙醇溶剂中能形成胶体溶液，这是由分子上下沿的两亲性所决定的。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。