查询词典 restrictor

A new infinite gas-lubiicated journal bearing with active controlled restrictor is proposed in order to remedy the defects of several existing infinite stiffness at abroad in construction, manufacture and adjusting, which combining surface-restriction with active controlled restriction, make the static and dynamic effect both better.

针对目前国外几种无穷静刚度气体润滑轴承结构复杂、制造难度大、调整困难的不足，本文提出了一种主动控制节流无穷静刚度气体润滑轴承，将表面节流与主动控制节流相结合，使轴承动、静压效果同时获得较好的发挥；利用浅腔及锯齿形多槽结构产生较强的楔形动压效应，提高轴承的静态和动态性能；利用主动控制节流器对轴承进行压力反馈主动控制，提高轴承的承载力、刚度，并在一定载荷范围内，使轴承刚度为无穷大。

It is proved that the frequency response could be much improved by using restrictor in tube system.

在管路系统中加限流器能在很大程度上改善管路系统的频率响应特性。

It mainly studys approximate engineering synthesis algorithm about effective cross section area of valve, Sa, which synthesis by geometrical cross section areas of restrictor in valve flow channel.

重点研究了由阀流道节流口几何截面积合成阀有效截面积 Sa 的近似工程合成算法。

The displacement restrictor parameter optimization of the shock isolation system is a kind of nonlinear optimization problem with the restriction.

冲击隔离系统限位器参数的优化问题是一个有约束的非线性优化问题，也是一种最困难的优化问题。

An analytical model of non-linear shock response of the equipment using shock isolator with displacement restrictor is established and the pseudo-force approach is used for the first time to solve the response.

带有限位器的浮筏隔振系统是非线性系统，该文建立了这一非线性系统的模型，利用伪力(pseudo-forces)法计算了带有限位器的浮筏隔振系统模型的冲击响应，分析了限位器参数对冲击响应的影响。

An analytical model of non-linear shock response of the equipment using shock isolator with displacement restrictor is established and the pseudo-force approach is used for the first time to solve the response.An experimental model of the equipment using shock isolator with displacement restrictor is made.

带有限位器的浮筏隔振系统是非线性系统，该文建立了这一非线性系统的模型，利用伪力(pseudo-forces)法计算了带有限位器的浮筏隔振系统模型的冲击响应，分析了限位器参数对冲击响应的影响。

Install flow restrictor aerators. Placing these inside faucets saves 3 to 4 gallons per minute when you turn on the tap.

这点很多人也可以做到：在洗脸或者刷牙的时候，不要开着水龙头让水就那么流着。。。。

The oil chamber when the spindle is not installed, all the oil out of the mouth of the oil column must be consistent, if not, should be taken to change the restrictor aperture approach, to change its flow.

各油腔在不装主轴时，各个出油口的油柱必须一致，若不一致，应采取改变节流器孔径的方法，改变其流量。

In order to solve the poor load capacity of oil film bearings during the start-up process of tandem cold rolling mills, based on the hydrostatic bearing theory, a load bearing capacity model for oil film was established. The influences of screw-down tilting, hydraulic pump power and restrictor's hydraulic resistance on the hydrostatic pressure bearing-spindle system were calculated.

针对某CVC带钢冷连轧机启动阶段支持辊油膜轴承静压承载能力不足的问题，应用流体润滑理论，建立了轴承倾斜工作下静压承载能力的全润滑系计算模型，分析了轧机压下倾斜、油泵功率和节流器液阻对轴承静压承载性能的影响。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。