查询词典 reverse side

Reverse traffic can lead degradation of TCP performance. To resolve this problem, we analyze the impact of reverse traffic carefully, and obtain the relation between reverse traffic and TCP performance. We propose an approach of rate control optimized for unidirectional trip time, and design an algorithm for rate control, called Unidirectional Trip Aware Rate Control, UTARC.

针对反向数据流量会导致TCP性能下降的问题，本文详细研究了反向数据流量对正向数据流应答的影响，揭示了反向数据流量与TCP传输性能之间的联系，提出了面向单向延时优化的速率控制方法，并设计了相应的速率控制算法UTARC。

Methods to help your baby every day rubbing his neck with his hands, I take a bath at home before the baby is done, our side 25, a total of 50, the baby will be the beginning of that pain, but it does not matter, we must pay attention to the way you are not too heavy, the first baby of the side because the side of regular habits, the back side of the tendon to some soft, instead of partial reinforcement on the other side of some hardware, that is, the hard side of the bars had not opened, there was a need physical therapy.

方法每天用手帮宝宝揉脖子，我家宝宝就是在洗澡前做的，我们一边25下，共50下，刚开始宝宝会有一点痛，不过不要紧，一定要注意你的手法不要太重，宝宝头偏了，是因为经常习惯一边后，倒的那一边的筋要软一些，而不偏的那一边筋就硬一些，也就是说，硬的那一边的筋还没有打开，所以要物理治疗。

In order to provide a photo detector in which the generation of spontaneous noise is suppressed and external noise is effectively reduced, a p-type diffusion layer is provided on the obverse side of an n-type semiconductor substrate, a p-type low-resistance layer is provided on the obverse side of the p-type diffusion layer, a lead frame is provided on the reverse side of the n-type semiconductor substrate with an insulative resin film in between, and the p-type low-resistance layer is electrically connected to the lead frame.

为了提供能够抑制自发噪声的产生并有效地减少外部噪声的光检测器，在n型半导体衬底正面设置p型扩散层，在p型扩散层正面设置p型低电阻层，在n型半导体衬底的反面设置引线框架、中间夹有绝缘树脂薄膜，p型低电阻层电连接到引线框架。

After all of these six changes have been carried out on one side of the palate,the operated side becomes completely relaxed.It can be moved both posteriorly and medially to lengthen the side of the palate and to contact with the cleft margin of the non-operated side without tension.Obviously,there is no need to perform the same surgical maneuvers on the other side again.The cleft is then closed by layers.

手术时，在腭部的一侧作完改变的六项操作以后，手术侧的腭部即彻底松弛，可以充分后退，增加该侧腭部先天不足的长度，并随意向近中侧移动，与对侧的裂缘接触，不需要在对侧再作同样的手术操作，即可将裂隙缝合。

The head is slowly turned 90° toward the side where nystagmus is induced less intensely. Then the head is rotated 180° rapidly toward the opposite side. This article reports three cases of the ageotropic form of HC-BPPV that were cured by rapid head rotation. The three cases demonstrated that rapid head rotation was an effective maneuver to treat cupulolithiasis on the utricle side. It is recommended that rapid head rotation can be used for therapeutic diagnosis: If nystagmus subsides immediately after this maneuver, the diagnosis is cupulolithias is on utricle side. If nystagmus changes into the geotropic form, the diagnosis is cupulolithiasis on canal side or canalolithiasis in the anterior arm of horizontal semicircular canal. A repositioning maneuver for geotropic form can then be applied to treat these patients.

逆地眼振型水平半规管良性阵发位置性眩晕的3种耳石可能位置如下：水平半规管前臂的管耳石、管侧的顶帽沉石(canal side cupulo-lithias1s)与囊侧的顶帽沉石，本文报告3例以快速转头治疗逆地眼振型水平半规管良性阵发位置性眩晕成功的病例，显示快速转头法对囊侧的顶帽沉石具迅速有效的治疗效果，对於逆地眼振型水平半规管良性阵发位置性眩晕的治疗，作者建议先以快速转头作治疗性诊断，若病人马上复原，诊断为囊侧的顶帽沉石；若眼振转为向地型，则诊断为水平半规管前臂的管耳石或管侧的顶帽沉石，进一步再以向地型的耳石复位法治疗病人。

Based on 3D steady and incompressible N-S equation and k-ε turbulent model, the aerodynamic performance of three different design options of 160 km/h container flat wagon was analyzed and compared using finite volume method. The three design options are as follows: the first design option has no headwall and the side surface of side beam is flat; the second and the third both have headwall and high side beam, and the side surface of side beam of the second is obtuse, while the third is cambered.

