查询词典 resolution ratio

The focusing beam radius' ratio between the telescope lens compound system and the single lens increases via length (70~400mm) increasing, and the maximum ratio is 30, meanwhile the ratio between the telescope-lens compound system and the single lens decreases via length (70-400 mm) shorting, but the maximum difference of the focusing beam radius' is 0.043μm.

结果表明，随着距离(70~400mm)的增加，两者的聚焦效果相差增大，最大为30倍；随着距离(70~400mm)的减小，两者的聚焦效果相差减小；经望远镜和薄聚焦透镜组合系统聚焦的高斯光束束腰处光斑半径随距离(70~400mm)变化的最大值为0.043μm。

The effects of the aspect ratio, the swept-back, the taper ratio and the area ratio of the rudder itself to the whole assembly on the hydrodynamic coefficients are also studied.

文中用数值试验方法探讨了舵展弦比、后掠角、梢根比及舵与组合体的面积比等因素对舵流体动力系数的影响。

Moreover, with the assistance of grey series forecasting model and the rule of the annual precipitation, the annual average precipitation, groundwater flow field, groundwater level and spring flow in the future under current exploitation circumstances were forecasted. If 2010 is a high flow year (guarantee ratio 20%), or median flow year (guarantee ratio 50%), or even low flow year (guarantee ratio 75%), the underground water level of Heilongdong spring in flood season will exceed 130 m, or reach 130 m, or even below 130 m, and the spring flow in flood season will exceed 10 m^3/s, 7 m^3/s, 5 m^3/s respectively.

以灰色序列预测模型为辅助手段，结合历年的降水规律，对未来现状开采条件下的年均降水量、地下水流场、水位及泉流量进行了不同保证率条件下的预测，若2010年为丰水年（保证率20%）、平水年（保证率50%）、枯水年（保证率75%，黑龙洞泉汛期地下水位标高分别为超过130m、达到130m、低于130m，汛期泉流量分别为超过10立方公尺/s、7立方公尺/s、5立方公尺/s。

The results show that the most remarkable factor is the slenderness ratio, the axial compression ratio takes second place and the steel ratio is third.

结果表明，对其影响最大的为长细比，其次是轴压比，再次是含钢率。

Influences of several parameters, such as axial compression ratio, slenderness ratio, steel ratio and strength of the materials on the hysteresis behavior of the beam-columns are analyzed.

基于理论分析模型，分析了各参数，如构件轴压比、长细比、截面含钢率和材料强度等因素对圆钢管混凝土压弯构件P-△滞回关系曲线的影响。

The experiment and the research indicate that:(1) Through the Hot-Continuous-Rolling production technics under small reduction ratio of 4.04 and 5.08, the rectangular continuous-casting billet of 235×265mm can be used to produce big size steel stick of Φ140mm and Φ 125mm whose macrostructure and mechanical properties meet the standards, this technics is viable;(2) This rolling technics can make the deformation penetrate to the center of the billet by low temperture and low velocity and big roller diameter and large reduction quantity at every pass and optimum design and arrangement of rollers, which is the key of Hot-Continuous-Rolling technics under small reduction ratio;(3) The sending technics used in Xining Special Steel Co.,Ltd can not use waste-heat of billet adequately, but the sensitive temperature section of A1N or sulphides or inclusions separating out is avoided, creating a favorablecondition for insuring good surface quality of final rolled steel;(4) The Hot-Continuous-Rolling technics under small reduction ratio has a close relationship with the billet quality control and the hot sending process control and the cooling control after rolling.

通过实验研究表明：(1) 235×265mm矩形连铸坯分别采用4.04和5.08的小压缩比热连轧生产工艺，所生产的Φ140mm和Φ125mm的大规格棒材，其低倍组织和机械性能均符合标准要求，该工艺是可行的；(2)本实验所采取的低温低速、大辊径大道次压下量轧制工艺加上轧辊孔型的优化设计与配置，可以使加工变形渗透到铸坯的中心，这一点是实现小压缩比热连轧生产工艺的关键；(3)西宁特钢在红送过程中虽然铸坯余热未能得到充分的利用，但是有效地避开了A1N、硫化物的析出及夹杂物偏析的敏感温度区，为保证最终轧材良好的表面质量创造了有利的条件；(4)小压缩比热连轧生产与铸坯质量控制，热送过程控制以及轧后冷却控制密不可分。

Under spraying humidification state, the parameters of JYPW-1 spraying axial fans for textile enterprises such as flow, total pressure, efficiency, shaft power and acoustic power level changing with water-air ratio were tested, and the performance parameter curve changing with water-air ratio was obtained. The approximate formula of its pneumatic performance in different water-air ratio condition were deduced which can be referenced for of selection and project application.

在喷雾加湿工况下，对纺织空调系统所用的JYPW-1型喷雾轴流通风机的流量、全压、全压效率、轴功率和比A声级噪声等性能参数随喷淋水气比的变化进行了测试，得到了喷雾风机性能参数随水气比变化的曲线，并整理出喷雾风机在不同水气比时，其气动性能的近似计算公式，可供喷雾风机选型和工程应用时参考。

Result 2TYB-450 rice seedling seeder adopted the synchronous driving wheel, the equipment for vibrating and homogeneous sowing and the guiding sowing plate with seed box cross, so it didn't slip when driving and had high eligible ratio of sowing, good effect of filling seeds, less sowing seed number per seedling area and high working stability, with the sowing eligible ratio of 68.67%, the sowing blank-hole ratio of 1.89% and the sowing seed number per seedling area of 4.19. The working performance of 2FBS-840 seeder was next and that of MR-BZ840A seeder was worst.

结果］2TYB-450型播种机采用同步驱动轮、振动匀种装置、种箱交叉导种板，驱动不滑移，播种合格率高，充种效果好，每取秧面积播种粒数少，工作稳定性高，其播种合格率为68.67%，空格率为1.89%，每取秧面积播种粒数4.19；2FBS-840型播种机的作业性能次之，MR-BZ840A型播种机的最差。

Experimental results show that: bearing capacity of JPP is thirty percent higher than that of cast-in-place pile which has the same length and diameter with JPP. The deformation of JPP is controlled by core pile; axial force distribution of PHC is different with soil-cement; and their axial force ratio in same section is their elastic modulus ratio. Distribution of inner and outer friction resistance is similar; and the inner friction is about 1.62 times of the outer one; it is about the ratio of JPP diameter and PHC diameter. Furthermore, the relation between friction resistance and relative displacement is similarly hyperbolic; and the relation between dip resistance and displacement is also hyperbolic.

试验结果表明，JPP桩与同桩长、同桩经灌注桩相比承载力高30%以上；JPP桩变形由芯桩控制，管桩轴力分布与水泥土轴力分布规律不一致，但同一截面上管桩和水泥土的轴力比值约为其弹性模量的比值；内外摩阻沿桩身的分布规律类似，内摩阻是外摩阻的1.62倍左右，约为JPP桩直径和管桩直径的比值；桩侧摩阻力与桩土相对位移近似双曲线分布，桩端阻力和桩端位移也近似双曲线分布。

Results 59 cases were cuerd in the treated group'the ratio of curative was 88.06%'effective 6 cases'the ratio of effective was 8.95%'ineffetive 2 cases.The average time in hospital was 19 days'the raio of rel asp e was 9.25%'during one year.25 cases were cured in the control group'the ratio of curative was 58.14%.12 cases were effective'the rateio of effective was 27.90%'6 cases was ineffective'the average treatment time was 31 days.

结果 治疗组治愈59眼'治愈率为88.06%，有效6眼，有效率8.96%，无效2眼，治疗天数平均19天，随访1年54眼中复发5眼，复发率9.26%；对照组治愈25眼，治愈率58.14%，有效12眼，有效率27.91%，无效6眼，治疗平均天数31天，随访1年23眼复发7眼，复发率30.43%；两者比较治疗组疗程和疗效均优于对照组（P.01）治愈患者随访1年，治疗组复发率比对照组明显低。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"