基于三维、不可压、定常N-S方程和k-ε双方程湍流模型，采用有限体积法对3种不同设计方案在运行时速为160 km/h的集装箱专用平车在有、无横风情况下的气动性能进行分析与比较，其中：方案一的平车无端墙，侧梁侧面平直；方案二和三的平车均加有端墙，且侧梁加高、侧面形状分别为钝形和弧形。

Based on 3D steady and incompressible NS equation and kε turbulent model, the aerodynamic performance of three different design options of 160 km/h container flat wagon was analyzed and compared using finite volume method. The three design options are as follows: the first design option has no headwall and the side surface of side beam is flat; the second and the third both have headwall and high side beam, and the side surface of side beam of the second is obtuse, while the third is cambered.

摘 要：基于三维、不可压、定常 N S 方程和 k ε双方程湍流模型，采用有限体积法对3种不同设计方案在运行时速为160 km/h的集装箱专用平车在有、无横风情况下的气动性能进行分析与比较，其中：方案一的平车无端墙，侧梁侧面平直；方案二和三的平车均加有端墙，且侧梁加高、侧面形状分别为钝形和弧形。

A machine component comprising: an elongated base plate with side edges, a linear actuator assembly having two parts which can move away from and toward each other, first mounting means on said base plate, said mounting means supporting one part of said assembly, a slide plate rectangular in cross-section and having parallel straight side edges, two elongated guide members each having a rectangular slot adapted to slidingly receive the edge of the slide plate, each elongated guide member including a lowerpart and an upper part and means for securing them together, the lower part having means for attachment to the base plate, said rectangular slot having (1) a first side wall adjacent to and parallel with the base plate, said first side wall being definedby a surface of said lower part,(2) a second side wall defined by a surface of said upper part, and (3) a bottom wall defined by a surface of one of said upper and lower parts, the upper and lower parts having oblique mating surfaces such thatlongitudinal meovement of one part with respect to the other causes the parts to separate from or approach each other in a manner to change the width of said slot, and second mounting means establishing a connection between the slide plate and the other part of said assembly.

有一长条形底座与身边的边缘，一个线性驱动器装配有两个部分，可以离开，彼此之间，首批意味着在说底座、说安装方式支持之一说总成，一个矩形截面板、平行直边棱、两种细长的引导会员都有一个矩形槽适应slidingly收到边缘的细长板，每一个lowerpart引导会员包括一个上方和手段，确保他们在一起，下方附件的方式，在底座，说矩形槽有(1)第一次侧墙毗邻，平行底座，一边说：definedby墙表面说下方，(2)第二次侧墙表面的定义，并说上方(3)底壁由一个表面的上部和下部零件，说上部和下部阀部件表面的thatlongitudinal拥有斜meovement这样的一部分的原因部分可以分离或接近对方的方式来改变宽度的槽，第二次安装方式，建立连接板之间，另一部分说总成。

The crushed rock in the side abutment weakens the side restriction while the side wall and the apron strengthen the side restriction. The analysis showed a new stress distribution with automatic modification and less stress concentration when the side restriction is weakened by using crushed rock in the abutment.

结合某碾压混凝土拱坝的拱座，在减弱和加强侧约束时，即在坝体部分高程的破碎软弱岩石减弱坝体侧约束以及坝体下游边墙和护坦增强坝体侧约束的情况下，研究侧约束对于坝体应力和位移的影响。

A student who is or was a resident of the other side immediately before visiting one side, and who is present in the first-mentioned side solely for the purpose of his education shall be exempted from paying taxes in that first-mentioned side on the payments derived from sources outside that side for the purpose of making a living, accepting education.

学生是、或者在紧接前往一方之前曾是另一方居民，仅由于接受教育的目的，停留在该一方，对其为了维持生活、接受教育的目的收到的来源于该一方以外的款项，该一方应免予征税。

Although translator has turned from being a crystal ball by which the original culture can unrestrainedly penetrate to another crystal ball by which the target culture can freely traverse, the translator's personal embodiment, in the process of cognitive act, are still absent in translation studies. Translators are still subjects without body or simply disembodied subjects.

译者虽然由原语文化可以自由穿透的玻璃球变成了译语文化可以自由穿越的玻璃球，但译者认知过程中的个体体验在翻译研究中依然缺席，译者依然仅仅是一个没有躯体体验的主体。

Chillingly, he claimed our technology is 'not nearly as sophisticated' as theirs and "had they been hostile", he warned 'we would be been gone by now'.

令人毛骨悚然的，他声称我们的技术是'并不那么复杂，像他们一样，和"如果他们敌意"，他警告说，'我们将现在已经过去了。